Question about 1993 Mitsubishi Montero

1 Answer

My front tires ON 2002 lancer DE wore out unevenly with less than

The car has less than 32,000 over 6 yrs of usage and I have had to replace my tires due to uneven wear. The original tirers were Bridgestone radial when I could not get those to replace worn out tire I bought another brand.
The last time I had to get one I got 2 new tire and had them installed in the front. One of those only lasted about 18 months. I had to replace this one since it was actually shredding.
When I went to replace this tire alingment was recommeded to prevent uneven wear.

The mechanics insisted 2 parts had to be installed in order to align the tires and prevent the uneven wear. Please let me know if Mitsubisshi sells autos without this part or if this part was unnecessary.

Posted by on

  • Mike Butler
    Mike Butler May 11, 2010

    What was the part(s) they said had to be replaced/installed?



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,990 Answers

No and No. These parts are on them all and are absolutely Necessary for the Front end to stay alligned. This car will continue to Eat Tires until you replace these parts and get an allignment.

Posted on Jan 24, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Lancer vibrates at 90 to 100 ks at front at front left

bent rim, tires out of balance, worn cv axle, bad wheel bearing, warped brake rotor, bad tire. Change that wheel to the rear, and see if the vibration moves with the wheel. Depending on the vibration, could be a motor/transmisson mount.

Dec 17, 2013 | 2002 Mitsubishi Lancer

1 Answer

I need information about on a 2002 Daewoo Nubira. I had the bushings repaired new and had an alignment, new tires in the front for about a week and now can see the wires sticking out from the inside o

Had a similar problem on my son's Chrysler Cirrus-bad wearing of front tires on the inside. Turned out to be worn inner tie rod ends.
Replaced them and got new alignment. Now it runs better, and is not showing tire wear.
Good luck.

Feb 25, 2012 | 2002 Daewoo Nubira

1 Answer

Is it difficult to change tie rod ends on an 02 Lancer?

I had my outer tie rod end go bad in my 2002 lancer oz and i just bought the pairs and took it in and it total cost me 200. but could be less. I would take it in to a tire shop. that's what i did.

Nov 22, 2010 | 2002 Mitsubishi Lancer

1 Answer

Why does my car starts to shake after 65mph

This problem is normally caused by one of two things, either an out of alignment front end or a bad, unbalanced, or underinflated tire. A out of aligned front end will normally cause uneven wear on your tires, check for uneven wear and for any noticable cracks on the tires, then take to a alignment/tire shop and request a FREE quote to repair.

Nov 17, 2010 | 2002 Pontiac Grand Am

1 Answer

1999 Chevy Cavalier Trying to get this ready for my kid to go back to college. Recently replaced both front tires, brakes, drivers wheel bearing and exhaust leak. The car makes a lot of road noise while...

I have the same thing going on with my 2002 cavalier. I replaced wheel bearings with no luck. My tires also wore uneven toe. Going to try alignment. I'm sure it's the same problem as you describe and it's really annoying. Right hand turns remains the same but long left turns will quite the howling. If you find a solution to this.... let me know

Sep 09, 2010 | 1999 Chevrolet Cavalier

2 Answers

My brake pads wore off unevenly

yuor rotor could be stuck on the side with more pad, dont rebuild it, there cheep enough to buy new

Oct 25, 2009 | 2003 Honda Civic

2 Answers

Rear wheels on my 2000 sport are tilted in on the top.

You need to have your rear wheel alignment checked you have too much camber on your tires

Jun 12, 2009 | 2000 Jeep Cherokee

1 Answer

How to replace inner tie rods on lancer

I had my outer tie rod end go bad in my 2002 lancer oz and i just bought the pairs and took it in and it total costed me 200. but could be less. I would take it in to a tire shop. thats what i did.

Feb 25, 2009 | 2002 Mitsubishi Lancer

1 Answer

Front end noise cavalier

hi, this sounds like track rod ends have gone this is for the steering and causes the tyre to where in one point these are cheap to buy and easy to fit but you will need to get the tracking set after replacing this part as it needs to be set to stop your tire wearing uneven the noise your getting will be from the tire on the road as it will be forcing the tire to run uneven so getting this checked would be my first choice.
Hope this is some help toy you let me know how you get on or if you have any questions ok

May 20, 2008 | 2000 Chevrolet Cavalier

Not finding what you are looking for?
1993 Mitsubishi Montero Logo

Related Topics:

101 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

78238 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides