Question about Ford Cars & Trucks

Open Question

Where is the heater control valve on 2002 ford f150

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75117 Answers

SOURCE: location of the heater control valve

There are 2 hoses going through the firewall from the engine, these are the coolant hoses to the heater core, one is 3/4" and one 5/8", the control valve should be in the larger line (3/4") which is the inlet, make sure that the valve has vacuum (heater on low), also check and see if both hoses get hot with the heater blower on low, if they do get hot your problem is not the heater control valve but the air temp control blend door actuator.

Posted on Dec 28, 2008

  • 1596 Answers

SOURCE: 1990 ford f150 cross over valve location

Please Help ME by Remembering to RATE ME Thank you Vrey Much !!!

This vehicle does not use an external fuel tank switching valve. A supply check valve in the fuel pump assembly opens when the outlet pressure from the energized fuel pump exceeds the opposing check valve spring force.


R E C A L L 1991
THE DUAL FUEL TANK SELECTOR VALVE MAY MALFUNCTION AND CAUSE AN OVERFILL CONDITION IN ONE OF THE FUEL TANKS, RESULTING IN AN OVERFLOW OF FUEL PAST THE FILLER CAP.
THE OVERFLOW OF FUEL PAST THE FILLER CAP CAUSES A FUEL LEAKAGE, WHICH CAN RESULT IN A FIRE WHEN EXPOSED TO A SOURCE OF IGNITION.
REPLACE THE DUAL FUEL TANK SELECTOR VALVE.
SYSTEM: FUEL TANK, AUXILIARY.
VANS AND LIGHT TRUCKS WITH DUAL FUEL TANKS PRODUCED IN THE FOLLOWING PERIODS: F150, F250, AND F350 LIGHT TRUCKS BUILT BETWEEN FEBRUARY 28, 1989 AND JULY, 1989; ECONOLINE BUILT BETWEEN FEBRUARY 28, 1989 AND FEBRUARY 11, 1991.
NOTE: FORD HAS AGREED TO RECALL THESE VEHICLES BUT PARTS ARE NOT YET AVAILABLE.PARTS WILL BE AVAILABLE IN DECEMBER 1991. YOU WILL RECEIVE A LETTER FROM FORD ADVISING YOU WHEN TO SCHEDULE AN APPOINTMENT WITH YOUR DEALER TO HAVE THE RECALL WORK PERFORMED. IN THE MEAN TIME, YOU CAN TAKE THE FOLLOWING PRECAUTIONS:FILL EACH TANK TO ONLY 1/3 FULL. IF YOUR VEHICLE LEAKS FUEL OR IF YOU SMELL FUEL, STOP USING THE VEHICLE AND CALL FORD AT (313) 446-4654 AND ADVISE THEM OF YOUR PROBLEM. REFER TO FORD SAFETY RECALL NUMBER 91S39. AN OPERATOR WILL TAKE YOUR NAME AND TELEPHONE NUMBER. A FORD REPRESENTATIVE WILL CALL YOU BACK

Posted on Jan 21, 2009

  • 396 Answers

SOURCE: where is the heater control valve locatedon a 2002 mitsubishi

Most heater control valves are on or near the firewall behind the engine. Look for coolant hoses attached to a small metal piece. It also will have an arm that has a cable from inside the vehicle attached to it.

Posted on Oct 19, 2009

emissionwiz
  • 75117 Answers

SOURCE: were is the idle air control valve located on my

at the throttle control valve in the upper intake manifold. has 2 wires to it, is a long and round and about 8 inches long.

Posted on Dec 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

2002 Ford f150 evaporative emission control system sensor where is it located


on top of the canister purge can , next to the solenoid of same purpose

Jan 30, 2016 | Ford Cars & Trucks

2 Answers

Why is there no water going to the heater core in my f150?


Could be your water pump is bad and not circulating correctly.

Jan 14, 2013 | 2004 Ford F150

1 Answer

What is the purpose of a inline water flow control valve. (Manual flow valve) in a F150 Truck


If you mean a valve in one of the heater hoses, it cuts hot water off from flowing thru the heater core. Its controlled by the temp switch on the dash.

Dec 19, 2012 | 2001 Ford F150 Styleside SuperCrew

1 Answer

Where is the heater control valve located on my 2002 ford escape v6?


I don't show a heater control valve for your truck. It should have a blend door under the dash that controls air flow thru the heater core.

Dec 08, 2012 | 2002 Ford Escape

2 Answers

No heat in cab f150 2002 extended cab the gauge shows that the engine is warm.


Check the antifreeze protection. Has it been more than 2 years since you changed it? If there's too much water,you need to add antifreeze. Or,you may need to replace the thermostat.

Jan 12, 2011 | 2002 Ford F150 Regular Cab

1 Answer

Where is the heater control valve located on 2000 ford f150 xlt v6


Good day,
It seems you want to replace the heater control valve on your ford,follow the instructions provided below

1.Simply look right above the battery and you will find a TEE valve on a little black hose.In some cases the valve comes in a blue colour on the tee.
2.Pull it off and slide the other that needs to be replaced in the tee.


Have a nice day.

Dec 04, 2010 | Ford F-150 Cars & Trucks

1 Answer

2002 F150 v6-4.2L I have a service engine soon ligth on. Install a reader and the code is P1518 manufacturer controlled vehicle speed, Idle control & auxilliary inputs.


YOUR DIFINITION IS INCORRECT, HERE IS THE CODE FROM THE FORD REPAIR MANUAL

P1518 Intake Manifold Runner Control (Stuck Open)
CHECK FOR DISCONNECTED INTAKE RUNNER CONTROL VALVE LINKAGE AT UPPER PLENUM CHAMBER

Oct 09, 2009 | 2002 Ford F150 Regular Cab

1 Answer

Service engine soon light on


you may have a bad intake manifold anti swirl control unit or the vaccum valve, check all connection first and check for vaccunm leaks hope this helps.

Oct 08, 2009 | 2002 Ford F150 Regular Cab

1 Answer

I got problems with my heater on a 4.2 1998 f150 pick up truck


  1. Heater control Valve
  2. Low on coolant
  3. Thermostat sticking
  4. Air in Cooling system
  5. Control Module HVAC

Jan 13, 2009 | 1998 Ford F150 Regular Cab

2 Answers

Location of the heater control valve


There are 2 hoses going through the firewall from the engine, these are the coolant hoses to the heater core, one is 3/4" and one 5/8", the control valve should be in the larger line (3/4") which is the inlet, make sure that the valve has vacuum (heater on low), also check and see if both hoses get hot with the heater blower on low, if they do get hot your problem is not the heater control valve but the air temp control blend door actuator.

Dec 28, 2008 | 2004 Ford F150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

519 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5471 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...