Question about 2004 Dodge Ram 1500

1 Answer

Heater blower only highspeed - 2004 Dodge Ram 1500

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 11 Answers

Bad resistor

Posted on Jan 16, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2002 GMC Savana Cargo van with a a/c and heater blower that will not work. The problem started when I lost the low speed, then the medium, and finally the highspeed. Fuses and relays are ok.


You checked the fuse and relay, did you check to see if you had power at the resistor ?
American built vehicles control fan speed by the power circuit which goes thru the resistor. The high speed usually bypasses the resistor.
You may need a new blower motor or control switch.

Jul 20, 2012 | 2000 GMC Savana

1 Answer

Heater blower motor.,Highspeed only works..problem??


9 out of 10 times its the heater fan resistor doing this. it has wires that corresponed to diffreent speed settings for heater fan. the resistor is beside the blower motor, Your Kia Sportage Blower Motor Resistor controls the heating equipment in the vehicle by opening and closing the fan motor. The Kia Sportage Blower Motor Resistor allows the heating and climate control system to control the speed of the vehicle's cooling fan. its under the passenger side glove box. undo 2 screws and disconnect the electrical connector. thats it!!

Jan 24, 2012 | 2000 Kia Sportage

1 Answer

1992 323 mazda want blow heat out


REPLACE THERMOSTAT.IF ALREADY DONE.CHECK HEATER BLOWER MOTOR SEE IF POWER GOING TO HEATER BLOWER MOTOR.IF YES BLOWER MOTOR BAD.IF NO POWER GOING TO BLOWER MOTOR CHECK AC AND HEATER CONTROL FUSE AND CHECK BLOWER MOTOR FUSE AND RELAY IF ALL IS GOOD CHECK SEE IF POWER GOING TO AC AND HEATER CONTROL SWITCH IF YES THE AC AND HEATER CONTROL SWITCH COULD BE BAD.

Nov 10, 2011 | 1991 Mazda 323

2 Answers

Cannot get the heater to work


CHECK SEE IF HEATER BLOWER MOTOR WORKING, REMOVE HEATER BLOWER MOTOR HOT WIRE HEATER BLOWER MOTOR SEE IF BLOWER MOTOR WORKING BLOWER MOTOR FAULTY OR YOU HAVE FAULTY WIRING AT BLOWER MOTOR AND RESISTOR.

Nov 05, 2011 | 1996 Mercury Grand Marquis

1 Answer

The battery light on my 1994 Buick Park Avenue comes on then goes out. Sometimes I pull over and restart the car and it stays out. What can cause this? Thank you for your advice


That model of car has alot of electrical systems that can cause heavy load on the system. Blower motor on highspeed, headlamps, power windows ,ect.... instead of turning engine off ,try to eliminate the load and see if that helps. I would suspect a weak ,or too small of a battery ,or the altenator
is not working at full capacity

Feb 25, 2011 | 1994 Buick Park Avenue

1 Answer

How to replace a blower motor in a 1996 ford thunderbird lx


Removal
  1. Remove the glove compartment liner to gain access to the heater blower motor and blower motor wheel assembly mounting screws.
  1. Use a small screwdriver to remove clip retaining hydraulic damper strut.
  1. Remove four screws and remove the heater blower motor assembly and blower motor wheel assembly from the heater blower motor housing.
Installation
  1. Using a new seal, position the heater blower motor and blower motor wheel assembly to the heater blower motor housing with the flat side of the flange near the heater blower motor switch resistor (18591). Install the four retaining screws.
  1. Tape the heater blower motor power lead to the air inlet duct to keep the wire away from the blower outlet during installation.
  1. Install the heater blower motor and blower motor wheel assembly in the vehicle.
  1. Install the glove compartment liner.

Oct 07, 2010 | 1996 Ford Thunderbird LX

1 Answer

I have three problems- I bought this car used. I was told that the blower motor for the ac/heater may be out. It definitely is. I discovered that it could either be a resistor or the blower motor itself....


Check the fuse or the circuit breaker.?Remove wires at the blower motor.One will be the ground wire,black,in color?? the other will be the hot.If there is only one then the motor is grounded by its mounting. Check wiring diagram.for colors or use an inline fuse 20 amps. in the power test lead Run a ground wire to the other. A premade set of test leads are very helpful.This will test the motor.The fuse may blow if the leads are reversed or the motor is shorted,or draws too much current.If motor tests ok,repair the open.Test the switch and the high speed relay,then the resistor packl All with finction of the blower switch.No slow speeds,bad resistor pack or switch,check resistor(visually),no high speed with switch?Bad highspeed relay. A wiring diagram will be of help,in checking points in the circuit where the color code is used.Without a diagram is a guessing game and takes more time.

Sep 13, 2010 | 1991 Toyota Camry

3 Answers

Everytime i turn my heater on heater on works and blows fuse?


fuse blows. unplug heater blower motor turn ignition on, turn heater on, does fuse blow? if not need to replace heater blower motor

Feb 10, 2010 | 1995 GMC Jimmy

1 Answer

I have a 2000 ford E350 van with front and rear air. the front blower motor runs at low speed, The front blower still runs on low even when the knob is set on medium or high. I do not know where the...


it's either the blower motor switch or blower motor resister. Resistor ?Heater Blower Motor Switch Removal Remove the battery (10655) ; refer to Section 414-01 . Remove the battery tray. Remove the screws. Remove the battery tray. Disconnect the heater blower motor switch resistor connector. Remove the heater blower motor switch resistor (18591). Remove the two screws. Remove the heater blower motor switch resistor. ----------------------------------- Switches Removal Disconnect the battery ground cable. Remove the center trim panel; refer to Section 501-12 . Remove the control assembly. Remove the screws. Remove the control assembly. Remove the A/C-heater function selector switch knob. Disconnect the vacuum harness connector. Disconnect the A/C-heater function selector switch connector. Remove the A/C-heater function selector switch. Remove the screw. Remove the A/C-heater function selector switch. Remove the temperature control switch knob. Disconnect the temperature control switch connector. Remove the temperature control switch. Remove the screw. Remove the temperature control switch. Remove the heater blower motor switch knob. Disconnect the heater blower motor switch connector. Remove the heater blower motor switch (18578). Remove the screw. Remove the heater blower motor switch. ----------------------------

Mar 31, 2009 | 2007 Ford E-350 Super Duty Length XLT

1 Answer

1994 chevrolet astro van


replace the blower motor resistor
rate my solution &vote

Dec 12, 2008 | 1994 Chevrolet Astro

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8265 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...