Question about Cars & Trucks

Open Question

How to remove interior door panel astra 1996 - Cars & Trucks

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
ginko
  • 19396 Answers

SOURCE: Need to replace the driver's door interior door opening assembly

Hi there.

The procedure is roughly the same for all mk3 x types.
You need to remove all the screws on the armrest and on the ashtray, then undo all the plastic clips using screwdrivers on the panel.

You find detailed instructions on links below, I quote:

" remove two screws at the bottom of the armrest.
pull out ash tray.
remove screw in the middle of the ash tray holder.
pull up on armrest, it should pop up, then pull it out
start at bottom right of door and start popping out the plastic clips (all the way around the door)
(remove speaker wires)
push up door panel - done"



WikiAnswers - How do you remove a rear door panel in a Jaguar XJ6


Also from manual:

Disconnect vehicle battery ground lead.
Remove the door trim pad veneer panel.
Remove the upper trim pad.
Remove the door armrest.
From inside the door pocket, release the puddle lamp (1 Fig.1) securing quarter turn fastener.
Undo and remove fixing (3 Fig.1), (front door only)
Carefully release lower trim pad fir tree fasteners.
To avoid damage and distortion of the door metal, lift the lower trim pad complete with clip and clip retainer.
Carefully pull the trim pad away from the door panel.
Disconnect the multi-plugs (1 Fig.2) and remove the lamp.
Carefully displace the trim pad (2 Fig.1) from the door retaining clips.
Disconnect the multi-plugs (2 Fig.2) and (3 Fig.2).
Remove the door pocket.
Displace and remove the retaining clips and remove the trim..
Refit in the reverse order of the removal procedure. Check the trim pad retainers for damage before refitting.

Before refitting the lower trim pad, remove the clip retainer from the pad and and reposition retainer to the door.

ndo door handle escutcheon screw and remove escutcheon
Remove the door trim pad veneer panel.
Undo and remove the upper trim pad securing screws.
Remove the chrome strip.
Undo and remove the top channel securing nuts.
Displace and remove the top channel assembly.
Place the trim pad aside (Fig. 1).
Refit in the reverse order of the removal procedure.

bbad647.gif

36a4a47.gif

cc1f9fe.gif

Thanks Jaguar XJ6 Interior Lights

I will be grateful if you can rate the solution given.

Many thanks.

G.

Posted on Feb 25, 2009

Ad
  • 2 Answers

SOURCE: removing door panel in 2000 toyota corolla

remove phillips scew and the door handle. remove padded arm rest on the door by lifting it up, and remove 2 screws. You can use a panel tool to remove the plastic toggle like pins holding the panel border in. Be as gentle as possible they may break due to becoming brittle.

Posted on Apr 06, 2009

  • 1986 Answers

SOURCE: door panel removal

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

  • 1986 Answers

SOURCE: How to remove interior door panel on 2002 chrysler t & c???

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

  • 1986 Answers

SOURCE: need directions to remove driver door interior panel 1997 deville

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls

Posted on Sep 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

NEED TO GET INTERIOR DRIVERS DOOR PANEL OFF FOR 2008 ASTRA SATURN


You need special tools to get the fasteners out of the door or you'll permanently damage the door panel. there are hidden screws on the arm rest and door latch handle. Let a mechanic with the tools do the job.

Mar 07, 2016 | Saturn Cars & Trucks

1 Answer

Where are the central locking system located in a 1996 opel astra


Hehe that's quite a job , it's just beneath under your left panel and just remove rubbers etc and probably one hook is loose , if not, the motor is dead

Aug 17, 2014 | 1998 Opel Astra 1.7

1 Answer

1996 ford probe passenger electric window no longer works.


you blew the fuse for your radio.you cannot put a hot wire to a ground that is why the fuse blew.you could have broken a wire connector for the door,windows etc.the headlight switch wire harness is probably melted this happens a lot on Ford products,the head light draw so much heat they melt the wire harness plug that goes on the back of the headlight switch.

Jul 25, 2009 | 1996 Ford Probe

1 Answer

I have a 1996 gmc suburban - the front pass door will not open from inside, you can open from outside. How can i replace a broken handle/latch?


Either a piece broke or the pullrod came off. Either way... you'll have to remove the interior door panel to repair.

Jun 10, 2009 | 1996 GMC Suburban

1 Answer

Need Help Putting A Door Handle On A 1996 Dodge Avenger


Start by disconnecting your negative battery cable. Then you need to locate and remove the screws that hold your interior door handles in place (they may be hidden by snap in, or snap on clips). Once you remove the screws that hold the interior door handles, remove any wire connectors to the handles. The interior door panel itself, is held on by snap in clips, and you will need a small pry bar to pull them from the door (try to gat as close to, or directly under the clips to prevent them from tearing out of the door panel). Once the clips are removed from the door, pull the panel upward to remove it from the door. After you gain access to the inside of the door, you will see a area for your new door handle to set in place and operate the door latch. Place your new door handle in place and tighten the nuts that retain it. If has a electronic key code, plug in the electrical connector.

Install everything in reverse.

I hope this helps you, and I wish you luck on your repair.

May 07, 2009 | 1996 Dodge Avenger

1 Answer

Interior door panel


SHoluld be pretty simple. Look for any obvious screw covers, remove. Make sure the handle and switch covers are clear--snap off if necessary being careful not to break, then starting at the bottom, pop off the snap dowels that hold it on. After all is clear all around, lift the panel up and usually more from the back of the door panel. Good luck.

Mar 27, 2009 | 1996 Pontiac Grand Am

1 Answer

Help removing interior door panel/ 1996 Subaru Impreza Coupe


First you remove the small triangular shaped plastic piece that is on top of the door panel by the front of the door by the mirror by simply prying it of. Next behind the door open lever if there is a small plastic cover remove it under it will be a screw. Next your window switch will just pry up and out, disconnect the wiring, under the switch there will be a screw ataching the door panel to the door. Next on the face of the door panel if there is a small cover about the size of a nickle but elongated, remove the cover and remove the screw below it. Next pry the door panel from the bottom untill it "pops" out and grab it and pop the rest of the panel out, lift the panel up off of the window ledge.

Mar 22, 2009 | 1996 Subaru Impreza

1 Answer

How to remove the door panel on a 96 Ford Thunderbird?


Carefully pull front door trim panel finish panel away from front door trim panel.
Disconnect wires from front door lock switches, outside rear view mirror controls and window regulator control switches, if equipped. Remove front door trim panel finish panel.
Remove front door trim panel retaining screw through front door trim panel finish panel opening.
Remove interior lamp lens cover.
Remove screw through interior lamp opening.
Slide front door trim panel upward to disengage hooks.
Rotate top of front door trim panel away from front door and lift bottom hooks from front door.
Disconnect window regulator jumper wire
Remove front door trim panel.

Feb 21, 2009 | 1996 Ford Thunderbird LX

1 Answer

Vauxhall astra fuel gauge problem


Hi,

You appear to have an earth fault, possibly in the circuit for the interior light or the dash. Find any wires within these circuits which are screwed to the chasis , unscrew them and clean the metal work underneath and the lug with emmery cloth or sand paper.

Oct 06, 2008 | 1996 Honda Civic

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...