Question about Cars & Trucks

Open Question

Reset roof fault warning light 2011 gtc - Cars & Trucks

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 5 Answers

SOURCE: Electrict roof warning light aluminates and roof won't rase

The problem is most likely a faulty micro-switch, on the driver's side, under the tonneau cover. Unfortunately, it's impossible to accurately diagnose without a Bentley diagnostic computer, which will have to be performed at a Bentley dealer. As for the windows, the proper way to program the "one-touch" windows is to start with the front. Fully raise the front windows, release the switch, then hold it in the up position for a few seconds (you will hear the door module/window motor click) then fully lower the window, release the switch, and hold it in the down position for a few seconds. This will program the front windows, now do the same in the rear. Low battery voltage will usually cause the windows to lose their programming. You should have the vehicle attached to a Bentley battery tender whenever it is going to sit longer than a few days. The vehicle has 2 batteries, one only starts the car (right-side/start battery), the other (left-side/main battery) runs all of the electronics. Most people think, as long as the car starts, the battery is ok. That is not so with these vehicles. The car will start, even if the main battery is totally dead, or vice-versa. The installed battery tender attaches to the main battery, and comes with a neatly installed wiring harness, and a AGM battery approved battery tender. This will help avoid many different annoying electrical malfunctions.

Posted on Feb 21, 2009

  • 869 Answers

SOURCE: reset brake warning light procedure on a 2007

get it checked by a dealer. may be the barke system have broken down,

Posted on Feb 02, 2011

riceski
  • 1851 Answers

SOURCE: Hi, I have a Bentley

Hi,
Yes it does need to be reset. Try removing the negative battery cable for 30 seconds then replacing it. Also when you do this you will need to reset things like the radio and it will take 20 minutes for everything else to reset automatically.
The easier thing is to take it to the dealer and have them reset it for you this is most likely a free charge item.

Best of it

Gary@FixYa

Posted on Jun 23, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Codes po303, po171, po137. po420


2000 Toyota Corolla, P0171 & P0420 codes - YouTube

? 5:43
https://www.youtube.com/watch?v=ahJnJ19-vwY
Jun 13, 2011 - Uploaded by StandardBrandParts
Standard Motor Products presents: Technician's Toolbox "2000Toyota Corolla, P0171 & P0420 codes"

Smoke testing for codes P0171 P0174 - YouTube

? 5:48
https://www.youtube.com/watch?v=kZsqEfP-5zM
Jan 18, 2011 - Uploaded by realfixesrealfast
These two codes mean a V style engine is running lean on both banks. So you have to be thinking - what can ...

How to repair fault code P0171 and reset warning light ...

? 26:31
https://www.youtube.com/watch?v=Y8FBGrCT3rM
Nov 27, 2014 - Uploaded by Peter Finn
How to repair and fix fault or error code P0171 and reset warning light Toyota Corolla VVT-i engine. ... Also how to find fault codeusing OBD scanner. ... Trouble shooting a misfire, Code P0300, P0301, P0302, P0303, P0304, P0305, P0306, ... 2000 Toyota Corolla, P0171 & P0420 codes - Duration: 5:43. by ...


Dec 02, 2015 | 2005 Toyota Corolla

1 Answer

Why does tire light stay on 2011 Toyota?


Reset the Tire pressure monitoring system light. The reset button is located under the steering side under the finish panel. You have to bend down to see the button.
Operate the tire pressure warning system reset switch only after the inflation pressures of all 4 tires have been adjusted on the vehicle.
To initialize the system, press and hold the tire pressure warning system reset switch for 3 seconds or longer with the power switch turned IG-ON

Jul 23, 2014 | 2011 Toyota Highlander

1 Answer

I have problem with a Bentley Continental GTC and that is that the driver information panel says 'Roof Fault' the error occured after not fully completing a roof opening cycle in one press of a...


If all else fails disconnect the battery for 30 min it will erase all codes on the vehicle for free instead of taking it to a service station and paying them to do it

Jun 28, 2013 | Cars & Trucks

1 Answer

2011 tiguan trailer warning light comes on whenever any trailer is connected


Very first thing you should have done is to check the ground between the vehicle frame and trailer frame. That's the only thing that can be causing this problem. Be SURE the grounds are connected very well. I've found the ground to be the only problem in these situations every time. Can't be anything else, it's all good.

Jul 07, 2017 | 2011 Volkswagen Tiguan

2 Answers

Hi, I have a Bentley Azure 2008. I have opened the roof up and down many times without any problem. Now it has given me a warning that the roof would not have folded correctly - possibly because it was...


Hello and welcome to FixYa!

You may have system failure that's why the indicator light is showing. Please try this trick, remove the positive battery connector and let it sit for at least 5mins. Reconnect the positive battery connector and observe how it goes. This will reset the system and can get rid of the problem.

Hope this helps and thank you for using FixYa! Have a good one!

Jun 22, 2011 | Bentley Azure Cars & Trucks

3 Answers

Is replacing the battery on 2007 Bentley GTC a dealer item only?- due to computer operation faults? Can Autozone preform this?


when you disconnect the battery you may have to do a total reset,(slim chance)NO DISRESPECT TO AUTOZONE but IT IS A BENTLEY..........and if it does need it they havnt got a chance......

Oct 19, 2010 | 2007 Bentley Continental GTC Convertible

2 Answers

Reset brake warning light procedure on a 2007 bentley continental gtc


get it checked by a dealer. may be the barke system have broken down,

Jun 12, 2010 | 2007 Bentley Continental GTC Convertible

1 Answer

Electrict roof warning light aluminates and roof won't rase


The problem is most likely a faulty micro-switch, on the driver's side, under the tonneau cover. Unfortunately, it's impossible to accurately diagnose without a Bentley diagnostic computer, which will have to be performed at a Bentley dealer. As for the windows, the proper way to program the "one-touch" windows is to start with the front. Fully raise the front windows, release the switch, then hold it in the up position for a few seconds (you will hear the door module/window motor click) then fully lower the window, release the switch, and hold it in the down position for a few seconds. This will program the front windows, now do the same in the rear. Low battery voltage will usually cause the windows to lose their programming. You should have the vehicle attached to a Bentley battery tender whenever it is going to sit longer than a few days. The vehicle has 2 batteries, one only starts the car (right-side/start battery), the other (left-side/main battery) runs all of the electronics. Most people think, as long as the car starts, the battery is ok. That is not so with these vehicles. The car will start, even if the main battery is totally dead, or vice-versa. The installed battery tender attaches to the main battery, and comes with a neatly installed wiring harness, and a AGM battery approved battery tender. This will help avoid many different annoying electrical malfunctions.

Nov 23, 2008 | 2007 Bentley Continental GTC Convertible

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...