Question about Cars & Trucks
If ignition fuse okay problem could be the ignition switch.if you turn on ignition switch on no power going to dash lights or starter.
Posted on Jan 15, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
You might need a new cluster .... or it is p[ossible you installed a new stero in the vehichle and one of the wires that were not used from the harness to connect to the cd player may not have been wrapped and are causing a ground.
Posted on Aug 30, 2009
Then 1, bulbs are burned out
OR 2, the wiring is faulty.
Posted on Nov 04, 2009
Testimonial: "thanx for the solution. took the car to a repair shop and was told that the wiring was faulty. had the car rewired."
Did you have the recall done on it ?
recall 05S28. Description: Speed Control Deactivation Switch.
It could be a blow fuse in the recall harness, if you did have it done.
Try the self test, and see what the results are. If you do not get it into self test mode, it could be the fuse in teh recall harness that is blown. The 1st revision of the recall harness was an inline ATM fuse, not sure if the revision 2 was the same. If that fuse is blown, the switch is leaking, and should be checked.
This test is a key on engine off (KOEO) test only that is conducted in park only with emergency brake fully engaged.
1. Enter self-test diagnostics by depressing the speed control OFF switch while turning the ignition key ON, making sure the engine does not start and is not running. The speed control indicator on the instrument panel will flash once to indicate that speed control module entered the diagnostic mode. Five additional flashes at this point indicate a defective speed control servo. Release the OFF switch.
2. Press the remaining switches in this sequence: ON, RESUME, COAST and SET/ACCEL.
If the ON switch is not depressed within five seconds after entering the diagnostics mode, the module times out and the procedure must be started over.
The speed control indicator lamp will flash as each switch is depressed. Press each switch in the sequence immediately after the indicator light goes out for the previous switch.
There will be a slight delay when the last button is pressed and the lamp flashes.
3. A lamp flash with the last button (SET/ACCEL) indicates that the static test passed. If the lamp does not flash with the last button and there are no additional flashes of the lamp, the switch is defective.
If the lamp does not flash with the last button, and additional flashes occur, follow the chart below for trouble codes:
— 2 flashes - BPP defective, circuit is defective, brake applied, CPP switch or jumper (if equipped).
Posted on Feb 23, 2010
Tips for a great answer:
Apr 28, 2013 | Cars & Trucks
Jan 20, 2013 | Cars & Trucks
May 23, 2011 | 2005 Jeep Liberty
Jul 15, 2010 | 1988 Jeep Cherokee
Apr 05, 2010 | 1998 Audi A4
Feb 20, 2010 | 1995 Ford Taurus
Sep 10, 2009 | 2002 Dodge Caravan
Aug 10, 2008 | 1989 Mercury Tracer
Aug 05, 2008 | 1984 Volvo 240 Series
52 people viewed this question
Usually answered in minutes!