Question about Cars & Trucks

Open Question

I cant open the fuel door on my 2003 holden barina, i bought it recently and havent figured out how to unlock it.

It looks as though you could just open it by hand but it wont budge, i need to be able to find some sort of a lever to unlock it but i dont know where in the car this might be

Posted by Anonymous on

  • Anna Rutherford Sep 08, 2013

    Hi - did you find a solution to this problem? I am experiencing the same thing so would appreciate any advice you can offer! Thanks

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
brainyass
  • 242 Answers

SOURCE: cant get the crankshaft pulley off

It's most likely right hand thread. You will have to use a large breaker bar to get enought leverage to remove this nut. Or you can use what ever you have and place a steel pipe on the end of it for extra leverage. If it doesn't budge, you may have to soak it in penetrating oil, and use an impact wrench. Make sure you remove the large washer under the nut "before" you remove pulley.

Posted on Nov 12, 2008

Ad
onyeredson
  • 404 Answers

SOURCE: Holden Barina 1996 Car is

Hi! Was the thermostat and other items replaced due to this overheating? you say coolant level full? maybe your header tank is full but the system isn't? Try bleeding the system. From cold, start the engine with radiator/header tank cap OFF stay with the vehicle and have some very warm water handy. DON'T look over the filler but watch it as the car gets to operating temperature if the water drops drastically top it up with warm water again stay with the car it may take a long time to level out. If the car is bubbling furiously and doesn't want to settle then possible HEAD GASKET Failure or Water pump.
Does your oil look milky on the dipstick? is there an excessive amount of water coming out of the exhaust? are your hoses swelling with radiator/header tank cap on at operating temp?
Sorry to be the possible bearer of bad tiding if the Gasket has gone, but better to sort it now than cause irreprable damage?

Posted on Dec 03, 2008

MrScary66613
  • 1990 Answers

SOURCE: changing a fuel pump on a 1991 holden barina

The Fuel Pump is Inside the Fuel Tank. You will need to Trop the Fuel tank for this. Not an Easy Job by any Means.

Posted on Jan 22, 2009

  • 1 Answer

SOURCE: Cant open fuel filler door,where is the switch?

I have a 97 and there is no release for it. Just push on the right end of the gas cap door to open it. Hope that helps.

Posted on Apr 16, 2009

stevenhurc
  • 450 Answers

SOURCE: 2004 holden rodeo, remote control key wont lock/unlock doors

try putting key in ignition turn to on position
then press lock & unlock several times slowly if door locks cycle up & down after 1st press it lost code and is now resynconised.
now try remote with all doors closed and key out of ignition
if this dont work need to register key(program)back into system which dealer must do with Tech2 if round heart shapped remote

Posted on Jun 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a Holden Barina Hatch 2012 model.


I think the system on that car enables you to open the petrol flap once the drivers door is unlocked (either by pulling the cap open or pressing on the flap).

1. Lock the car using the central locking.
2. Insert the key on the drivers door, turn it once and unlock it. Open the door to check you have unlocked it. Then turn the key in the lock again as if you were unlocking it a 2nd time.
3. Now open the petrol flap as the lock should have released.

Jan 29, 2016 | Holden Cars & Trucks

1 Answer

How do I open the bonnet of my 2009 bow 740? Tried banning on it with someone pulling lever as advised by RAC but no joy


Provided there is still resistance felt in the lever indicating that the cable is still intact have someone put one hand on the bonnet between the grill and the left head light and the other hand in the same place next to the right headlight and while pushing down on the bonnet in these two locations then have someone pull on and hold the lever up then release your weight from the bonnet and try pulling up whilst the person is holding open the lever, if it opens the two bonnet latches need lubricating.

Feb 25, 2015 | BMW 740 Cars & Trucks

1 Answer

2001 Monte Carlo wont start shift cable issue


Don't know about needing the brake pedal pushed to get INTO park, but it might, as the pedal needs to be pressed to get it OUT of park.

Mar 22, 2014 | Chevrolet Monte Carlo Cars & Trucks

1 Answer

My electronic passenger side slider is jammed open. It will budge only about an inch or two. I've tried putting on manual, but it still won't budge.


this happened to me too. I had to remove the inside trim/handle cover to access all the levers that open the door. Toward the top of the collection of levers is one that releases the door from the "locked" position. I'm not sure what the permanent fix is for the problem...I still manually release the lever each time I need to open the door.

Mar 15, 2011 | 2004 Toyota Sienna

2 Answers

Cant get into boot


hi from uk as a getz owner(my wifes car) i do understand problem may i suggest this is most probably the lever on rear of the lockwhich is behind the cover on boothatch is probably loose hence when key is used the lever that connect to rod link and releases latch is slipping on key lock operation but when c/locking is used on drivers door it opens boot latck by motor no problem SO remove the panel from hatch held by screwsnear screen and pop plastic buttons on surround you will now have visual access to lock mech's and by using info provided above ? i am sure you can sort the problem if you use both key in lock operation and c/locking method to observe linkage it may be as suggested or a simple little ajustment of rod linkage hope this helps/inspires you ? best wishes from n/west uk lanc's

Dec 01, 2009 | 2003 Hyundai Accent

1 Answer

How do I remove the third row seat. lever wont budge


I just fixed my dad's 04 suburban with the back seat's #1 lever not budging. It's a surprisingly simple fix: take a 5 inch flat head screw driver and as you look into the slot where the #1 handle goes, you will see a wheel mechanism that it is connected too. to the left of that wheel, you will see a hammer mechanism with a cord attached to it. all you have to do is carefully push the lever with the screw driver while gently lifting up on the handle.
Hope this helps!

Nov 24, 2009 | 2004 Chevrolet Suburban

1 Answer

05 tiburon my steering wheel locked up and i know how to turn the wheel to unlock it with the key but it wont budge how can i remove it so i can drive my car!!!!!!


It only unlocks by hand, keep trying hard it needs to turn one way or the other. It may help to ask a friend for help if you have too much trouble.

Sep 28, 2009 | 2005 Hyundai Tiburon

1 Answer

1994 Jeep Grand cherokee rear lift gate


Well My 94 Jeep Grand Cherokee had the same problem and we had to just cut into the lift gate panel from the inside. It required cutting plastic but with a 94 looks arent everything and a working lift gate was worth it. But then we pealed back this black plastic mat under the panel and lifted up on the release bar(verticle bar that lifts the latch) and once we got it open we adjusted a little clamp that had slipped. Dont adjust it too much or when u lock it it wont lock! But sorry i dont know the name of the parts. But then u can screw the panel back in and it wont look to bad besides some cuts.

Jun 09, 2009 | 1994 Jeep Grand Cherokee

2 Answers

1998 Toyota 4 runner - Cannot raise seat to get tire tools


In the middle of the seat itself, there will be a loop you can pull and the actuall seat part will flip up

May 10, 2009 | 1998 Toyota 4Runner

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

183 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...