Question about Cars & Trucks

Open Question

Diesel injection pump leakingbmw 318tds

Leaking injection pump

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
txkjun
  • 409 Answers

SOURCE: 1999 Volkswagon beetle turbo diesel injection pump

Was any work just done to this car? Timing belt? It is rare that these pumps go bad but I have seen a few shell out. If you are not familiar with the ALH diesel engine I would not try to replace it. You should take it to a shop that specializes in VW's. 

Posted on Dec 29, 2008

Ad
  • 167 Answers

SOURCE: diesel injection pump leaks

all diesel cars built before 1996 have seals in them which are not suitable for the new low sulfur diesel fuels sold today.Only way to remedy the problem is to have new seals fitted.Can be a costly job.Get 3 quotes.
Hope this helps.

Posted on Jun 28, 2009

  • 14 Answers

SOURCE: 6.2 diesel will not bleed diesel

Make sure all lines are light when turning engine over.While turning engine over loosen the a line closes to pump or the fuel filter.You should get some fuel.Then continue on all lines working farther away.

Posted on May 02, 2010

  • 159 Answers

SOURCE: 2000 dodge ram diesel 2500 . what is a fuel inject...

This usually happens when the lift pump gets worn and fuel pressure drops below 7lbs and the injection pump has to work harder by pulling in the fuel and will destroy the pump,your is probably a vp44 fuel injection pump it needs replaced and they are expensive 1200.00+ but also change the lift pump or change to a fass fuel system,if the lift pump went out and you replace the injection pump it will ruin it in a short time.
The injection pump is not an easy job to change or for a novice mechanic as it has to be set in time with the engine at top dead center,and then the whole fuel system needs to be bleed of air.

Posted on Jun 05, 2010

ercupa190
  • 12223 Answers

SOURCE: Yanmar EG907 Tractor, how to increase horse power by adjusting injection pump. is anyone familair with yanmar diesel injection pump.

I believe that you must increase everything. Is not a good idea adjusting injection pump. Will be a great idea,if you get better best answer from directly from the Manufacturer.
Go and get support from them. Will be more efective.
God bless you

Posted on Oct 05, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Injection pump leaking.ford escort 1.8 td 1999


you need 'tractor tire' injector ring seals

Feb 17, 2015 | 1999 Ford Escort

1 Answer

Toyota problems fuel pump leaking


Replace rubber lines to injection fuel pump.

Jun 16, 2014 | 1986 Toyota Hilux 2200

1 Answer

2.8 crd injection pump


alldata.com, log in and read that yet?
did you look at this near FSM?
the 21 steps, read them yet?. did you make it to step 21,?
quote
  1. Disconnect negative battery cable.
  2. Remove engine cover and bracket.
  3. Evacuate A/C system.
  4. Remove accessory drive belt.
  5. Remove cooling fan and fan shroud.
  6. Remove charge air cooler outlet hose to intake manifold.
  7. Remove fan support assembly.
  8. Remove timing belt outer cover.
  9. Using special tool VM.1055, remove high pressure injection pump sprocket retaining nut.
  10. Install feet from VM.1067 in injection pump sprocket as shown.
  11. Install inner flange of special tool VM.1067 on injection pump sprocket as shown. Secure flange to feet in injection pump sprocket with Allen bolts supplied with tool.
  12. Screw the high pressure injection pump sprocket holding plate assembly into flange of VM.1067. Using left hand threaded bolt supplied, secure holding pl
  13. Before servicing the vehicle, refer to the Precautions section. CAUTION High pressure lines deliver diesel fuel under extreme pressure from the injection pump to the fuel injectors. This may be as high as 23,200 psi.(1600 bar). Use extreme caution when inspecting for high pressure fuel leaks. Fuel under this amount of pressure can penetrate skin causing personal injury or death. Inspect for high pressure fuel leaks with a sheet of cardboard. Wear safety goggles and adequate protective clothing when servicing fuel system.
  14. ate assembly to timing belt inner cover.
  15. Disconnect A/C lines at compressor.
  16. Remove charge air inlet hose.
  17. Remove the EGR airflow control valve from the intake manifold.
  18. Remove high pressure injection pump to fuel rail high pressure line.
  19. Disconnect high pressure injection pump quantity control valve electrical connector.
  20. Disconnect fuel supply and return lines at high pressure injection pump.
  21. Remove alternator to intake manifold bracket.
21 Remove high pressure injection pump retaining nuts and remove pump.

Care must be taken not to bend the brake vacuum tube when removing high pressure pump.
unquote:


if you learn a short cut to that, please do post it.

Jan 20, 2014 | 2004 Jeep Liberty

1 Answer

Leak injection pump


Sounds like you are going to have to drop the tank out to inspect and fix. with luck it will be leaking from the fuel pump seal or the return line. If your truck is fuel injected , and the pump is in the tank , regular fuel line hose won't do, need to buy stronger hose rated for fuel injected cars. If it is the return line, won't be as high presure.

Keep us updated or send us additional details.

Jan 22, 2011 | 1991 Toyota Pickup

1 Answer

2001 BMW 530 DIESEL (E39)


LEAKS AT THE INJECTION PUMP CAN BE COMING FROM DIESEL INJECTION PUMP DRIVE GEAR INNER SEAL.LOOK FOR LEAKS AT FUEL SHUT OFF VALVE AND COLD START VALVE.

Jul 08, 2010 | 2001 BMW 5 Series

2 Answers

Engine turns over on my 2003 Jetta 1.9L TDI but does not start. New battery , all lights are working. Changed fuel fillter and put diesel in it to wet it, but still does not start. It did start once and...


When were the glow plugs last changed?

They sit over the cylinder like spark plugs and warm the diesel before it goes into the inlet manifold, greatly assists starting.

May 17, 2010 | 2003 Volkswagen Jetta TDI

1 Answer

Fuel pump leaking diesel


internal drop the tank and replace extenally you may be able to get away with cutting of the broken section and replace with rubber fuel injection hose and fuel injection high pressure clamps. Make sure ints for fuel injection regular hose will strectch and leak.

Mar 12, 2010 | 2000 Ford Escort

1 Answer

Diesel injection pump leaks


all diesel cars built before 1996 have seals in them which are not suitable for the new low sulfur diesel fuels sold today.Only way to remedy the problem is to have new seals fitted.Can be a costly job.Get 3 quotes.
Hope this helps.

Jun 28, 2009 | 1989 Toyota Corolla 2 Door

2 Answers

Does any one have any thing to say about check engine code P-0411 for a dodge stratus 2004 please send me any thing regarding this code


P0411 is a code for your air injection sysem to operating properly it could be a bad air injection pump or a blown fuse for the pump also an air leak (vaccum leak) check to see if the air pump is working if it is then check your hosesfor leaks if none found have the code cleared and see how long it takes to come back.

Jun 08, 2009 | 2004 Dodge Stratus

1 Answer

1999 dodge diesel 2500 seems to have a fuel related problem.


Please clarify the "loosing power" does it lose power and shut down or does it loose power but will idle? Your Cummins is electronically controlled so oil condition is important, fuel leaks, oil leaks, leaks in the air ducting between the turbo and the intake, sensors, water in the fuel. Do you get an engine light when this trouble happens? Dodge uses a lift pump to carry fuel to the the injection pump, is it working?

May 31, 2009 | 1999 Dodge Ram 2500 4WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

115 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

80417 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15314 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...