Question about Cars & Trucks

Open Question

Mazda 160i bakkie starts well and won't idle after 2 minutes running

Posted by on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 375 Answers

SOURCE: 1997 mazda rustler 160i

sounds like a problem with the air flow system. There should be a MAP sensor that needs to be cleaned. It may only need an air filter as sometimes bugs and dirt can build up inside the housing. Of course if it is a fuel problem and there is no fuel filter and anything is able to get through to the motor you may be giving your injectors a dirty beating that they don't deserve. Get a fuel filter on stat. If you've put new spark plugs and rotor on did you hapent to look at the distibutors points? They should have at least been cleaned and look nice and shiny. Did you gap those plug to specification? There are quite a few things that can cause your particular problems... Wires play big rolls also....

Posted on Jun 24, 2008

Ad
haider_alhar
  • 90 Answers

SOURCE: setting the idling and airflowmeter on the 160i rustler Bakkie 97

first check the sparking plugs because some cylnders may not working propably . then chek the oxygen sensor

Posted on May 31, 2009

dcramer531
  • 1654 Answers

SOURCE: Fuel does not come from

Either your fuel pump has died, make sure you check all fuses and wiring for shorts, or the screen on the pump is clogged and needs to be cleaned. Most likely the pump needs replaced and the t ank will have to be lowered to acces the pump.

Posted on Mar 31, 2011

  • 5370 Answers

SOURCE: starts,idles & runs fine, but won't rev over 2400

This is indication of faulty MAF sensor. Its located on the air inlet, look and the air filter box and follow it to the engine there inline you will see the mass air flow sensor and the air intake temp sensor is built into the mass air flow sensor. when you locate the air filter box you will see the maf sensor its bolted to air box.Make sure the connector is good and also the wiring.Remove the MAF sensor, clean it and recheck.Also try driving without MAF sensor.If its revs fine, then its faulty MAF.------- This should help.Thanks.Helpmech.

Posted on May 19, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Mazda Rustler 160i 1998 Bakkies fuel injectors don't open,What is the problem


First, test fuel pressure as injectors will not open if pressure is low.

Aug 01, 2016 | Mazda Cars & Trucks

1 Answer

What is the problem with my mazda sting 160i 2002 model as soon as i use electrics like lights, wipers etc, the battery runs down. i've replaced battery, regulator and alternator 3 times already. It runs...


remove negative cable from battery, hook up a test light to the negative terminal. opposite end to negative on battery. start pulling fuses, when the light on tester goes out. thats the bad curcuit that is draining battery. wait about 3 minutes before pulling fuses. Good-Day!

May 13, 2014 | Mazda Cars & Trucks

1 Answer

Runs rough dies


change the fuel filter and check the fuel pressure

May 25, 2013 | Ford Expedition Cars & Trucks

1 Answer

Mazda rustler 160i starts idles but when reving or bringing the revs up starts to splatter and jurk and petrol vapour is strong as well as backfire throu intake and when revs are droped throu exhoust. pls....


ck your distributor, the cap and rotor, if all are good ck timing to see if jumped time. if in time and distributor ok ck fuel, and look for vacuum leaks.

Aug 19, 2012 | Mazda Cars & Trucks

1 Answer

Had a question bout my mazda rx8 I was driving it one night it was running fine the next day went out and it won't turn over it takes awhile bit it finally starts and idles real rough and you give it...


Too many possibilities

Won't turn over is one problem -battery,cables,grounds,
starter,solenoid,etc

Idles rough-- vacuum leaks,spark plugs never replaced,
egr valve etc

Worn O2 Sensors
Dirty MAF Sensor
Old Fuel Filter

You have to go into a lot of technical detail & history
on your vehicle, for us to even guess.

May 23, 2011 | 2005 Mazda RX-8

1 Answer

Fuel does not come from the tank on amazda rustler bakkie 160i 2001 model hence the car cannot start


Either your fuel pump has died, make sure you check all fuses and wiring for shorts, or the screen on the pump is clogged and needs to be cleaned. Most likely the pump needs replaced and the t ank will have to be lowered to acces the pump.

Mar 31, 2011 | Mazda MPV Cars & Trucks

1 Answer

My 160i etude 1997 misfires and even mazda agents


it is not carburated injectors are most likley leaking

Dec 15, 2009 | Mazda MAZDA3 Cars & Trucks

1 Answer

Setting the idling and airflowmeter on the 160i rustler Bakkie 97


first check the sparking plugs because some cylnders may not working propably . then chek the oxygen sensor

May 31, 2009 | Mazda 323 Cars & Trucks

2 Answers

1997 mazda rustler 160i


sounds like a problem with the air flow system. There should be a MAP sensor that needs to be cleaned. It may only need an air filter as sometimes bugs and dirt can build up inside the housing. Of course if it is a fuel problem and there is no fuel filter and anything is able to get through to the motor you may be giving your injectors a dirty beating that they don't deserve. Get a fuel filter on stat. If you've put new spark plugs and rotor on did you hapent to look at the distibutors points? They should have at least been cleaned and look nice and shiny. Did you gap those plug to specification? There are quite a few things that can cause your particular problems... Wires play big rolls also....

Jun 24, 2008 | Mazda 323 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...