Question about 1999 GMC Sierra

1 Answer

Not getting power to the ground in front end.

Not sure how to start this so here goes,
Mine is a 99 sierra extended cab Z71, I'm not getting power to front end but when I had it up on stands ,all four corners off the ground. The fnt.shaft is turning and the fnt. wheels spin untill I apply presure to the front tires ( chock one tire and use an axe handle to apply resistance to the other.) I am able to stop the rotation very easly. no grinding,banging or other noise. obviously problem is in the transfer case,, "right?"
I have already replaced the actuator and dash switches.

Thanks in advance,

Jim Krynak,

Oberlin, Ohio.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,990 Answers

This is Definatelly the Transfer Case causing this Problem.

Posted on Jan 24, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1994 GMC Z71 extended cab.... tail lights, interior lights not working but everything else is....What fuse or relay do i look for and where are they located on the truck?


The fuse panel is located under the driver's side of the dash. I'm not sure off hand which fuse controls these lights.

Feb 02, 2013 | 1994 GMC Sierra

1 Answer

What size of motor does a 94 gmc Z71 extended cab have


it is probably a 5.3L but without reviewing the VIN or engine code there is no way to be certain

Sep 30, 2010 | 1994 GMC Sierra

1 Answer

Blower Motor cuts out while operating on my 2001 GMC Sierra 4wd extended cab P/U. Banged on the spot on the passenger side under the dash and it started to work again. What could cause this?


Your truck may have a bad blower motor resistor. It can be very easy to replace, if you have a "work truck" or plain truck just look under the dash and you can see it, it has a connector with about 6 wires on it, it is right beside the blower motor. If you have a higher end truck like a LT or Z71 you will need to remove a plastic trim panel to see it, this will be difficult if you have a center console. You may also have a bad blower, to test this you will need to disconnect the two wire connector on the motor when the fan stops working and check for voltage on the red wire. If there is no power then the resistor is bad, if there is you have a bad blower. But you will need the problem to act up to properly test this.

May 23, 2010 | 2002 GMC Sierra 1500

1 Answer

What years driver side seats will interchange with a 1997 gmc sierra 1500 z71 4x4 extended cab


Call a salvage yard. They have a Hollanders interchange guide and can tell you the correct ones as well as sell them to you.

Feb 06, 2010 | 1997 GMC Sierra

1 Answer

Replaced battery and starter both where bad. Truck


loose connections and starter relay in power distribution box under hood. Make sure you dont have a loose or poor connection on a ground or power wire from battery.

Oct 27, 2009 | 1997 GMC Sierra

1 Answer

What does the 50 amp fuse labeled batt in the fuse box under the hood send power too ? If I dont remove it my battery will drain totally dead over nite. Its in a 1996 chev 1/2 4wd Z71 extended cab


The fuse is the main fuse to the vehicles power supply just the same as removing the battery cable . you have a drain in your electrical system , use a test light , remove the possitive cable from the battery and hook one end to the battery and the other to the cable remove fuses till the light goes off ( make sure all doors are closed and switches turned off) that is your drain source . do no remove the 50 amp fuse in this test .

Aug 28, 2009 | 1996 Chevrolet K1500

2 Answers

How to replace the front diferential seal where the drivers side drive axle go in on a 2000 sierra 1500 Z71 4WD?


THis would be way too much to walk you thru. If you like to do your own maintenance-buy a chilton manual online or at your local auto parts. It will save you time and $

Jan 19, 2009 | 2004 GMC Sierra 1500 Crew Cab

Not finding what you are looking for?
1999 GMC Sierra Logo

137 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...