Question about Cars & Trucks

Open Question

HYSTER CODE 524213 3

CRANKS RUNS FINE FOR 10 SECONDS SHUTS DOWN

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

polarcycle
  • 1392 Answers

SOURCE: starts and runs 3-5 seconds and shuts down

Sounds like your security system is shutting the car down. You should be able to leave the key on for 15 minutes and it will reset itself. Make sure you are using factory keys, and they are in good condition.

Posted on May 28, 2009

matney68
  • 426 Answers

SOURCE: Strats but then shuts down.

there is no code its in the key. they sometimes will lose the required resistance.
there is a reciever for the signal on key in ignition and in the key.do you know if this is the type you have?

Posted on Aug 14, 2009

tragedy lok
  • 266 Answers

SOURCE: Engine cranks slowly and barely starts

fuel problem?timming?tune up?

Posted on Aug 25, 2009

BeninVa
  • 389 Answers

SOURCE: my o2 silverado 4.8l just started to start really

This might help also, mine did the exact same thing after a careless dealer mechanic loosened the air filter cover during a safety inspection and forgot to tighten it back. After I tightened the screws on the cover it went back to starting normally.

Posted on Dec 16, 2009

  • 148 Answers

SOURCE: truck won't crank & run when hot

The PMD ( pump mounted driver) black box on the side of the injection pump is shutting down when it gets hot, Best to replace entire injection pump for warranty purposes> repair should be made by qualified diesel mechanic as the **** timing has to be set with scan tool after replacement

Posted on Jan 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Does DTC B0092 disrupt engine idle running? engine cranks and runs for just 3 seconds, then shuts off itself, with ignition still on.


The "B" represents a body code and I wouldn't think it would shut down the engine. I would google the code and see just what it is for. Hope this helps.

May 17, 2017 | Cars & Trucks

1 Answer

WHAT DOES FAULT CODE 676-4 REFER TO?


WHAT DOES FAULT CODE 676-4 REFER TO? - Fixya

www.fixya.com/cars/t25801863-fault_code_676_4_refer
Jul 30, 2015 - ... 676-4 REFER TO? HYSTER FORKLIFT 3.0 FORTENS ENGINE 3STAGE WITH SIDE SHIFT FAULT CODE 676-4 - Cars & Trucks question.

FORKLIFTACTION.COM (Forklifts) - Site Map - List all forum ...

www.forkliftaction.com/sitemap/forums.asp
Find forklift manufacturers, dealers, suppliers and other lift truck ... What do we know about the PSI 2.0L and 2.4L engines? .... nissan platinum error codes. ..... what have change do I all to go at hyster forten truck of montrol pendaal to ..... Raymond EASI - NO reach, tilt, or sideshift. ...... Hyster 5.5FT fault code 676-4 [view]

Jul 30, 2015 | Cars & Trucks

1 Answer

My 1995 mercury cougar xr7 in the morning the fuel pump runs along time like a couple of minutes befor it shuts off so it will crank,but 5 hours later it cranks up fine.what is the problem?


Can you be more clear? The pump only runs for 2 seconds until the engine starts cranking and then it stops immediately when cranking stops.

Aug 17, 2013 | 1995 Mercury Cougar

1 Answer

Engine cranks for 8-10 seconds before it starts when engine is warm


you must RUN the SCANNER/computer for better diagnostic and fix it. YOu can have some faulty like: PCM+BCM+ignition coil, sensor, etc. see the diagram attached.
God bless you225004b9-8d42-483d-a0e8-ee6550772ecc.jpg8c2fbe48-c384-4953-ac1d-abce3867e5a4.jpg

Jul 27, 2013 | 2000 Chevrolet Astro

1 Answer

Poor idling


Coils,fuel filter,dirty throttle body.

May 11, 2013 | Cars & Trucks

1 Answer

1994 ford ranger runs fine until i go to town then just shuts down but will crank over and fuel is getting to it


check ignition pick up its in the distributor. its responsible for spark in the plugs

Dec 04, 2012 | 1988 Ford Ranger

2 Answers

Truck won't crank & run when hot


the TPS senser is bad its on the injecter pump or you have a bad crank shaft sonser

Jan 31, 2010 | 1994 Chevrolet C3500

1 Answer

Strats but then shuts down.


there is no code its in the key. they sometimes will lose the required resistance.
there is a reciever for the signal on key in ignition and in the key.do you know if this is the type you have?

Aug 14, 2009 | 1999 GMC Yukon

1 Answer

1985 chevy Blazer cranks up, runs rough, then


have you checked, cady, fuel tank, is it getting the right amount of gas and air? plugs and wires, go with general mantinence first then step up. i have a 85 s10 blazer that was a lemon off the lot but has over 300000 on it and it has the same prob i fix it tempurary by flipping the lid on the breather upside down so it gets more air

Mar 12, 2009 | 1985 Chevrolet S-10 Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

372 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...