Question about 2003 Volvo S60
Posted by Anonymous on
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: check engine light code PO442
You likely won't notice any drivability problems. P0442 indicates a fuel vapor leak in the EVAP control system. It means a very small leak has been detected. In fact, the leak can be from a hole as small as 0.04" in diameter.
The (EVAP) emission control system prevents the escape of fuel vapors from a vehicle's fuel system. Fuel vapors are routed by hoses to a charcoal canister for storage.
Later, when the engine is running a purge control valve opens allowing intake vacuum to siphon the fuel vapors into the engine.
With a P0442, the most common repair is to Remove and reinstall the gas cap, clear the codes, and drive for a day and see if the codes come back. Otherwise, replace the gas cap, or Inspect the EVAP system for cuts/holes in tubes/hoses.
Good luck and hope this helps
Posted on May 07, 2009
THE 445 IS THE EVAP PURGE VALVE IT MAY BE BAD BOTH 446 IS SAME VAVLE YOU NEED TO SEE IF THE HOSE ARE GOOD ON THIS VAVLE MAKE SHERE NO CRACKS IF NOT PULL HOSES AND SEE IF SOMTHING IN VAVLE ITS NEAR THE CANSTER AND THAT IS NEAR THE GAS TANK UNDER CAR PUT CHECK GAS CAP MAKE SHERE ITS TIGHT HOPE THIS HELPS
Posted on Sep 15, 2009
SOURCE: CODE 042 ON A VOLVO S60
Brake lights and cruise control are not set properly.
Easy check - are your brake lights coming on with just the usual light touch of the pedal? If not, then the microswitch that senses that your foot is on the brake needs to be adjusted or replaced.
Posted on Sep 22, 2009
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well
Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
Posted on Nov 04, 2009
Tips for a great answer:
Feb 07, 2016 | 2003 Volvo S60
Aug 04, 2015 | 1998 Honda Accord
Oct 12, 2012 | 2001 Volvo S60
Sep 06, 2012 | Volvo Cars & Trucks
Feb 06, 2011 | 2003 Volvo S60
Oct 29, 2010 | 2003 Volvo S60
Apr 09, 2010 | 2003 Volvo S60
Sep 15, 2009 | 2002 Volvo S60
Aug 01, 2009 | 2002 Volvo S60
86 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: