Question about SsangYong Rexton

Open Question

KPBFA2AD13P087934 is the serial number of my Ssangyong Rexton car and has difficulty in pulling when it is put on drive

Posted by on

  • llkelton2006
    llkelton2006 Jan 16, 2013

    The problem is this, when i start the carand shift the gear selector to drive, it takes off but after it change the first time,it doesn't return and once you get to a small hill, the car just stands without moving either to front or to the back. It only takesoff again when you shift the selector to drive 1.

  • llkelton2006
    llkelton2006 Jan 16, 2013

    And before then, the 4WD lights on the board was always on and the 4WD engages without you doing it. We later completely disconected the 4Wd cable.

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 341 Answers

SOURCE: Orange Warning light on dash board check

It means you have a computerized system management problem. An electronic sensor component has either failed, or a condition has occurred that has put a sensor out of normal range and the onboard computer is letting you know of it. Any time that light comes on it sets a code that can be read with a special code reader.Most auto parts stores will retrieve the code/ codes for you at no cost. Be very cautious interpreting the codes meaning, because various engine conditions will set a code as well, because the condition will affect what the sensor measures. If you spend the money for the replacement sensor(never cheap) it won't shut the light off.Once installed auto parts stores will not take it back.Also 90 percent of the time it is defective wiring running to the sensor or bad grounding that causes the codes/codes.So unless you have a ton of high priced testing equipment and a lot of electronic engine control troubleshooting experience,you best take in in for service. One more thing. The most common reason the light comes on is a loose or defective gas cap.The computer monitors that too.

Posted on Nov 30, 2008

bunnydawg
  • 5158 Answers

SOURCE: front diff gone, car making clunking noise on acceleration

go to an empty parking lot

turn the wheel all the way to the right and drive in circle slowly

listen for a ticking noise or similar.

repeat in the left direction.

if you hear a ticking or clicking noise you likely have a bad CV joint. not a horridly expensive repair tho a necessary one

one other thing that will cause it is if the rubber boot surrounding the CV
joint is torn.

pleae take a moment to rate this solution.

robert

Posted on Sep 04, 2009

  • 1 Answer

SOURCE: i have a ssangyong rexton and it wont start it

There's a number of possible reasons.
You don't mention if the engine turns over in the attempt, and you don't say which light is on.
A SsangYong service person can plug in a diagnostic tool to see what error codes are present.

Posted on Jan 26, 2010

  • 1 Answer

SOURCE: ssangyong rexton engine problems

was told from the dealer that it would take around 8 to 12 weeks as there was a back log of parts coming from korea,So went to mercedes to order the part and they said that they were nothing to do with ssyangyong. so went to my local breakers yard and got a starter ring gear from a old mercedes 2.0ltr petrol auto engine and with a small amount of modifacation and three clamps and a eletric drill gun, lay the sourced ring gear on top of your old ring gear match up the large blank spaces,just make sure you sit the ring gear the right way round i.e the way it came off the car as you will see the mating hole dont totaly line up and one is out using your starter ring gear as a template drill out the hole that is out refit the replace ment ring gear to your car rebuild the box.
have done this three times to diffrent rexons now,and to date the cars have had no problems and run great . Ok not the shortes posts but it did not take 8 to 12 weeks to read or write.
part from the breakers yard £15, to drill the part 10 mins , to strip and rebuild the car including going to the yard one 10hrs total cost well thats up to who does the job for you but it not that hard a job to do.

Posted on Jan 13, 2011

  • 1 Answer

SOURCE: cant engage 4 wheel drive on ssangyong rexton 2.7 diesel

ho un problema sul rexton si accesa spia cheak ,cosa devo fare ???????????

Posted on Jan 02, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

La voiture n'accelere pas


2007 SsangYong Rexton 270
translate only
The car does not accelerate
It does not exceed 20 km / h and even the sound of the engine does not change

Apr 10, 2016 | 2007 SsangYong Rexton 270

1 Answer

Engine belt diagram ssangyong rexton


look under the hood for diagram....

May 27, 2014 | 2005 SsangYong Rexton

1 Answer

Wher ar the chassis number ssangyoung rexton


It is right behind the front left wheel. Turn the wheel to the maximum left and look behind it

Apr 15, 2014 | 2005 SsangYong Rexton

1 Answer

I need a rack end for a 2005 rexton 270d. There appears to be a major issue with parts !!


check out the "Ssangyong owners club of Australia" and you will find various suppliers who can assist you !!

Mainey

Nov 24, 2013 | 2005 SsangYong Rexton RX

2 Answers

After changing fan belt on my 2005 sangyong rexton the vehicle is not moving smooth?


go to www.automecanico.com and translate this website amazing with your browser and fix it.
God bless you

Jul 23, 2013 | SsangYong Rexton Cars & Trucks

1 Answer

Ssangyong rexton 2.9


Simple... unbolt the headlight assembly or you can just unplugg the harness and then just unscrew the bulb. it should have three metal spokes sticking out, screw the new bulb... all the best

Mar 06, 2013 | 2005 SsangYong Rexton

2 Answers

Where is the oils filter located on a Diesel Sangyong Texton 2005 Merc DXi270


The oil filter for the diesel Rexton is behind the engine block on the passengers side. If you remove the plastic engine cover and stand next to the passengers mirror, you will see the casing next to the firewall.

Aug 17, 2012 | 2006 SsangYong Rexton 270

2 Answers

I have a ssangyong rexton and it wont start it just has an orange light with checked on it what could it be


There's a number of possible reasons.
You don't mention if the engine turns over in the attempt, and you don't say which light is on.
A SsangYong service person can plug in a diagnostic tool to see what error codes are present.

Jan 24, 2010 | 2000 Chevrolet Malibu

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top SsangYong Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

terry stevens

Level 3 Expert

991 Answers

Are you a SsangYong Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...