Question about 1999 Chevrolet Astro

1 Answer

IGNITION HAS TO BE TURNED JUST RIGHT SO THE CHARGING SYSTEM WORKS PROPERLY .STARTER SOLENOID CLICKS BUT WILL NOT STERT

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 87 Answers

Replace the ignition switch and if your key is worn out you may need a lock cylinder and new key cut from the vin number, check the battery to may be bad

Posted on Jan 15, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
alicantecoli
  • 22156 Answers

SOURCE: 1997 Chevrolet Z71 Pickup (intermittent start)

saved me the job of answering ,which would have been the same

Posted on Nov 22, 2008

  • 1 Answer

SOURCE: camaro wont start

send me more info about your car,year,and motor size. if it is the starter clicking then check the red heavy wire between the battery and the starter. nickyjam770@hotmail.com add me

Posted on Dec 26, 2008

  • 24 Answers

SOURCE: entire 1996 blazer electrical dies when starter solenoid engaged

bad ground cable,use a jumper cable from negative to alternator bracket, if it starts thats it.

Posted on Feb 07, 2009

  • 744 Answers

SOURCE: starter will not turn with ignition key

some are fused and has relay. check fuse and relays. replace with the same type, you could try to interchange the relays if they are of the same type.

Posted on May 25, 2009

  • 3 Answers

SOURCE: ignition switch not working

Probably switch, then, or the column.

Posted on Nov 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

03 for explorer not starting turn the key have full power hear klicks from distribution block but no crank


The starter solenoid is mounted on the starter. Clicking from the distribution block must be the starter relay. Swap in another relay from the block into that socket to see if the relay is the problem.

Nov 24, 2013 | Ford Explorer Cars & Trucks

2 Answers

1986 ford f350 won't start


The solenoid click sounds very strong, implying that you have a charged battery and the ignition circuit is functioning out to the solenoid. Suspect an issue with the starter motor. Is the starter motor installed and connected properly?

Aug 11, 2013 | Cars & Trucks

2 Answers

1999 Subaru Forester starting problem


You either don't have power to solenoid or solenoid is bad. Disconnect solenoid power from ignition and check for power there using a light or a multimeter. Connect battery to the starting terminal and to ground. Turn ignition on go to start position. Light should ncome on. If not checl that circuit backwatds. If on then jump solenoid with a wire from battery positive. If OK it should click and start. If not check starter brushes and solenoid.

Jan 16, 2013 | Cars & Trucks

2 Answers

2001 jeep cherokee sport will not crank


But those are ignition parts. If the car won't crank, there is a problem between the battery, ignition switch, and the starter.
Try this, Darren: With key on, does your dash light up, gauges working and check engine light on? Turn key to start. Do you hear a click form the area of the starter? If you hear the starter solenoid click, and you know the battery is charged up good, then likely the starter is out, and needs to be taken off for testing or replacement. But that is assuming that the battery cables and their.connections are good and allowing full battery power to the starter.
If you hear no click in start, turn the headlights on and watch their intensity while someone turns key to crank. If the lights dim noticeably and no cranking, then the starter is bad or needs testing. If the lights don't change intensity when key is at crank position, then possibly the starter solenoid is bad or the circuit from ignition switch to the starter solenoid is not allowing current to pass. Take off the small wire (brown, I think) from the starter solenoid and see if it has power when key is in crank position. If it has power, the starter has to come off-it or the solenoid is bad. If no power on the solenoid wire with key in crank, then the circuit from ignition switch to the solenoid will have to be checked. There are at least a couple of components in that path- one is the starter relay, another is the neutral safety switch (or clutch switch on manuals). Also if no power on the solenoid wire, check the 30 amp fuse in the power distribution center by the battery. It may be fuse # 10, at least it is on a '97 Jeep. Heck, check all your fuses while you're at it.
Good luck.

Jun 02, 2012 | Jeep Cherokee Cars & Trucks

1 Answer

Car doesnt want to start. all lights come on when in the on position however when I turn it to start nothing happens it dont even try to turn over it just clicks 2002 hyundai xg350


The starting system consists of:
  • starter motor
  • starter switch, part of the ignition switch
  • starter motor solenoid relay switch
  • starter solenoid
  • starter drive
When you turn your key to start your engine, it just clicks, right? If so, more than likely this is due to a bad battery. Even though your battery may appear to be fully charged, it may have a dead cell, or worse. If you get a jump, does the vehicle start? If so, replace your battery.

Possible sources of the problem if the engine does not crank or the relay clicks:
  1. Battery
  2. Starter motor
  3. Starter motor relay
  4. Ignition switch
  5. Damaged fuse
  6. Anti-theft system
  7. Circuitry

Mar 16, 2011 | Hyundai XG350 Cars & Trucks

3 Answers

I try to start my truck up which is a 2003 ford expedition and it makes a ticking noise! well i jus changed the starter and its still making that noise. could it be the alternator or whats the problem?


The starting system consists of:
  • starter motor
  • starter switch, part of the ignition switch
  • digital transmission range (TR) sensor (automatic transmission-equipped vehicles)
  • starter motor solenoid relay switch
  • starter solenoid
  • starter drive
When you turn your key to start your engine, it just clicks, right? If so, more than likely this is due to a bad battery. Even though your battery may appear to be fully charged, it may have a dead cell, or worse. If you get a jump, does the vehicle start? If so, replace your battery.

Possible sources of the problem if the engine does not crank or the relay clicks:
  1. Battery
  2. Starter motor
  3. Starter motor relay
  4. Ignition switch
  5. Damaged fuse
  6. Anti-theft system
  7. Circuitry

Mar 16, 2011 | Ford Expedition Cars & Trucks

2 Answers

I just replaced my ignition system and starter now i go to start it and it makes a weird clicking noise and wont start whats wrong?


Make sure you have all the wires right.The clicking is your starter not engaging.Was the starter new?Did you bench test the starter before installing it?

Feb 19, 2010 | 1992 Ford Explorer

3 Answers

Vehicle will click but not start, tried juming still clicks , only 10000 original milesany suggestions


Assuming your battery is properly charged and has a good connection, it's your starter solenoid (relay) that has failed.

The starter solenoid receives a large electric current from the car battery and a small electric current from the ignition switch. When the ignition switch is turned on, a small electric current is sent to the starter solenoid. This causes the starter solenoid to close a pair of heavy contacts, thus relaying a large electric current to the starter motor, which in turn sets the engine in motion.

If a starter solenoid receives insufficient power from the battery, it will fail to start the motor, and may produce a rapid clicking or clacking sound. The lack of power can be caused by a low or dead battery, by corroded or loose connections in the battery cable, or by a damaged positive (red) cable from the battery. Any of these problems will result in some, but not enough, power being sent to the solenoid, which means that the solenoid will simply make a clicking sound, rather than setting the starter motor in motion.

If these items are all okay, it is likely you need to replace the solenoid.

Jan 10, 2010 | 2004 Ford Econoline

Not finding what you are looking for?
1999 Chevrolet Astro Logo

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...