Question about Chevrolet Silverado 3500

Open Question

How to bypass rear tank on a 2001 chevy 3500 - Silverado 3500 Chevrolet Cars & Trucks

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

citroenchris
  • 600 Answers

SOURCE: i need a rear brake diagram for a 89 chevy 3500 4x4

Try this website :-http://www.compnine.com/index I used it to fit a parking brake to our 1999 sierra that had them missing

Posted on Aug 06, 2009

  • 400 Answers

SOURCE: how to set timing for a 2001 chevy 3500 van

Which engine is in the Van?

Posted on Oct 26, 2009

  • 67 Answers

SOURCE: how to remove of a 2001 3500 chevy express dual

Take off the rear wheels, the bolts in the end of the axle, slide it out. Should be a small clip that holds a slide key to keep the nut from spinning off. Take off the clip and take extra care not to loose it or the small block it holds. Take the nut off, which may take a special socket as if memory serves correct it's round with indentions the socket catches for removal. Once the nut is off pull the drum with equal pressure. It should slide off. The seal inside the hub should be replaced to save axle grease ruining the brakes on reassembly. Not sure what you are doing in there so I'll skip to assembly. You will have lost a decent amount of gear lube in the process. If you've taken both drums off assemble one all the way back to the tires. Lower it and raise the other side as high as safely possible. Pour in two quarts of gear lube through the axle spindle (the opening the axle slides into) and finish the assembly. Next jack the other side back up and let it stay that way for a while. This let's the gear lube run into the hub to lubricate the bearings. After 10 minutes or so lower it and pull the high plug out of the axle housing, if fluid runs out allow it to. You don't want too much. If not add to it until it's full.

Posted on Jan 22, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 chevy truck 3500 check wiring on fuel pump harness


images for 2000 chevy truck 3500 check wiring on

How to Install New GM Wire Harness on Fuel Pump Module ...

? 3:10
https://www.youtube.com/watch?v=FffdzqknP3k
Apr 20, 2012 - Uploaded by Airtex Pumps
This video is about how to install a new Airtex fuel pump module into some GM ... fuel pump and gas tank to a 98 internal fuel pump and gas tank on my truck 88 gmc. the wires are a little different. .... Check the power & ground at the pump. ... CHEVY SILVERADO FUEL PUMP CHANGE OUT.2500HD 2001.

How to test an electric fuel pump - YouTube

? 13:54
https://www.youtube.com/watch?v=Q3ZiTsKCdO8
Feb 3, 2012 - Uploaded by ScannerDanner
2001 GMC 3500 8.1L engine with no fuel pressure. In this video I am showing how to test the fuel pump electrical circuit using atest light and scan tool. ... seconds on the ground wire. when i unplug the harness from the the fuel pump .... need help newfuel pump chevy venture 2004 runs for a few days then ...

How to Install Fuel Pump E3947M in 1997-2000 Chevrolet ...

? 5:53
https://www.youtube.com/watch?v=9LLLRVnItbI
Apr 20, 2012 - Uploaded by Airtex Pumps
Applications: 2000-97 CHEVROLET/GMC C, K 1, 2, 3 TRUCK 262... Please check out our 'How to Install New GM Wire Harness onFuel Pump ...


Jan 22, 2016 | Cars & Trucks

1 Answer

How to replace a fuel pump for a chevy express 2001 3500


Fuel Pump Removal & Installation To Remove:
  1. Disconnect battery negative cable.
  2. Relieve Fuel System Pressure.
  3. Raise and safely support vehicle.
  4. Remove Fuel Tank.
  5. Remove fuel sender assembly by turning cam lock counterclockwise. gm-04-00-954.gif

  6. Remove fuel sender assembly from fuel tank.
To Install:
  1. Using NEW O-ring seal, install fuel pump sender to fuel tank.
  2. Install cam lock assembly and turn clockwise to lock.
  3. Install Fuel Tank.
  4. Cycle the ignition switch ON and OFF to pressurize the fuel system and check for fuel leaks.
prev.gif next.gif

Jan 28, 2011 | Chevrolet Express Cars & Trucks

1 Answer

Adding extra fuel tank on a 2001 chevy dually crew cab long box


Actually,an aftermarket fuel tank is available that should bolt in in place of existing fuel tank that holds 55Gallons instead of the reg.30gal. check out this site...http://www.titanfueltanks.com/GMC_Chevy_Fuel_Tank.htm

May 04, 2010 | 2001 Chevrolet Silverado 3500

1 Answer

2001 durimax 3500 dula fule gague dose not work


sounds like a ground proublem try to reach top of fuel tank an wigle wires if helps may have to drop tank to clean ground some times you may see between cab and box take stick to see if loose grounds get croted on them tap it also leave key on and try if it moves at all that is it

Dec 16, 2009 | 2001 Chevrolet Silverado 3500

2 Answers

I have a 2000 Chevy 3500 box truck with 2 gas tanks. The gas guage only goes to 1/2 with both tanks full and it won't pump gas from the second tank. How do I fix this.


Fuel levels are equaled in the tanks via a frame mounted transfer pump that transfers fuel from the rear tank to the front tank where the main pump is. Your transfer pump needs replaced, and should run about 60 bucks. Should find the pump mounted to the frame between tanks.

Oct 14, 2009 | 2000 Chevrolet 3500

2 Answers

I own a 2003 chevy silverado diesel dullay 4x4 and none of the controls work for the passenger side window, I need a wiring diagram.


Hi I have a 4x4 2003 chevy 3500 silverado dually with dual tanks
rear tank stoped pumping into front tank and was full . I siphoned the fuel out of rear tank and fuel gauge reads 9/16 full . is there a way to reset the fuel sending units so they can calculate the fuel readings. I always filled the two tanks with the same amount of fuel
until now ? I'm thinking there is a inkine fuel pump

Aug 31, 2009 | 2003 Chevrolet Silverado 3500

1 Answer

Water in gas tank. how do i drop two tanks on 1999 chevy 3500 steak truck


Normally it's just a matter of removing filler tubes from side, disconnect fuel lines & electrical connections at fuel pump/sender, undo the 2 straps, & lower it down.

May 15, 2009 | 1999 Chevrolet 3500

2 Answers

Fuel pump for 2001 gmc 3500 box van


The fuel pump is in the tank, there is one for each tank if you have dual tanks, also change the fuel filter with pump.

Nov 06, 2008 | 2001 GMC W3500

1 Answer

My 1989 chevy 1 ton truck has no brakes, the shoes are new, lines are bled , master cylinder tests good, but no pedal at all


check the anti lock solinoid to the rear brakes, it has a valve and a resiviour in it, it is in the line to the rear brakes, usually the valve or diaphram goes bad, easiest way to check it is to bypass with a piece of brake line

Jul 16, 2008 | 1988 Chevrolet C/K 3500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...