Question about 2007 Ford Explorer Eddie Bauer
Rear door window hinge, top part.
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
the plastic panel pops off , if you had a trim removal tool it would be nice but it can be improvised , they are just tension clips , get some kind of lever behind the panel and give it a pop , once the plastic panel is off its pretty much self explanatory from there , a connector and couple small bolts , now the outside has nut under the w/w blade , a piece of the arm cover pops up to access the nut , remove w/w arm , then a grommet and under the grommet is a bigger nut that helps hold the motor onto the door/hatch , when reinstalling before you put the w/w arm back on run the wiper and make sure it shuts off and in the park position . should be a piece of cake .
Posted on Jan 05, 2009
You will need to remove the door panel to gain access to the handle. Roll the window up or down as needed to get to the nuts that attach the handle to the door. You will also need to remove a rod the goes to the door lock. You will see the rod after the door panel is removed. Good luck.
Posted on Feb 18, 2009
Wil it work at the door switch or not at either switch? If not make sure you have power and ground to the motor in up and down positions. if so suspect the motor.Also the cable operated regulators break and will not let the window go up or down
Posted on Jul 30, 2009
1. Open window & remove door lock knob. 2. Remove 2 screws from armrest & remove armrest. 3. If manual windows, remove windoe crank. 4. Pry under & remove trim panel around door handle, remove any un-covered screws. 5. This is the fun part, the door panel is affixed with plastic retaining clips, slip something thin under door panel until you can feel where clip is and pull door panel away from door at that point. These clips are suppose to remain in the door panel, but rarely do. They usually remain in the door itself. do this for EVERY clip you find, there are clips approx a foot apart around the entire panel. Good luck. 6. After all retaining clips are pulled out, lift panel slightly to disengage panel from flange at base of window. 7. Disconnect any electric wires or switches and there you have it. Try not to curse.
Posted on Sep 29, 2009
Tips for a great answer:
Jul 02, 2015 | 2007 Ford Explorer Eddie Bauer
Aug 09, 2011 | 2002 Ford Explorer
Apr 19, 2011 | 1996 Mercury Grand Marquis
May 08, 2010 | 2002 Ford Explorer Sport
Feb 17, 2010 | 2003 Ford Explorer
Jan 19, 2009 | 1996 Ford Explorer
38 people viewed this question
Usually answered in minutes!