Question about Honda Civic

Open Question

97 Honda civic dip stick won't go back in

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

vitaforall
  • 44 Answers

SOURCE: 97 honda civic dx the

what i find common is the parking brake handle slides up over time covering the release button and not allowing the park brake to go down. can you push the button with your fingertip while pulling up on the handle and release the park brake? if so you can tap the handle to the rear with out hitting the button. protect the button with a socket or use a block of wood next to the button. don't hit the button.

Posted on Dec 27, 2008

lemmingleejn
  • 173 Answers

SOURCE: oil filter in civic 97

If you go to a reputable motor factor,
you can only be sold the correct filter for the civic.
As there are soo many variables in engine type, it's almost impossible to tell, oil volume, or which type filter.
However, I will say, be sure that you don't mix semi-synthetic oil, and mineral oil.
Oil changes should be undertaken every 30,000 miles, (unless under extra work load, (in which case, slightly more regularly))

Otherwise, 10/40 or 15/40 grade oil, is perfectly fine.
The trick to not overfilling the oil, is simply just to take your time, clean the dip stick and retry, until you have the correct reading.

Please don't forget to rate:)

Posted on Jul 29, 2009

MNfisherman
  • 11896 Answers

SOURCE: how to remove transmission on 97 honda civic dx

remove crossmember, axles, cables, tranny mount bolts (3), tranny to engine of course bolts

Go to autozone.com and register for full free online repair manual

Posted on Sep 11, 2009

  • 491 Answers

SOURCE: I haveea 97 honda civic. My wipers won't turn off

PRISE SWITCH OUT AND CHECK FOR CROSSED WIRES IF SWITCH IS CAPUT GO TO BREAKERS YARD FOR REPLACEMENT.

Posted on Oct 24, 2009

  • 211 Answers

SOURCE: 97 honda civic ex inconsistent turn signal

Check the connections of the bulb sockets and the contacts on the bulbs themselves. Sometimes a small amount of corrosion or oxidation can increase the resistance in the circuit enough to cause the flasher to cycle erratically. When the fast flashing occurs, check both your front and rear bulbs. Is one dimmer than the other? If so, start by checking that one first.

While unlikely...does your Honda have any sort of towing capability? If so, corrosion or a short in your trailer light connection can also wreak havoc on a flasher. If your car has a tow hitch, you may want to remove the trailer wiring adapter from the car's factory wiring and see if the problem disappears. If so, either remove or replace the defective controller.

Posted on Feb 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

99 honda civic won't go into 1st and second gear after replacing the clutch


Check the gear lever linkage adjustment, and the gear lever stick foundation.

Apr 16, 2013 | 1999 Honda Civic

1 Answer

Got a 97 Honda civic ex and it won't turn over,


It appears that the longer time to warm up is because there was no water in the radiator and running for 30 minutes would cause the motor to seize. Check it out.

Mar 22, 2013 | Cars & Trucks

1 Answer

Honda civic stuck in deadlock can't open any doors as the key won't work in any of the door lock's or boot


Try having a new key cut using the key code, at a dealer, not tracing the old key.

Feb 25, 2013 | 2003 Honda Civic

1 Answer

97 Honda civic won't start. Has had timing belt and pulley replaced along with rotor button


Did the timing belt break? Are you 100% that it is "in time" correctly? Does it spin over effortlessly? If so,do a compression check,and make sure you dont have any bent/broken valves,or blown head gasket.

Sep 23, 2012 | 1997 Honda Civic

1 Answer

My 1998 Honda civic ex won't move but the motor


Have you just replaced the clutch? Taken out the transaxle, and put it back in? Are you sure transmission was in good condition before this? If so, review your procedure carefully to be sure you got it all back right.
Watch the slave cylinder while someone depresses clutch. You should see the little plunger move slightly out and move the clutch lever back. The lever moves the release bearing inside bell housing into contact with the pressure plate. If slave cylinder doesn't move at all, try bleeding again. The plunger has to move when clutch is engaged.
I'm not sure what you mean by "will shift but won't go into gear". You mean it's actually going into a gear position and car won't move? Or it won't go into any gear, period. As if you had no clutch?

Nov 06, 2011 | 1998 Honda Civic

1 Answer

Transmission dipstick location


the dip stick is located in engine compartment if you stand in front of car with hood open the dip stick is to your left on side of trany, if this car is stick shift and not automatic then theres no dip stick its checked from side of trany by removing a plug and fill until oil runs out a little a lift would be the way to check it, the car must be level
NOTE; some models have a tube with dip stick and some a cap that unscrews on top of trany and when checking fluid you dont screw in just stick in hole to check level when done then screw back in and tighten,heres a diagram to help you find it.c083006.gif

Aug 25, 2010 | 1991 Honda Civic

1 Answer

Oil filter in civic 97


If you go to a reputable motor factor,
you can only be sold the correct filter for the civic.
As there are soo many variables in engine type, it's almost impossible to tell, oil volume, or which type filter.
However, I will say, be sure that you don't mix semi-synthetic oil, and mineral oil.
Oil changes should be undertaken every 30,000 miles, (unless under extra work load, (in which case, slightly more regularly))

Otherwise, 10/40 or 15/40 grade oil, is perfectly fine.
The trick to not overfilling the oil, is simply just to take your time, clean the dip stick and retry, until you have the correct reading.

Please don't forget to rate:)

Jul 29, 2009 | 1997 Honda Civic

1 Answer

We have charged the battery but it won't move when I've put it in gear.


It's a short dipstick, located at the front of the engine compartment, very low, towards the bottom of the radiator.

May 20, 2009 | 1991 Honda Civic

1 Answer

What would make the crankcase on a 1999 Honda Civic LX pressurize, it has oil vapor shooting out of the dip stick tube & is pushing oil out of the front & rear main oil seals? The car starts fine,...


I saw this once where a guy took his car to one of those Quick Oilchange places and the kid put in new oil and forgot to take the old out first. Another thing to check is youre PCV Valve, if this is blocked it will increase your crank case pressure.

May 18, 2009 | 1999 Honda Civic

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...