Question about 2004 Chevrolet Impala

1 Answer

I own a 2004 chevy Impala and my driver side window will not respond. I replaced the control panel and the RAP fuse and I still cannot get the window to respond

The lights for the display buttons on the control panels (all 4 doors) are not showing any power. No lighting on the window buttons only.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 11 Answers

Bad motor

Posted on Jan 16, 2013

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 10 Answers

SOURCE: 2006 Chevy Impala drivers side

here is a picture of the door panel components:acceptwha619.gif
those numbered 2 and 4 are screws 7 and 8 are plastic fasteners that should just pull out the door frame with an a little force outward on the plastic door panel.

Posted on May 03, 2011

  • 206 Answers

SOURCE: 2005 chevy impala rear driver power window stopped going up.stuck

If neither switch works it is a bad connection at the motor or bad ground or a bad motor. Remove the door panel unplug the motor push the switch and see if there is 12volts on the wires if there is the motor is bad There are small brushes in the motor that go bad tap on the motor while pushing the switch if it works that way replace it

Posted on Mar 29, 2009

Charlie1221
  • 61 Answers

SOURCE: power door locks and windows not working from the drivers side

Check the fuses first. If that dont work take the door apart the wiers have problably lost the connection due to kids and chocolate.
Gotta love them tho.

Posted on Jan 27, 2009

  • 270 Answers

SOURCE: i have a 2006 chevy trail blazer, the drivers side

Problems WithChevy TrailBlazers
ElectricalProblems
Some of the mostcommon problems with the TrailBlazer involve the vehicle's electrical systemand accessories. Many drivers have experienced problems with the dashboardgauges, including the fuel gauge, speedometer and "check engine"warning light. Additional electrical problems include power automatic doorlocks and windows that fail to work or operate intermittently. These problemscan be difficult to diagnose as they can result from anything from a faultybattery to problems with the wiring or other electrical components.
Read more: Problems With Chevy TrailBlazers ' eHow.com
A fuse contains a thin metal bridge between two terminals. When too muchelectrical current is drawn through the fuse the bridge melts, breaking thecircuit. This feature prevents damage to electrical components and limits thepossibility of a fire.The Chevrolet Blazer utilizes small fuses to protect thevehicle's wiring harness from overload. These are typically plug-in blades, notthe glass-barrel fuses used in older vehicles.
Location The fuse panel ona Chevy Blazer is located on the driver's side of the firewall beneath thedashboard. Some later models may be equipped with a fuse panel cover. To removethe cover, pull the retaining clips loose on each side and lift the cover fromthe panel. Replacing a Fuse Locatethe fuse you believe is burned out by its label or use the owner's manual as aguide. To remove the fuse, you may need needle-nose pliers; don't put too muchpressure on the fuse or you could crack the casing. Examine the thin metalstrip between the two terminals. If it is broken, scorched or deformed, it mustbe replaced. Read more: Fuse Box Instructions for a Chevy Blazer ' eHow.com

Posted on Nov 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 chevy impala radio & dash lights stay on now when ahut car off, key out and close and lock doors automatically. Never happened before. Help please..


Could be relay contact's stuck closed allowing power to stay on . Or it could be a BCM - body control module problem .

Retained Accessory Power (RAP)
The retained accessory power (RAP) system allows certain vehicle functions to operate for a specific amount of time after the ignition switch is turned OFF. The body control module (BCM) monitors the ignition switch position, battery condition, and each door ajar switch status to determine whether RAP should be initiated or terminated. RAP is controlled with two different methods; serial data and relay control. Some modules receive a RAP message from the BCM over the serial data circuits. Serial data controlled RAP is deactivated as required by their modules RAP power mode operation. Other subsystems are activated directly by the BCM through a RAP relay. Components and systems that are active in RAP are also activated anytime the ignition is any position other than OFF regardless of the door switch signals.

Relay Controlled RAP
The BCM keeps the RAP relay energized during all power modes, except Off-Awake and Crank. The relay is also energized for approximately 10 minutes after shutting the ignition OFF and removing the key, providing no door is opened.
Relay controlled RAP will end when one of the following conditions is met:
• The BCM receives an input from any door ajar or open switch indicating the opening of any door after the ignition key is out of the ignition.
Important: If the BCM is receiving any door ajar or open signal from those switches when the ignition key is turned OFF, RAP will not initiate.
• The BCM internal timer for the RAP expires after approximately 10 minutes.
• The BCM detects a decrease in battery capacity below a prescribed limit.
Systems powered by the RAP relay during the RAP power mode are as follows:
• A/T shift lock control solenoid assembly (w/ floor shifter)
• Power window circuit breaker
• RAP fuse
• Inside rearview mirror (DD6)
• Sunroof (CF5)
Serial Data Controlled RAP
RAP systems controlled by serial data are as follows:
Radio
Radio RAP activation/termination is the same as relay operation with 1 exception; the only door switch that will turn off the radio during RAP is the driver door open switch.
Vehicle Communication Interface Module (VCIM) (Onstar®)
VCIM RAP activation/termination is the same as radio operation with 1 exception; if there is an active call when the ignition key is turned off the VCIM will remain in RAP mode, and keep the radio in RAP mode until the call is terminated.

Do you know what a DTC - diagnostic trouble code is ?
DTC B1475 00: Retained Accessory Power Circuit

Your best bet , take it to a Chevy dealer !

Jan 31, 2017 | 2006 Chevrolet Impala

1 Answer

Remove and replace rear drivers side quarter glass 2004 Chevy impala


This video is not on an Impala, but a quarter window is a quarter window. It should give you an idea of what needs to be done.
How to Replace Quarter Window

Jan 28, 2017 | Chevrolet Impala Cars & Trucks

1 Answer

Windshield wipers on 2004 chevy impala when just the driver side works


Did u replace fuses/windshield wiper relay ,both relays ,should be 2 inside the engine compartments fuse box, if not that then the wiper transmission arm could be partially busted or stripped....seems like common problem on this page, maybe lookup if might be free recall replacement

Oct 08, 2015 | 2004 Chevrolet Chevrolet Impala

1 Answer

Chevy fuse box diagrams


You have a fuse panel on the right side(passenger) of the dash panel (open the door to access it).You also have two fuse blocks located in the engine compartment. One is located on the right side by the coolant reservoir, the other is located next to the window washer reservoir.

Jul 20, 2014 | 2004 Chevrolet Impala

1 Answer

Driver's side window buttons work on my 2004 chevy impala but none of the others do?


There is a window lock button that diables all windows but the drivers window, check it.

Oct 03, 2012 | 2004 Chevrolet Impala

1 Answer

I have a 2004 chevy impala. Neither A/C or heater fan works. (I'll assume they are one and the same.) So far I have changed the 20 mA fuse for the A/C fan on the drivers side fuse panel. I have no...


I will asume it is a 3.4 liter/There are two fuse blocks on the passenger side fender well.Open cover and and you find the blower motor (fuse/relay) I hope this will help

May 17, 2011 | 2004 Chevrolet Impala

2 Answers

My 2004 chevy impala power windows no longer work. I replaced the master door panel switch, the fuse on the driver side and they still will not go down, when I press the driver side switch you can hear a...


If the buzzing is sound is coming from the doors, then the motors are going bad. If the buzzing sounds like it's from under the hood, then check the relay switch and see if it went bad and needs to be replaced.

Mar 18, 2011 | 2003 Chevrolet Impala

1 Answer

My 2004 chevy impalas heater only works on the passenger side and not the drivers side. whats wrong and where can i buy the parts for that problem. thank you


You can start by checking to see if there are any blown fuses: There is a fuse panel on the drivers side end of dash.Open cover and check AC/Cruise and DR LK and LH HTD

Feb 13, 2011 | 2004 Chevrolet Impala

2 Answers

2005 chevy impala rear driver power window stopped going up.stuck


If neither switch works it is a bad connection at the motor or bad ground or a bad motor. Remove the door panel unplug the motor push the switch and see if there is 12volts on the wires if there is the motor is bad There are small brushes in the motor that go bad tap on the motor while pushing the switch if it works that way replace it

Mar 29, 2009 | 2005 Chevrolet Impala

2 Answers

My power window in my 2002 chevy impala will not work


The RAP circuit breaker is directly behind the left side fuse panel. The chevy dealer acts like its a big secret and wants 75.00 to plug it in. You have to reach up under the dash and plug it in the BACK side of the left fuse panel. The diagram on the plastic cover is misleading. If you put the seat all the way back, you will have to lay on your back and with a flashlight you should look and you will see where it plugs in. This is on a 2002 chevy impala. Hope this helps.

Best Regards Jeff

Mar 25, 2009 | 2002 Chevrolet Impala

Not finding what you are looking for?
2004 Chevrolet Impala Logo

355 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8265 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...