Question about 2001 Chrysler Sebring

1 Answer

Transmission why doesnt move my car when i shift from P to D , or R , just RPM goes High to 1500 and back to 1000

Posted by on

  • saya_f2000 Jan 24, 2009

    i fond obd cod>> P1751 Shift Solenoid #1 (SS1)

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,498 Answers

Hi saya,

An automatic transmission will do exactly that if it's low on fluid.

To check the level, have the car running. Have a rag available. A long snouted funnel and a couple quarts of transmission fluid.
Find the dipstick for the transmission
Pull it, wipe it, put it back in, pull it again.
Check the level at the end of the stick.

If it's low or not showing at all add a quart. Keep doing so until the proper level is reached.

Hopefully this will solve your problem. If it does not, I'm sorry to say that a transmission repair professional may be your next option.

Keep in mind, you described your problem in a single sentence. That is all I had to work with. If there are additional symptoms that may be applicable, that could change things. Check the fluid and hope for the best.

Mike

Posted on Jan 24, 2009

  • Justin Case
    Justin Case Jan 24, 2009


    • Check the fluid level as described

    • Then re-check the diagnostic codes.

    If the solenoid code remains, the solution requires the opening of the transmission and a significant expertise in transmission repair. Without the specific training, even skilled mechanics consider repair on automatic transmissions to be one of the 'Black Arts' and will refer the job to a pro. I have to give you the same advice.

    The good news is, of all the things that can go wrong, the cost of this item is on the low end of the scale.

    Mike

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Toyota corolla 1998 not moving in the morning


i crank car.
it starts, engine idles at 1000 to 1500 rpm cold. good
it don't misfire or shake (tuneups work)
i shift in to gear. Drive. or reverse.. car dont move
i step on gas, and RPM goes way high and car will not move.
there is my guess. correct my errors.
or post yours.

Jan 12, 2014 | 1998 Toyota Corolla

1 Answer

Rpm drop speed remains loud noise


problem with transmission. go to www.aa1car.com and fix it.
God bless you

Jul 18, 2013 | Cars & Trucks

1 Answer

2004 Lincoln aviator goes into gear but won't move


bad transmission maybe. Try going into a lower gear (2 or 1) and giving it a little gas and holding it there. (about 2500 rpm) Hold it there for about 30 seconds.
If it still doesnt move, look under at the side of the transmission where the shifter cable connects and make sure it is moving.
Make sure the brake is on and the wheels are blocked and have a friend shift it back and forth while you look.
Sometimes, the connection pin comes out and you wont shift. .
If it does move right away, head to the transmission shop.

Dec 30, 2012 | 2004 Lincoln Aviator

1 Answer

2003 chevy 1500 truck shifts at a high rpm and doesnt go into overdrive on the highway


4l60e transmision burnt clutchs in fourth gear ! is there a light on if so check it if it says silonaid change the it . if the atf is black just have it rebuilt

Nov 16, 2012 | Cars & Trucks

1 Answer

Problems shifting into overdrive in my 96 chevy 1500 4x4


i have a 90 chevy 2500 2wd 350ci.when i go to start my truck the key turns hard in the ignition,the check engine light and brake light come on the heater dont work,and the transmission will shift from 1-2 at real high rpm and shift hard,no 3-od.this comes and goes,but all happens at the same time.some times it last for 10 min,sometimes its days.what is going on?

Apr 24, 2012 | 1996 Chevrolet K1500

2 Answers

My transmission wont shift properly rpm goes up too high


sounds like the clutches are slipping or you have a bad seal in tranny, which wont allow it to keep pressure. have you changed the fluid and filter?

Aug 16, 2009 | 2003 Chevrolet Silverado 1500

2 Answers

WHEN YOU PUT THE CAR IN DRIVE IT WILL NOT GO ANYWHERE


Its the electronic shift control located just under the battery ontop the transmission replace or repair will solve the issue

it'll go into drive but once it reaches 1500 rpm it'll drop into neutral as a safety because at this rpm it is being told to shift gear and when it fails to do so it safely goes into neutral

it will go into reverse just fine and park and you can run all the low drive gears until you reach 1500 rpm then it'll cut it off

i pulled mine out re soldered bad components on the board to fix it but im an electronics engineer it may be easier for you to just replace it

Aug 09, 2009 | 1995 Dodge Avenger

1 Answer

97 Ram 1500 over revving until hitting 45 mpm


It sounds more like a cable or linkage sticking, and yes it is transmission related, sort of, just because of the high RPM before shifting. Spray all your cables good with lube, at throttle linkage, and get under and look where cable & linkages are at side of transmission, and spray them good too, and work them back & forth, to try & loosen them up. Truck shut off & in park when under it eh.!
Then work shifter back & forth, gas pedal to floor & up etc, to try & loosen things up. That may just cure your problem.

Apr 25, 2009 | 1997 Dodge Ram 1500 Club Cab

Not finding what you are looking for?
2001 Chrysler Sebring Logo

161 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...