Question about Toyota HiAce

Open Question

How to replace power steering hose on a toyota hiace

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Hiace Toyota

Near the foot-step on the front passenger door (open the door first!)

Posted on Mar 18, 2009

  • 3600 Answers

SOURCE: replacing power steering hoses

adirondacktr on is correct, you can find replacements or get them made at any auto parts store, or a Hydrolic shop that makes hoses, But if it's a 2008 it would be a warrenty fix. If you let it go you can damage the pump and the hydrolic assist sytem costing a lot of money and voiding any warrenty you would have if you do not have it replaced you can also get a subscription to alldatadiy.com to see if there is a recall on the hoses or any other they may have found. Don't let it leak to the point you damage the pump.

Posted on Jul 07, 2009

badnad
  • 1 Answer

SOURCE: How do you disassemble toyota hiace 2006 dash?

Its easy, The only tool you need is a plastic lever tool. Or can be done with big head screw driver (but car for the trims for it can get damaged)
Lever both side vents out, then pull on the trim gently outwards. (long piece from glove box to the end of the radio before the instrumental dash panel) Then pull the main inturmental dash out towards you as well. There may by plugs connected to the front panel. Disconnect that and it exposes the digital meter, I think it then takes only 2 x 10m bolts and the dash is out.

Posted on Dec 06, 2009

  • 115 Answers

SOURCE: high presure power steering hose is leaking

Hi, they do make a universal high pressure hose for your vehicle. You have to purchase the hose and the fittings seperately. It is made by Russell. The fitting choices are straight hose end, 45 degree hose end and 90 degree hose end. I found these parts at partswarehouse.com . The two fittings and hose will cost about $175 to $200. They ship to you for free. I hope this was helpful.

Posted on Mar 16, 2010

SOURCE: Hello, i need to replace a high pressure power steering hos

The high pressure hose is simple to replace if its not to confined of an area for you. Just un-thread from both sides, fill with power steering fluid, work steering wheel from side to side to work the air out. In between this check fluid levels. If air is still in it will make a whining sound, and bubbles will be visible in the power steering fluid reservoir. Hope I helped you good luck!!

Posted on Jul 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is it possible to fit power steering to 1985 toyota hiace campervan


If it came with power steering on another trim level then yes you can fit it

Oct 01, 2012 | Toyota HiAce Cars & Trucks

1 Answer

I replaced my power steering pump in my 1994 toyota pick up and the power steering still won't work? What else could be wrong?


If you are saying the steering is difficult to turn you could have a blocked hose or a problem in the gearbox.
Or something in the front suspension such as a faulty ball joint.

Jul 15, 2012 | Toyota Pickup Cars & Trucks

1 Answer

Hi I have a Toyota Hiace 2006 model and can't seem


The rear washer and the front share the same water bottle in the front, if the rear only is not working the hose to the rear may be disconnected or the motor for the rear washers is bad, there are two motors on the bottle one for front one for the rear, make sure both are working.

Feb 23, 2012 | 2007 Toyota Hi-Ace 220

1 Answer

Billiebarrytoyqta hiace 2001 whistiing noise when taking off


Sounds like you have a vacuum leak. Visually inspect engine compartment for any disconnected small hoses. Likely in or around air intake. Look also near brake master cylinder, power brake booster also has vac hose to it.

Feb 26, 2011 | 2001 Toyota Highlander

1 Answer

Hello, i need to replace a high pressure power steering hos


The high pressure hose is simple to replace if its not to confined of an area for you. Just un-thread from both sides, fill with power steering fluid, work steering wheel from side to side to work the air out. In between this check fluid levels. If air is still in it will make a whining sound, and bubbles will be visible in the power steering fluid reservoir. Hope I helped you good luck!!

Jul 11, 2010 | Toyota Land Cruiser Cars & Trucks

1 Answer

Can a non powered steering 87 toyota p/u be changed to power stee


It can be done, but you would need to replace the rack and pinion, obtain the power steering hoses, the power steering pump, bracket and belt, from the same year, same motor pick up.

Mar 09, 2010 | 1987 Toyota Pickup

2 Answers

I have a 1997 toyota camry that was reported to have a power steering hose leak at 125,000 K and when I took it to another mechanic at 127,000 K he told me that I need a new power steering pump and power...


POWER STEERING PUMP OR HOSE HAS NO SET TIME OR MILEAGE TO FAIL WHEN THEY WEAR OUT THEY WILL FAIL ANY TIME.I WOULD HAVE POWER STEERING HOSE REPLACE FIRST.IF YOUR STEERING WAS NORMALWORKING GOOD BEFORE HOSE RUPTURE NO NOISES OR HARD STEERING.REPLACE POWER STEERING HOSE.BECAUSE POWER STEERING PUMP AND RACK PINION UNIT GOING TO COST RIGHT MUCH.ALSO BY IT BEING A IMPORT.

Feb 15, 2010 | 1997 Toyota Camry

1 Answer

Replacing power steering hose and rack and pinion steering


when it comes to the power steering hose I would say just do it yourself. As for the rack and pinion it will probably cost you quite a few hours of labor. anywhere from 5-9. Its up to you!

Oct 19, 2009 | 1994 Toyota Corolla

1 Answer

Power steering hose, leaking. How to replace power steering hose.


You will have a leak from the pump, pressure hoses or the rack. You will have to get the system washed down and inspected for the leak, most common problem is the steering rack leaking, this will leak oil onto the exhaust and cause your smoking problem, start her.


Remove the power steering pump pulley.
Place a drain pan under the vehicle. Important: Cap or plug the ends of the power steering hoses to prevent fluid loss.
Disconnect the power brake booster inlet hose from the power brake booster.

248015_2_34.gif

Disconnect the power steering cooler hose from the power steering pump.

248015_3_27.gif

Disconnect the power steering pump remote reservoir hose from the power steering pump.

248015_4_19.gif

Raise and support the vehicle. Refer to Vehicle Lifting.
Remove the power steering pump rear mounting bracket nut.
Lower the vehicle.
Loosen the accessory bracket bolts and nut. Pull the accessory bracket forward.
Remove the power steering pump mounting bolts.
Remove the power steering pump and the power brake booster inlet hose from the vehicle.
Remove the power brake booster inlet hose from the power steering pump.







Jul 23, 2009 | 1994 Toyota Corolla

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...