Question about 1988 Ford Taurus

1 Answer

Its not fireing

Batter is good new the plugs are new the wires are new

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 93 Answers

Sounds like you're not getting juice to plugs. Can check by putting screwdriver in plug wire and hold blade close to grounded metal. If no spark then start working backwards. Be careful, these voltages are very high.

Posted on Jan 15, 2013

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
alicantecoli
  • 22219 Answers

SOURCE: 2001 ford windstar-new coil pack,new spark plugs

head gasket?? blowing between two cylinders

Posted on Mar 19, 2010

  • 117 Answers

SOURCE: back firing thru intake, tune up done-new plugs,

check your plug wires again and check the cap and rotor sounds like either a bad cap and rotor or a couple wires backwards

Posted on Apr 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Truck is not firing on 3 cylinders yet it runs.. Runs really rough, back fires, under powered.. Plugs are Wet, Firing order is correct. New Spark plug cables. Don't know that is wrong! Please Help


Check for spark at the plug ( may have coil problem).
If spark is good then do a compression check. Pressure shouldn't be less than 75% of known good cylinders.

Apr 17, 2013 | 1995 Dodge Dakota

1 Answer

I have a sebring 2004 v6 2.7 which is misfiring. put it a new coil and changed plug on cylinder that doesnt fire still no spark. im getting power all th way to the plug tested with volt meter.it reads 14...


Invalid test. When plug fires, the wire shoots around 40,000volts. When not firing, there is no current in the wire.
Try switching the misfiring plug wire with another that is firing. Switch them both at the plug and at the coil tower. If that was a bad plug wire, the misfire will now be on the cylinder where you put the suspect wire. This will confirm a bad plugwire.
Good luck.

Nov 25, 2011 | 2004 Chrysler Sebring

2 Answers

2000 volvo v70. no start.


probley a loose connetion on batter or a short in wire or try checking spark pluges and ground wires even the fuse boxs

Jul 01, 2010 | 2000 Volvo V70

1 Answer

Back firing thru intake, tune up done-new plugs, wires,cap and rotor. timing good, firing order good... 5.8l efi


check your plug wires again and check the cap and rotor sounds like either a bad cap and rotor or a couple wires backwards

Apr 15, 2010 | 1992 Ford F150 SuperCab

2 Answers

Car will turn over but won't start


Have you checked the timing belt?

Mar 13, 2009 | 1997 Nissan Sentra

1 Answer

Miss firing


could be a wire crossed, or it's out of time. since you used motorcraft plugs, did you set them properly to the correct gap? replacing plugs without gapping them can cause the sluggishness, out of time can cause the mis-fires and rough running.

Nov 27, 2008 | 1994 Ford F150 Styleside Supercab

1 Answer

1196 chey blazer


overheating could be caused by a stuck thermostat or a clogged radiator not firing on #1 plug could be a fouled plug or bad wire or it may be grounding on the block and your coiil may not have been put in at the right mark

Aug 09, 2008 | 1996 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...