Question about Ford Expedition

1 Answer

Oil light on dash of bf falcon wont go off

Changed oil and filter,changed oil pressure switch but light still on and annoying beebing sound still every few seconds

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Ford Master
  • 451 Answers

Need more info. Whats a bf falcon for starters?

Posted on Apr 23, 2015

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 57 Answers

SOURCE: Audi 80 oil pressure light

i think from memory that the oil pressure switch is at the back of the cylinder head, if its not there it will be located just above the oil filter, these switches are very cheep to buy and can be bought from any good motor factors. You are right to suspect the switch, its the first thing to eliminate before bogging your self down with more complicated and expensive problems.

Posted on May 14, 2008

  • 153 Answers

SOURCE: ford focus turbo diesel low oil pressure with no knocks from engine

Possible oil sending unit problem.

Posted on Oct 24, 2008

  • 64 Answers

SOURCE: changed oil pressure switch,still no oil pressure

The fuel pump on that model runs through the oil pressure switch so that if the truck looses oil pressure,It kills power to the fuel pump to prevent engine need to find the cause of the low oil pressure reading(possibly a bad oil switch).That would be the cheapest place to start,or have it checked with a mechanical gauge.Good luck,

Posted on Mar 30, 2009

  • 137 Answers

SOURCE: I have a 2006 fiat doblo 1.3 diesel and the oil

you have a faulty oil pump

Posted on Jul 07, 2009

  • 2299 Answers

SOURCE: 04 ford freestar has p0193

I will start by saying that the battery will need to be replaced. A battery should not go dead for at least 20 minutes with every thing on. There is a 100 amp fuse that will blow if there is something drawing enough current to kill the battery in seconds. Even minutes. So that tells me that the battery is going to leave you stranded even after you get the stalling problem fixed.
P0193= Fuel rail pressure sensor circuit high input.
P0174= Too Lean on Bank 2
P0174 too lean could be a number of things. It could be that the air filter needs to be replaced. The Mass Air Flow sensor is bad. It could be a vacuum leak from a vacuum line or the intake leaking. It could be a bad O2 sensor. If it is a vacuum leak, the best fastest way to find it is to spray starting fluid around the intake and vacuum lines while the engine is running and if it revs up, that is where the vacuum leak is.
As far as the P0193 that is more than likely the fuel pressure regulator or sending unit. But with the van stalling, I would say it is the fuel pressure regulatro.

Posted on Jan 05, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I need a work shop manual for 2007 ford ute bf series lol xr8 where can I get one how much and postage

Where is the oil filter on a BF falcon? - > Forums > Fordmods Tech > 6 Cylinder Workshop

Apr 16, 2012 - 15 posts - ‎9 authors
will i need to jack the front end up to get to it? ... Autobarn, Repco and Bursons should sell a BF workshop manual if you don't already have one

Mar 22, 2017 | Ford Cars & Trucks

1 Answer

Where is oil sending unit located?

You're vehicle has two sensors for the oil,an oil pressure sensor switch & oil pressure sensor.If oil pressure gets below 6psi,the oil pressure sensor switch will turn a dash light on to let you know the pressure is at a dangerously low amount.So if you've got a dash light on,the pressure sensor switch needs to be replaced.Its located to the right of the oil filter housing,on a 2.0 liter.Its located to the left of the oil filter housing,on the 3.0 liter.
If your oil pressure gauge is reading inaccurately,you need to replace the oil pressure sensor instead.Its located near the ac compressor.

Oct 15, 2015 | 2003 Ford Escape

1 Answer

Wiring diagram 2.4 to oil pressure switch

Need to know the year,I have a 85 nissan 720 truck,our's have 2 types of oil pressure switches,one for the gauge on dash,the other is for the light on dash,the first one cost more,the kind I have,it's located by the oil filter,when you remove the oil filter to change,it's possible that you may have remove the wires,happens to me,lol.There are 2 wires connected to it.To remove the switch,you will need to remove the oil filter,here's a cool nissan part site,enter your vin number their and it will give your vehicle and you can find your parts,I do. NISSAN PARTS

Jul 19, 2014 | Nissan Frontier Cars & Trucks

1 Answer

Bf falcon ute 2006

i had an old ford capri that did this in the end it was a dodgey starting motor i changed this and it was fine take it to a auto center and get the battery checked any way but it sound like a starter to me

Feb 13, 2014 | Ford Cars & Trucks

1 Answer


dirty oil pressure sensor.before an oil change you should use an engine flush first.

Dec 18, 2013 | 2000 Volkswagen Beetle

1 Answer

My oil light in the dash board is on on my 2007 pontiac g6 v6 the one with the oil can dripping so i got my oil changed and its still on what should i do?

that is the light to let you know there is no oil pressure (in theory). If the engine is not making any unusual noises than its probably just a bad oil pressure switch. The switch it typically located near the oil filter. usually a 1 1/16 oil pressure socket is needed to remove and replace the switch.

Feb 03, 2012 | Cars & Trucks

1 Answer

On the dash there is a light on. It is a oil pan with a wrench. What does this mean?

it is an oil warning of some kind. could be low oil,or it could just be due for an oil and filter change, or it could mean there is a blocked oil filter. or low oil pressure, or a faulty oil pressure switch

best solution is just to change the oil and filter, especially if you have not done this in a while (or at all) if the light stays on, you may need to change the pressure switch (remove wire, unscrew old switch, screw in new switch, replace wire) or find out about having the service light reset if it is on as part of a routine maintenance schedule.

Feb 23, 2011 | 2003 Saturn L-Series

1 Answer

Oil warning light on a brava car wont go off

Best would be is to measure the oil pressure out put.
Sometimes the oil filter could be the culprit.
Was the oil warning light staying 'on; prior to the oil and filter change?..If not thn the first thing to check is to replace the oil filter ..its better to install the 'original' one .
Hope this helps!

Oct 24, 2009 | 2006 Fiat Strada

5 Answers

Audi 80 oil pressure light

i think from memory that the oil pressure switch is at the back of the cylinder head, if its not there it will be located just above the oil filter, these switches are very cheep to buy and can be bought from any good motor factors. You are right to suspect the switch, its the first thing to eliminate before bogging your self down with more complicated and expensive problems.

May 14, 2008 | 1989 Audi 80

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

294 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers


Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides