Question about 2003 Ford Expedition

Open Question

Where can I buy an extra VTP chip for my for E150 2003 Econoline. I had 2 and lost one. These are the chips that you pull out so the van cannot be started. Thanks,

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 7 Answers

SOURCE: 1990 econoline van E150 won't start

SOUNDS LIKE THE IGNITION MODULE HAS GONE OUT BY THE WAY THESE THINGS ARE NOTORIUS FOR FAILING THE FAILURE RATE IS AROUND 75% ANY WAY REPLACE IT AND THEN THE SPARP WILL RETURN.. IN MOST CASES ..HEY ITS A START ASK FOR A THICK FILM MODULE AT ANY LOCAL PARTS STORE IT IS LOCATED ON THE DISTRIBUTER GRAY,, TWO 6MM SCREWS AND A 6OR8 WIRE PLUG ..HOPE THIS IS HELPFUL

Posted on Oct 01, 2008

samson-1
  • 153 Answers

SOURCE: freeze plugs ford econoline 150

The freeze plugs can be fixed with the engine in the veicle. There are some rubber plugs available that have a bolt thru the middle. Pry out failed plug, push in rubber replacement, tighten bolt to expand rubber. Fixed.

Posted on Oct 25, 2008

alicantecoli
  • 22095 Answers

SOURCE: pulling fuel tank to replace fuel pump

look on the floor for an inspection cover over the fuel sender unit

Posted on Nov 17, 2008

  • 2 Answers

SOURCE: 1995 ford econoline van speedo/trans

It is either the speed sensor, the wireing in between ot the speedometer module it self. The sensor sends pulse train signal to the speedometer module and there it drives the speedometer and is divided in frequency by about 7 and feed to the computer and the cruise control. When the signal drops the Engine management computer thinks the speed is real slow and raises the transmission pressure.

In the one I had it was a cold solder jooint on the bacjk of the speedometer module itself but this was the divided output and the speedometer itself still worked. The easyest part would be the sensor that mounts on the rear axile I believe and should cost less than 30.00 dollars. If not that thebn it's the wiring or the speedometer module electronics..


Posted on Mar 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuel pump located on a 1990 ford econoline van


Inside the gas tank. you have to unbolt the two straps holding your tank in place, remove all hoses and wires. pull the tank out from under the van, unbolt the sending unit (normally by blots, or lockring) and pull entire sending unit out. the pump is attached to the sending unit.

Nov 11, 2013 | 1990 Ford Econoline

1 Answer

93 Maxda Protege 5-speed problem


If it is only a 5th gear problem then it is at the rear end of the box and can be associated with a failed rear bearing on the cluster shaft or a chipped tooth on one of the 2 gears involved. This is a larger gear driving a smaller gear and is subject to extra load . This problem was fairly common in the easi-loader vans when the capacity of the van was exceeded (overloaded) and driven considerable distances. The gears them selves in most cases were wearing out. Check the drain plug magnet for metal bits.

Jul 20, 2013 | Mazda Protege Cars & Trucks

1 Answer

What type of power steering fluid should i buy? 1987 ford econoline van.


Hi, Go to a auto parts store and tell them the year and model of your van. They will give you the right stuff to buy. Good luck

Aug 02, 2011 | 1987 Ford Econoline

1 Answer

When you start the van it is turn off immediately


It could be a second key that does not have a chip installed in the key. I have an extra key just to get into the van. This key will fit in the ignition and start the engine, but it will shut off immediately.

Jan 31, 2011 | 2004 Dodge Grand Caravan

1 Answer

How do you release the tension on the belt of a 1991 ford 1 ton van so I can remove the alternator


you have to find your tensioner use a socket and ratchet , I have a breaker bar for extra torque and pull back on it , the belt will loosen and come right off

Aug 16, 2010 | 1991 Ford Econoline

1 Answer

Just purchased the 2001 acura cl 3.2 and i need extra keys. would like pricing on main key with computer chip


When I lost my keys/got it stolen and I called the dealership the key itself is like $25.00 but then the keyless entry (because it contains a chip) costs $103.00.

Jul 12, 2009 | 2001 Acura 3.2CL

1 Answer

Surging at 70 mph w/wo cruise control on


these vans are bad for plugging up at the gas tank pull gas tank n take apart the plastic part connected to the tubes theres 2 filters there that need cleaning due to the coatting ford uses inthe gas tank comming apart n plugging them

Jun 04, 2009 | 2008 Ford Econoline Cargo

1 Answer

How do I change out number 1 and 2 sparkplugs 1990 econoline van


try going through the front wheel wells behind front tires.

Feb 19, 2009 | 1990 Ford Econoline

Not finding what you are looking for?
2003 Ford Expedition Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5467 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...