Question about 2006 Dodge Sprinter

Open Question

2006 dodge sprinter p0381

Code p0381 glow plug heater indicaor circuit

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 55 Answers

SOURCE: 2006 dodge sprinter esp light on and tire spin light

Go to nearest garage and do diagnosis test and fault erase.

Posted on Oct 07, 2009

  • 37 Answers

SOURCE: working on 2006 dodge sprinter

I did this exact thing.. I see your date of posting is a while ago, however let me know how you ended up.. If you leave the battery connected while installing the relay you can short it out causing the problem all over again.. also there is a couple points that run along that wiring harness that are known to rub through.. let me know how you did!

Posted on Feb 03, 2010

  • 518 Answers

SOURCE: Have a 2006 dodge sprinter trouble code p0107..

Map sensor bad or vacuum &/or power to it missing. Map sensor located on intake manifold or firewall. It has a vacuum hose & electrical connector attached to it. To verify it is bad disconnect electrical connector to it while running. Idle should smooth out & run good. If so need to replace.

Posted on Jun 15, 2010

johnjohn2
  • 5763 Answers

SOURCE: error code that was stored

i could help you better if i had the code #s, check the battery and the charging system.

Posted on Aug 31, 2010

  • 8 Answers

SOURCE: glow plu circuit #2 shorted

i would change all glow plugs and the relay. while doing so make sure the battery is disconnected, also once i had a sprinter with multiple codes and intermittently would run very rough and sometimes not drivable.changed the engine wiring harness and the problem was solved.

Posted on Sep 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What is the code p0473 for a dodge sprinter van 2008


Error Code: P0404
Fault Location:
Exhaust Gas Recirculation (EGR) System - Range/Performance Problem
Causes:
-Hose leak/blockage.
-Wiring harness.
-Exhaust gas recirculation (EGR) valve/solenoid.
Error Code: P0473
Discription:
Exhaust Gas Pressure Sensor - High Input
Causes:
- Wiring short to positive.
- Exhaust gas pressure sensor (G450).
- Engine control module (ECM).
Error Code: P0674
Description:
Glow Plug Cylinder 4 Circuit - Circuit Malfunction
Causes:
-No Pre-Glow Period.
-Poor Cold Starting.
-Glow Plug Wiring faulty.
-Poor connection.
-Relay.
-Glow plug control module.
-Glow Plug faulty.
-Engine control module (ECM).
Solutions:
Check Glow Plug Wiring.
Check Glow Plug.
Error Code: P0675
Description:
Glow Plug Cylinder 5 Circuit - Circuit Malfunction
Causes:
-No Pre-Glow Period.
-Poor Cold Starting.
-Glow Plug Wiring faulty.
-Poor connection.
-Relay.
-Glow plug control module.
-Glow Plug faulty.
-Engine control module (ECM).
Solutions:
-Check Glow Plug Wiring.
-Check Glow Plug.

Sep 20, 2014 | 2008 Dodge Sprinter

1 Answer

Po670 code sprinter


P0670 Glow plug control Module -circuit malfunction

Jan 21, 2013 | 2007 Dodge Sprinter Van

1 Answer

What does error code po671 mean


HI,
http://engine-codes.com/p0671_gmc.html

It's a Glow Plug.

Possible causes- Cylinder #1 glow plug circuit is open or shorted
- Faulty cylinder #1 glow plug
- Faulty glow plug modulehelp.png Help with thisSymptoms- Engine Light ON (or Service Engine Soon Warning Light)
- Lack/Loss of Power
- The engine may be harder to start
- Engine hesitation

Read more: http://engine-codes.com/p0671_gmc.html#ixzz28UT1VO75

Oct 06, 2012 | 2008 Dodge Sprinter

1 Answer

Glow plu circuit #2 shorted on dodge sprinter van. check engine light on. what do i change


i would change all glow plugs and the relay. while doing so make sure the battery is disconnected, also once i had a sprinter with multiple codes and intermittently would run very rough and sometimes not drivable.changed the engine wiring harness and the problem was solved.

Aug 27, 2010 | 2006 Dodge Sprinter

1 Answer

Glow Plug system diagnosis


I HAD SAME CODE TO BUT NOTE THE CODES MIS READING DUE TO THIS Check under seat unplug control module see if it is wet with fluid . cost me $138.00 fee.
Engine light on than next day off may 2 day then on at same place drive kid to school.
issue with transmission fluid wicking up the harness into the control module and causing the module to malfunction. Usually, the harness from the transmission to the ETC module is replaced and the module is replaced provided the leak is repaired. In some cases this may be more than is actually needed but it usually fixes the concern. Transmission fluid does not actually damage the module and can be flushed away with board cleaning solvent or electrical contact cleaner as a first attempt. Always repair the leak before replacing a module.
http://www.benzworld.org/forums/w163-m-class/1465231-mercedes-repair-maintainance-transmission-etc-tips.html

Jul 19, 2010 | 2006 Dodge Sprinter

3 Answers

What is the obd 2 code 0674


sorry. i didn't see the heading. According to what i've seen about this code, you own a diesel. further more it appears to be a glow plug circuit code which also indicates cylinder #4.

Nov 02, 2009 | 2005 Dodge Sprinter 3500 Standard Roof

1 Answer

Working on 2006 dodge sprinter 3500 trubo diesel with engine light on put scanner on and got 2 codes, P0671 cylinder N.1 glow plug circuit and P0380 glow plug circ perf also intake air heater relay N.1...


I did this exact thing.. I see your date of posting is a while ago, however let me know how you ended up.. If you leave the battery connected while installing the relay you can short it out causing the problem all over again.. also there is a couple points that run along that wiring harness that are known to rub through.. let me know how you did!

Mar 20, 2009 | 2006 Dodge Sprinter

2 Answers

Problems with f250 truck


Have you had recall 07S57 camshaft postion sensor rplacement done yet? This recall was for a stalling concern.

Feb 01, 2009 | 2002 Ford F250 Super Duty SuperCab

3 Answers

ECU location


If it is in there check also on the drivers side of the engine block. Often , on new models the ECU is mounted behind the fuel filter housing.
Another way to find the ECU is following the wiring that are coming from the fuse box, on one way they go toward the device, on the other they go to the car computer

Here is the ECU:
1f4bce1.jpg

If you need replacement you can buy here :
Dodge Sprinter Auto Parts & More
Here you can also buy the Chilton repair manual with illustrations for all car parts and all step-by-step iillustrated procedures, this is a must if you want to DIY your vehicle.
Dodge Sprinter Repair Manual - Partstrain.com
Here is a cheaper manual, with immediate download, I do not know if it is good: MANUAL, SERVICE - Downloads

I see If I can find a precise schematic, or a picture, in case I will post it tomorrow, as now I am going offline.

Sep 07, 2008 | 2006 Dodge Sprinter

Not finding what you are looking for?
2006 Dodge Sprinter Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...