Question about Cars & Trucks

Open Question

I have a polo 2006 1.6 bah engine the oil light comes on I. Have changed the oil switch. Light stlill stays on checked oil pressure with oil pressure gauge oil pressure is 0.5 bar speck is 2 bar . Changed oil pumb oil pressure still 0.2 bar. Checked big ends and small end bearing no fault with bearings . Removed cam shaft ,cam shaft and cam shaft bearings ok. U.can drive vehicle no engine noise but oil light stays on please advise regards papa joe

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 34 Answers

SOURCE: Come to stop 99 Ram oil pressure drops to 0 check gauges light.

Change the oil! The 318Cu in V8 (5.2 liter) engine has a problem with sludge build up on the oil pump pickup tube screen. This engine requires oil changes at or before 3500 miles with a high detergent oil.

Posted on Jul 07, 2009

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Oil light stays on , oil level is ok


The light is activated by an an oil pressure switch. With the engine not running there is no pressure so it lights up. When the oil recirculates, the pressure increase and the light goes out. Locate yours and change it, they are fairly inexpensive. If it stays lit after a change it may indicate something more serious.

Feb 15, 2016 | 2006 Isuzu Ascender

2 Answers

Why does oil light stay on when oil level is okay?


The oil light is not an indication of oil level; rather it is an indication of oil pressure. If the oil pressure is low enough to light the oil light, you should be hearing some rattling in the engine. Otherwise, it is possible that the oil pressure sending unit is defective. You are lucky if that is the case, because some vehicles are wired that if the oil pressure sensor indicates low pressure, the engine will shut down to protect itself. You should have the oil pressure checked with a mechanical gauge ASAP and take whatever corrective measures are necessary.

Feb 15, 2016 | 2006 Isuzu Ascender

1 Answer

Oil light keeps comeing on ???


Remove the electric sender and install mechanical oil gauge to check that you have proper oil pressure. Bet ya the main bearings are not fitted correctly or the engine wasn't cleaned during overhaul and now bearings are trashed.

Jan 19, 2015 | Cars & Trucks

1 Answer

Oil pressure light stays on even though the oil level is fine


That could be from not having any oil pressure "oil pump failure, clogged filter, etc" or from a faulty oil pressure sending unit. More tests would need to be performed but is it really an oil pressure light or is it the change oil light. More info would be needed

Jan 30, 2013 | 2006 Chevrolet Malibu

1 Answer

Low oil pressure light comes on when i stop giving the car gas like when i come to a stop sign or light and every now and again the check engine light comes on. I change the oil to a heavier oil and the...


This may mean engine wear or bad oil pump. I would have the oil pressure tested to see if its a shot some where or if the pressure is really low, this is done by removing the sensor and installing a gauge and driving the car to see if the pressure is low, if the pressure is low then more checking is neede to see why,you may have worn engine bearings or bad oil pump. depending on the mileage it may be smarter to replace the engine, not knowing what internal damage has been done already. good day.

May 10, 2011 | 2006 Pontiac Grand Prix

1 Answer

Oil light on at stop


engine oil pressure may be low remove oil pressure sending unit and install a pressure gauge check for pressure while warm if pressure is ok replace oil pressure sending unit oil pressure at idle should be between 5-15 psi at min

Nov 17, 2009 | 2006 Dodge Stratus

2 Answers

1992 VW Polo 1.3L Coupe: warning light mystery


Bought a very reputable diy service manual for the vehicle, and that plus a bit of thought and nous gave me the cure: no intrinsic problem other than loose relay connections. Went round with the wiring diagrams as guide checking all electrical connections in tight and relays fuses etc all good. Switched on and no problem any more.

By the way, vehicle is 1992 VW Polo - not Fox (which in UK is a variant of the Polo)


Sep 06, 2008 | 1992 Volkswagen Fox

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

137 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...