Question about 1999 GMC Savana

Open Question

FUSE ISSUE i NEED TO KNOW WHAT FUSE GOES TO THE FACTORY LIGHT HOOK FOR MY TRAILER ON 1999 GMC SAVANA THE COVER PANEL IS MISSING SO I AM NOT SURE WHICH FUSE TO CHECK

Posted by on

  • Rick Byrd
    Rick Byrd May 11, 2010

    hi butlerg330 , looking at your schematics on the 99 gmc savana , there are no fuses for your per say trailer wiring , the fuses are upstream to the trailer wiring , the trailer wiring is just an add on to the vans circuitry , i'll explain , if your trailer was plugged in and a malfunction in the trailer wiring shorted it would blow the fuse for the vans fused circuits , so , if your vans parking lights , brake lights and turn signals that work on the van , then a problem with trailer lights would be elsewhere . if there is a problem with any of these described lights on your van , then checking fuses would be in order . location of your fuses are in the instrument panel fuse block , the turn signal fuse is the #16 slot - 20 amps , the stop lamps fuse is the #1 slot - 20 amp fuse , the parking lams fuse is the #9 slot - 20 amp fuse . according to my resources the fuse panel has identification for these mentioned fuses .

    do you need further assistance ?

    J5

×

5 Suggested Answers

  • 221 Answers

SOURCE: gmc savana van will stop running while driving or start sputterin

It could be a clogged fuel filter or a bad fuel pump. Also try replacing the spark plugs and spark plug wires and having the timing checked. Good luck.

Posted on Mar 11, 2009

countrysi248
  • 443 Answers

SOURCE: where is air conditioner recharge port

remember you will always charge an air conditioner on the low side. which is always on the larger hose. there is a smaller one which is the high side so stay away from the small one.. look up near the radiator and see if you see the dryer which is about 3 inches across and 8 inches long and looks like a cylinder.. on this device there is a port where you can charge it .. also this year might be up near the firewall .. they change locations too often .. thanks and holler if you need more. Jerry

Posted on Apr 25, 2009

emissionwiz
  • 70365 Answers

SOURCE: cant find the location of this oil pressure switch on my 1999 gmc savana 1500 van with a 350 engine

very rear of engine center of block behind intake.

Posted on May 12, 2009

  • 290 Answers

SOURCE: my 1999 gmc savana van turns over but does not

could be a bad fuel pump, or fuel pump relay. they are having problems(a lot) with the ethanol in the gas on GM products.Fuel pumps sales are through the roof at parts house on GM's. Have a pressure check on your fuel system. That is probably it. Add a can of Seafoam to your fuel every 3000 miles to alleviate this problem.

Posted on Aug 28, 2009

  • 1986 Answers

SOURCE: how do you remove the rear side door panel to

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls

Posted on Oct 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My turning signals not working on gms 1999 savanna van


Hi Mary , do the hazard lights work ? Did you check fuse #16 TURNB/U 20amp. in the instrument panel fuse box ? IP Fuse Block ,In the left lower kick panel. If the hazard lights don't work either bad flasher relay !

Apr 06, 2015 | 1999 GMC Savana

1 Answer

Blew a fuse on my trailer lights need to locate where the fuse panel for the trailer


There is a fuse box in the engine compartment usually on the driver side on top of the inner fender well. It's a black square box or sort of rectangular sometimes marked fuses or electronic.On the inside of the cover it should show what and where each fuse goes to.

Sep 07, 2011 | GMC Sierra Cars & Trucks

1 Answer

Marker lights wont work on my trailer. but the break lights and turn signals work. I checked all fuses in the main fuse box and they all look good


96 gmc topkick truck... marker lights won't work... where do i find a fuse box diagram... which fuse box???

Oct 20, 2010 | 2006 GMC Savana

1 Answer

1999 4runner light not working on trailer


Check the bulbs in the trailer. If you know someone with a trailer that you could hook up to try that too. A large majority of trailer lighting systems use a simple circuit pattern. Like Christmas lights. . . one goes out they all go out. etc. Some boat trailer lights will burn out if they are hooked up when it's backed into the water. The pain of trailer stuff is figuring out if its really the trailer or not. When the cover is off the lights make sure you take a good look at the guts of the light. The brass pathways will actually arc and melt. Ruining the light. If its not the trailer start checking the vehicle connections. Remember not to overthink things and start with simple stuff first. Oh and recruit a helper to push the brakes and run back and forth it will speed things up greatly.

Feb 20, 2010 | 1999 Toyota 4Runner

4 Answers

F150 Ford 1998 is there a fuse for a trailer and where is it located? Thank you


There are a few fuses for the trailer tow adapter.

1st, is theodd location on the 97-98, engine mini fuse panel has a 20 A fuse forthe stop / turn lamps. Have seen it covered in tape from the factory onsome 97-98 MY trucks.
This is on page 142 in the owners 1997 manual, all the revisions for the 1998 owners manual I have seen do not include this fuse box for some reason.

Download a PDF version from Ford, for the 1997 MY at :

https://www.fleet.ford.com/maintenance/owners_manuals/default.asp

This is a picture of the Power Distribution Box, additional relay box and engine mini fuse panel with the covers off. The 20A in the upper right panel with the red base, is the trailer stop/turn fuse.
3b8aa6c.jpg

The others :
1. Power Distribution Panel / engine compartment fuse panel
Fuse #1 - Trailer tow back-up and tail lamps
Fuse #16 - Trailer tow battery charge and stop/turn lamps
Fuse #28 - Trailer tow electronic brake

2. Instrument Panel Fuses ( cab fuse panel by hood release )
#23 - trailer tow battery charge relay

Nov 11, 2009 | 1998 Ford F150 Regular Cab

1 Answer

How do you hook up trailer lights on my 1999 gmc 4x4 Suburban


If your only going with a flat 4 connector, you will have a connection behind rear bumper area that you can buy an adapter to put between the connectors & flat 4 will connect from there, otherwise you can splice into your light harness in back of cargo area, behind panel in the corner. That's all provided your only going with a flat 4. If you need more info, just let me know.

Jun 28, 2009 | 1999 GMC Suburban

1 Answer

1991 F150 Interior dash and brake lights not working


you need to change out the 7.5amp fuse in the fuse panel under the dash. make sure you look up because i missed it the first time i had the same problem. the trim makes it hard to see when you have the cover off of the fuse panel.Or you have a short in your wiring or a short to power of an other curcuit. do you know what the code is for the check engine light? what engine is in it?

Apr 26, 2009 | 1991 Ford F150

3 Answers

Trailer light hook up problem


It sounds like your have may have your brake light and running lights crossed on your wiring harness to the trailer. Good luck and hope this help's

Apr 08, 2009 | 2004 GMC Envoy

1 Answer

Left turn signal on trailer


ok tdknutson, I'm not clear on this, does the truck left turn signal stop working when u plug the trailer in, or is it the trailer left turn signal that's not working, or both? When u plugged in the test light did it show u had power to that plug in? Let me know the answer to the above, and in the meantime, check the ground on the turn signal at the trailer. Make sure it's not loose, and tightly connected to the frame (or wire). Also, what type plug in do u have? 4, 6, 7 wire?

Oct 27, 2008 | 2003 GMC Envoy

Not finding what you are looking for?
1999 GMC Savana Logo

Related Topics:

227 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...