Question about Suzuki Samurai

Open Question

Suzuki F6a firing order - Samurai Suzuki Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

mrgreenz
  • 962 Answers

SOURCE: my suzuki carry f6a wont idel

Before doing anything else . Check the idle air control valve. It is located at the hole in the fuel system side. It can be removed and cleaned. Or spray cleaned using carb cleaner.After removing the air duct work. With the engine on and running at 1200 rpms or so, spray cleaner directly at some holes in the sides of the hole going to the fuel system. turn off engine and let the cleaner soak into the valve.Repeat process. If that is not the problem. it may be the Idle position sensor, (IPS) it is located near the fuel systen with a plug of a few wires. remove the plug and replace the sensor.

Posted on Feb 20, 2009

emissionwiz
  • 75817 Answers

SOURCE: What is the engine firing order for a Suzuki

firng order is 1-3-4-2 see diagram of distributor cap below.


475948f.jpg

Posted on Jul 23, 2010

  • 270 Answers

SOURCE: engine number of suzuki F6a?

Try checking the engine block. The number is stamped right above the oil pan on the right side of the engine. there is the flat part of the block there. It's a little hard to see, you may need a wire brush to clean it out.

Posted on Jan 08, 2011

  • 2 Answers

SOURCE: ChaJust Need The Fireing Order For A 1999 Suzuki

Hi. If you've got a 1L it's 1:3:2 or a 1.3L it's 1:3:4:2 . Any help ?

Posted on Apr 22, 2011

rabbit7954
  • 417 Answers

SOURCE: the cooling water of my F6a suzuki engine is mixing up to lubricating oil

If your head gasket is good, and you know this without a doubt, then you either have a cracked head/block or your head is warped. There is no other way for coolant to be getting in your oil. Heads aint any fun to take out and mess with but if you can do the work yourself it isn't to expensive to do. As long as your block is good. Good luck.

Posted on Aug 01, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the place of #1 distributor f6a 3cylinder Suzuki multicab?


Hello Christy, 3 posts now.
posted to USA forum
the country that has no such car, nor ENGINE
if fact both are ILLEGALL here.(EPA laws ban them here)
why ask here, ask where F6a are sold. be really 10 x better and 10x faster answers
or buy the shop manual at suzuki in your country?

Feb 14, 2017 | Suzuki Cars & Trucks

1 Answer

How many liters of f6a 12 valve suzuki multicab engine oil


welcome to usa forum .
where are you, , ?
we dont have F6a here.
so asking the oil volume of an F6a engine.
well , put back what came out?
measure it?
or google that engine and pray it pops up?
what car? is this. what year, books are INDEXED by
year
Car name,
engine F6a
and country.
we dont have these cars here.with that engine.
its motor cycle sized to us.







26367550-311i13us0ynxlomdu4i50tnk-3-0.jpg

Nov 22, 2016 | Suzuki Cars & Trucks

1 Answer

Step by step valve adjustment f6a engine suzuki


welcome a USA forum, we dont have F6a here.
no books, no coverage at almighty mitchells, nada
so where are you, in what country
that way helpers can point to sources in YOUR UNSTATED COUNTRY. yah think?>
or set it to 5 thou and be happy?

Oct 17, 2016 | Suzuki Cars & Trucks

1 Answer

My suzuki f6a engine multicab type is emitting a lot of white smoke and smells gas.what could be the probable cause of this?pls advice.


no car stated!
no year.? (the books are in year order)
no country.?
you're on a USA forum and asking about non usa cars?

just an engine, F6A, is it an engine removed from a car?
used for what>? a boat, or ? a go-cart, or some-ting.
is it like these (not one sold here)
must we guess what you are driving?

F6A - 657 cc (40.1 cu in) (65.0 x 66.0 mm). A four-cylinder version (the F6B) was also developed.

1990.03-1994.11 Suzuki Alto / Alto Hustle
1994.11-1998.10 Suzuki Alto HA/HB/HC/HD11
1998.10-2000.12 Suzuki Alto HA12 / Mazda Carol
Suzuki Cappuccino EA11R
Suzuki Cara
Suzuki Carry
1990.07-1998.10 Suzuki Cervo Mode CN/CP21S, CN/CP22S
Suzuki Every
1995-1998 Suzuki Jimny JA12

Feb 18, 2016 | Suzuki Cars & Trucks

1 Answer

Suzuki F6A engine valve clearance adjustment


Posting a non usa car to usa forum, oh,fun....
your not the first.
but but but like you and vast others...
no year?
no car stated?
only an engine on pavement.
is this a test????????


ALL BOOKS ARE BY
COUNTRY
THEN YEAR 1990 to 2013 (wana bet all are not same?
THEN MODEL
ENGINE (f6A got it)
IS THIS HARD TO UNDERSTAND.?

my suzuk online show zero cars.
nada. zip

for
F6A - 657 cc (40.1 cu in) 1990.03-1994.11
Suzuki Alto / Alto Hustle1994.11-1998.10
Suzuki Alto HA/HB/HC/HD111998.10-2000.12
Suzuki Alto HA12 / Mazda CarolSuzuki Cappuccino EA11R
Suzuki CaraSuzuki Carry1990.07-1998.10
Suzuki Cervo Mode CN/CP21S, CN/CP22S
Suzuki Every1995-1998
Suzuki Jimny JA12


zero here
https://suzukipitstopplus.com/Category/3-suzuki-service-manuals.aspx

why not ask your suzuki. IN YOUR COUNTRY
or a forum in your country. and get faster answer.
not one here was answered,

Im in S.america now, 300km from NAZCA.
i google now for you
omg 1st hit. am a the VIP of google, nah.

http://www.suzuki-forums.com/suzuki-carry-every-forum/21746-f6a-valve-clearance.html#post136224


is this your car, ?

using firing order
in turn
at TDC each
cold IN 0.08 EX 0.10 mm
HOT in 0.12 EX 0.12 mm

based on pure rotten internet rumor! (google)

if car as turbo, clearances are different
as can yEAR.
hotter running engines expand more!
so have different clearances.
and diff, years diff. metallurgy.
best it to look up YOUR car in YOur country.
and WIN.

Jan 15, 2016 | Suzuki Cars & Trucks

2 Answers

Step by step tutorial on adjusting valve clearance on suzuki f6a


you get those when you pay for a motorcycle course

May 26, 2015 | Suzuki Cars & Trucks

1 Answer

CAN I HAVE A DIAGRAM OF SUZUKI F6A VACUUM HOSE CONNECTIONS?


in what country, ?
what car?
what year. car.?
vacuum parts vary by , things and boring as SMOG, laws.
each country has there own laws so.....
this is a USA forum and we dont have F6a engines here.
here is a list of cars using F6A.
if it was in USA the under hood sticker shows vacuum map (by law here)

Mar 10, 2015 | Suzuki Cars & Trucks

1 Answer

F6a turbo engines


leaking where.
and carbon where.?
pretend we are blind, (we are)

Feb 05, 2014 | Suzuki Cars & Trucks

1 Answer

What is the firing order of suzuki 3cylinder f6a engine


its stamped on the intake manifold of most suzuki's

Jun 28, 2013 | Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

316 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...