Question about Ford Maverick

1 Answer

There are noises in the engine of my ford maverick.the mechanic changed the bearings just last week,what is the problem again?

The car is a 4*4 with 2300 engine capacity.the year is 2005 make

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 22 Answers

?????????????????????????????????????????????????/ mavericks have not been made since the 70"s

Posted on Jan 16, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Big Poppa Ma
  • 302 Answers

SOURCE: Squealing noise- internal or external

heads are bad

Posted on Dec 05, 2008

  • 1201 Answers

SOURCE: 96 Ford windstar GL

If there is white smoke coming out of tail pipe, the head gasket is blown. needs to be replaced.

Posted on Jan 27, 2009

  • 30 Answers

SOURCE: Ford Focus Engine System Fault warning light

yes there is a know problem with the fuel system. fuel pump breaks down, empty your fuel filter into a bowl and check for metalic, if you have this in the filter your pump is F..... along with all the other common rail stuff. expensive job... error codes though, i find that hard to believe, fuel pressure faults will occur, i think you garage does not know what to do. or does not want to tell you the cost of the job and he will be in doubt himself of wether he is right..... was you engine coil light flashing at any point.!!!

Posted on Mar 30, 2009

  • 5 Answers

SOURCE: Kia Sportage front wheel noise and vibrating

Sounds like a problem I had. Turned out to be the vacumn valve that locks the hubs when in 4wd. The car was not in 4wd but the hubs were always locked causing the wheels to vibrate and chatter especially when turning.

Posted on Jun 29, 2009

  • 216 Answers

SOURCE: 2005 mazda 3 2.3l that is burning oil (no leaks)

possibly the pcv but check if your cars exhaust smoke is blueish or white in color if it does and your car doesnt have an oil leak then sure its burning engine oil along with fuel, the piston rings is defective, since you replaced engine oil the additive that the owner has put with the oil to prevent blowby is gone thats why it starts burning oil.....

Posted on Apr 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What's the torque on rod bearings?


Engine Noises ' Knocking and Ticking ' Common Causes

www.justautorepair.com/whats-wrong-with-my.../knocking-ticking
The following are causes of connecting rod bearing noise: ... Loose torque converter-to-flywheel or flywheel-to-crankshaft bolts will sound similar to bearing knock. .... I got a 1998 tahoe its making a lil ticking noise after I got unstuck on some ice ... 2001 FordTaurus with a loud mechanical noise that is constant when engine ...

Change 4.6L rod bearings with engine still in vehicle? 02 Explorer ...

www.ford-trucks.com > ... > Modular V8 (4.6L, 5.4L)
Aug 11, 2011 - The regular everyday rattling noises seemed to get louder than usual. ...So I dropped the pan and this is what I found: ... Is it possible to change the rod bearings with the engine still in the vehicle? ... If you decide to go with new bearings,torque your caps down on some plasti-gauge and see if you get the ... 7.3 engine r&r
Mar 22, 2012
Rod Bearing Replacement
Dec 27, 2010
More results from www.ford-trucks.com

Dec 28, 2015 | 2000 Ford Explorer

1 Answer

2004 Ford explorer engine knocking


take it to an accredited service shop that has experience on your make of engine and have a proper diagnosis done and quote
it is possible that there is a spinning main bearing and the test is a oil pressure test using a mechanical gauge
some times it spins , low oil pressure -knocking other times it stops and the oil pressure goes back up , knocking stops
should I be correct , normally it can be repaired in car by removing the sump and replacing that bearing shell, of the shaft is not damaged
i would steer away from a new engine or suggestions of a blown engine but it could be serious

Apr 04, 2017 | 2004 Ford Explorer

1 Answer

2002 Chevy Cavalier makes Grinding / Vibration noise when steering wheel turns right. Noise goes away when wheel turned to the left. Both Wheel bearings hub assys. Changed 4 mths ago. Noise started 3 mths...


may be you should make a diagnostic and you can do it in a garage or you can do it by yourself if you want to do it by yourself you need some tools and you can find some good ones here: spobd2.com

Feb 02, 2013 | Cars & Trucks

1 Answer

Why does my fan belt on my 2002 ford taurus keep coming off


You may have a idler or pulley that is getting a bad bearing and throwing the belt. The belt can stretch some but if they do most will squeak or not cool the engine and you will see the engine temp go up when it is slipping and then when it catches the temp will go back down.

Jun 13, 2017 | 2002 Ford Taurus

1 Answer

Can the front differential on a 2003 ford explorer make a loud hum like a wheel bearing. I just replaced the drivers side front wh bearing and it seems to make less noise but it still makes it and changes...


Do the other bearing & change the diff fluid

Then get back to us

Flush the Power Steering Fluid
& add Lubgard,just make sure it
isn't the honda one

Jun 09, 2011 | 2003 Ford Explorer

1 Answer

Have a 03 matrix with a oilpump promblem I think,bought the car last week ran good next day was drive on highway notice oil lap on and noise from motor ,slowed down light went off.Next day change oil and...


Generally three things can turn the light on. First is the sending unit itself if it's going bad. Next is an obstruction of the pump pickup screen (usually hard carbon deposits). Third is worn engine bearings (usually rod bearings). Best way to find the problem is to have someone put a mechanical pressure gauge on the engine and read the actual pressure. If it's low you need to go into the engine to determine why. if it's normal, replace the sending unit. Senders aren't terribly expensive and you could just buy one and replace the one you have, providing the engine isn't tapping or knocking.

Mar 14, 2011 | 2003 Toyota Matrix

1 Answer

Noisey gear box. silent when clutch is engaged


change fluid first then go from there

May 27, 2009 | 2007 Ford F

1 Answer

New Clutch, New Noise!


throw out baring was inproperly installed

Mar 30, 2009 | 1998 Ford Escort

2 Answers

Rear wheel bearings keep going after only a short period of use.


When you install the bearing are you replacing the complete hub? The torque spec for this is 130-174 ft.lbs. Also are the rims and tires of stock size?

Jul 07, 2008 | 1998 Ford Escort

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...