Question about 1992 Nissan Pathfinder

Open Question

1992 nissan pathfinder daytime running lights won't work

Headlights work, high beam on left side doesn't work and daytime running lights don't work even though I just put in new bulbs.

Posted by Anonymous on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

wireguy212
  • 1627 Answers

SOURCE: 2002 pathfinder, the left headlight bulb does not work when the

Sounds like you need a bulb,the daytime running lights send power to the high beam wire so they look like low beam lights are on but really they are high beam lights running on low voltage.

Posted on Nov 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Daytime running light module location 2001 impala


The daytime running lamps in your 2001 Chevrolet Impala are controlled by the Body Control Module (BCM) Here is a description of how the system works:

The ambient light sensor is a light-sensitive transistor that varies its voltage signal to the Body Control Module (BCM) in response to changes in the outside (ambient) light level. When the BCM receives this signal, the BCM turns ON either the DRL or the headlamp relay for auto headlamp operation. Any function or condition that turns ON the headlamps will cancel the DRL operation.
Thirty seconds after you start the ignition with the headlamp switch set in the OFF position, the DRL will perform one of two actions:

Illuminate the high beam headlights at a reduced intensity in daylight conditions
Illuminate the low beam headlights in low light conditions
The DRL/EXT lamps fuse in the top of the engine fuse block supplies battery positive voltage to both the DRL switch contacts and to the DRL relay coil. When the BCM energizes the DRL relay coil, current flows through the right high beam lamp, to the left hand high beam lamp, to the energized DRL relay switch contacts, to ground G101.
The high beam headlamps are now in series, and split the voltage so that the headlamps illuminate at halt intensity. The DRL operates when the ignition switch is in the RUN position, and the parking brake is not set or the transmission is not in park. When these conditions have been met and the ambient light sensor indicates daytime conditions, the DRL will illuminate.

Oct 10, 2011 | 2001 Chevrolet Impala

1 Answer

When I click the headlights to bright all of the lights go out. I have already replaced the switch in the stearing column. What is wrong.


Try disconnecting one of your headlights and click on the high beams. If it goes to high without any other problems, then the problem is in the other headlight high beam circuit. If all the lights go out, then the problem lies in the high beam circuit of the headlight you disconnected. You can verify this by reconnecting the first headlight and disconnecting the other one. There is most likely a short to ground in one of the high beam circuits.

If you have daytime running lights. That is, your headlights stay on automatically. You will need to check the daytime running light relays. There may be four of them to check. One of them grounds the high beams.

Jan 30, 2011 | 1992 Toyota Pickup

1 Answer

2002 pathfinder, the left headlight bulb does not work when the


Sounds like you need a bulb,the daytime running lights send power to the high beam wire so they look like low beam lights are on but really they are high beam lights running on low voltage.

Nov 19, 2009 | 2002 Nissan Pathfinder

1 Answer

Headlights alternate on and off left and right daytime/high beam


although the underhood relay panel is common, I'd check your headlamp bulbs first, these are cheaper than the fuse box. The daytime running lights work off the high beam circuit, thus, a blown highbeam bulb could be the culprit, the fusebox solution was more common on 2001 and up modles, although it's a definite possibility.

Feb 18, 2009 | 2000 Dodge Caravan

2 Answers

95 pathfinder only 1 headlight comes on both bulbs good


im a mechanic who owns a1995 pathfinder, had the same problem.your trouble is in your daytime running light module. try giving it a tap, bet they will come back on

Jan 08, 2009 | 1995 Nissan Pathfinder

3 Answers

Low beam headlights do not work, but high beam headlights do


Clyde,

I've been troubleshooting this same problem on a different vehicle this week, and I can give you the steps I'd take.

1. If both sides went out at the same time, the problem is *NOT* likely to be the bulbs.

2. Check the fuses to see if both low beam lights are on the same fuse. Many cars have one fuse for low beam and another for high beam, so both lights out at the same time typically means fuse blown.

3. If the headlights are OK and the fuses are OK, then the problem is *LIKELY* the headlight switch. In my case, AutoZone has one and it can be installed easily; but in your case, that may not be as simple.

Please post your findings or comments.

Jul 16, 2008 | 1991 Nissan Pickup

Not finding what you are looking for?
1992 Nissan Pathfinder Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...