- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I'd call a GMC dealer and ask for the parts department. I'd ask about the availability and price of the driver's mirror turn signal bulb. That might tell you if that bulb is replaceable. You could also ask that same delaership's service department about the labor cost to replace the bulb. If the plastic cover below the mirror will not snap off, you would probably have to remove the mirror from the door and take it apart to replace the bulb. Depending on the friendliness of the GMC service or parts department , they might tell you what to do here.
The following is from 2002 Honda Odyssey factory manual page 20-70: Driver's switch panel removal. (This is the switch panel to the left of the steering wheel with TCS, cruise control, mirror, and sliding door switches.) Gently pull on the driver's switch panel bottom right corner to release the (2) right side clips, then detach the remaining (2) clips on the left side and the single top center clip. If equipped, disconnect the cruise control main switch connector, TCS switch connector, power mirror switch connector, and power sliding door connector, then remove the panel. Once the panel is removed, you can push out the switch from the rear. The switch has two bulbs in it, one is the cruise switch backlight bulb and the other is the cruise control function bulb.
On the inside trim, you can remove screws that are by the door handle,
arm rest, under door and side of door and then gently pull back on the
panel as there will also be retaining clips attached and you don't want
to break them. You'll need to lift the door panel upwards in order to
get it off the window ledge. Then you'll need to manipulate the panel
and disconnect the door handle linkage from the door handle and
disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door
There is a panel on the inside of the door where the mirror is.
That has to come off.
In some cases the door panel has to come off also.
Under the mirror panel there are nuts that hold the mirror on. Remove the nuts unplug the harness and install the new one.