Question about 1997 Dodge Intrepid

1 Answer

Dodge intreped no start

No spark, has fuel ,no codes. new coil, new crank and cam sensor changed the pcm. and it still wont start whats the problem?

Posted by on

  • 1 more comment 
  • Anonymous Jan 27, 2009

    I have the same problem.My husband buys vehicles cheap and I usually get them running pretty quick for us to drive but I am at a loss with this car.I have cahanged the cam sensor,crank sensor, pcm,and my coil checked out to be fine. I checked all my relays Tomorrow I will brainstorm again but could really use some help on this problem

  • Tina Anderson Mar 15, 2009

    I have the same problem. Where is the asd under the hood?

  • aprylll Mar 17, 2009

    My battery hit the hood when I went over a bump and shorted out the whole engine. I have replaced the coil, the harness and the brain and it still wont start....any suggestions?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 141 Answers

Have you checked the Automatic Shutdown Relay (ASD) under the hood?

Posted on Jan 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 2001 dodge neon cranked without the cam sensor connected. what's wrong with this picture?


Changing the Cam Position Sensor on Dodge Neon ...

? 10:33
https://www.youtube.com/watch?v=ciCPQ0kVAQY
Dec 21, 2012 - Uploaded by VeeTheAmazingGreek
... had to change out the cam position sensor on my 2001 Dodge Neon. ... 1997 Dodge Neon no start, crank sensor problems - Duration: 26:53.

Dodge Neon Questions - It will turn over but has no spark ...

www.cargurus.com > Questions > Dodge > Neon

CarGurusAug 9, 2015 - I did have a neon while ago and image crank sensor was bad ... my 1999dodge neon has no spark it will turn over but not fire i have changed the crank sensorcoil ... I have a 2001 Dodge Neon 2.0 with 140,000 kms on it.

Dodge Neon Questions - 2001 Dodge Neon will turn over ...

www.cargurus.com > Questions > Dodge > Neon

CarGurusJan 7, 2013 - I have a 2001 Dodge Neon 2.0 with 140000 kms o... ... went about a month before this recent problem, fixed that with no problem now this. ... firing. you said you replaced the cam sensor, did you do the crank sensor as well? ... My 1996Dodge Neon won't stay running whenever I take my foot off of the gas.

Starting Issues and Trouble Code Due to Defective Cam ...

repairpal.com > Problems > Dodge > Neon

Feb 05, 2016 | 2001 Dodge Neon

1 Answer

Wont start. it has injector pulse but no spark


is there power and ground to the coils?

If there is injector pulse than the crank sensor has to be good. Injector pulse and spark are both calculated off from the signal from the crank sensor.

Checking for power and ground to the coils is a good place to start. If that checks out than either there is a wiring issue in between the PCM and the coils or possible the PCM has failed.

Nov 20, 2015 | 2001 Pontiac Firebird Trans Am

1 Answer

So... I'm starting to get just a bit frustrated... after installing the new PCM, my dodge avenger, 96 2.0L ran for 5 days then went out again, fuel pump works and I've got spark but no start..


after all that work its terrible that something else goes bad however since you do get spark and fuel i would say crank or cam sensor but then if one of those goes bad it wont allow engine to turn over and would shut fuel pump off. so there is only one thing left to cause it you have a short in the harness somewhere maybe just a lose connection on the cam or crank sensor put dieelectric grease in all your connectors

Apr 03, 2013 | Cars & Trucks

2 Answers

It turns but it wont start,it has gas and power


Pull off the coil ignition cable at the distributor and check for spark coming out of coil when cranking engine over. Use a heavy rag or glove to hold the wire 1/4 inch from a metal ground. Should see a strong blue spark when cranking to verify ignition is good. If no spark, check for battery voltage to coil on the coil primary. If you have current to the coil, suspect a bad coil, ignition module, crank position sensor, or cam position sensor, or pcm. The coil, ignition module, and sensors can be tested before replacing.

Jan 29, 2013 | Cars & Trucks

1 Answer

3.3 dodge caravan spark cuts off pcm coilpack cam and crank sensor have all been changed all wires are fine and spark still cuts off


Cam and crank sensors must be gapped right. The hold down is sloted so it can be moved closer or further away. New sensor should have come with a small felt pad on the end. Push the sensor in until it stops. If the gap is to much you may get an internmitent spark. ( I have also gotten bad cam sensors right out of the box)

Jan 23, 2013 | Cars & Trucks

2 Answers

Please help me please need it real bad please 2003 dodge neon wont start even tho i changed all the sensors and the computer brain as well car will not stay crank it shuts off took to the dealer dodge


if you replace pcm the dealership has to reprogram new pcm , tcm and reprogram theft security system before car will start again.any time you replace pcm on any newer vechicles the odb 2 generation pcm control vechicles the new pcm, has to be reprogrammed.

Nov 25, 2011 | 2003 Dodge Neon

1 Answer

1999 Dodge Ram 2500 P/U 5.9L Gas V8 Standard cab Auto transmission 4x4 @ 38K miles. Started and ran January 10,2010 but will not start anymore. Tried Starting fluid down the throat of the carb - nothing....


This could be a number of things...
Crank sensor, cam sensor, coil, PCM, spark control module, ect.
Start with the sparkplugs, make sure they are firing if not work your way back from there spark pligs, wires, coil, control module, cank and cam sensors, PCM this is what i would do if this rolled into my shop.

Jul 18, 2010 | 1999 Dodge Ram 2500 4WD

2 Answers

1999 dodge caravan new pcm new crank and cam sensor new coil pack new flexplate still no spark, scannner show sync problem, any ideas


If you have replace new cam sensor with no sparks and the coil are good putting out 12 volt, my guess would be the computer it self faulty. cam sensor sense the cam turning and send info to computer telling computer to disperse the charge from the coil pack to the plugs assuming relay, cam sensor, coil, plugs, and wires are good. make sure the cam sensor is put in properly and position.

Aug 28, 2009 | 1999 Dodge Caravan

1 Answer

My s10 will turn over, but wont squirt gas through injecter


Does it crank? Do you have any codes? Check engine light? Do you have spark? No spark check coil, and connections, also it would be nice to know what year it is. Get codes read. No crank check battery and starter. No codes or lights check crank position sensor, make sure your pcm is good after replacing your ignition mod you could have blown it if you did do it right. (engine computer) Check cam sensor if applies. Crank and cam could prevent it from starting and I know one I think cam controls pcm's fuel delivery on gm's

Dec 30, 2008 | 1986 Chevrolet S-10 Blazer

Not finding what you are looking for?
1997 Dodge Intrepid Logo

Related Topics:

298 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...