Question about 2006 Kia Sorento

Open Question

Back window kia sorento

I just purchaed an 06 Sorento, but can't figure out how to open the back window.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: kia engine codes

I f you dont have a code reader try disconnecting the neg (black) side of the battery and let it stay for about 10 min this should re boot computer

Posted on Jul 18, 2008

  • 4 Answers

SOURCE: crankshaft sensor for 2004 kia sorento

The above information about the sensor being located at the top of the motor to the passenger side of center is bogus. That is only the pig tail plug in. The actual sensor pig tail continues down below, underneath the plastic lower timing belt cover, on the front of the motor, just above the crankshaft timing gear.

It is a very involved process of removing and replacing. You will have to remove all of the belts, the front timing belt covers, (upper and lower). You will also have to remove the front bracket that is mounted to the front of the block, which serves as the mount for the power steering pump, the alternator and the A/C compressor.You will also have to remove the crankshaft pulley. You cannot remove the plastic lower timing belt cover unless you remove all of these things first. The sensor is located underneath the lower cover. It has two bolts that hold it in place. You will have to remove these two bolts.

The crankshaft pulling bolt is a right handed thread and loosens by turning counter clockwise. The pulley will slip off but is a very tight fit. Do not try to turn it while removing it as there is a small pin that keeps it aligned to one position. Use a small ball pine hammer to tap it loose.

It is also a good idea to remove the electric cooling fan shroud that is mounted to the inside side of the radiator and the radiator hoses to give yourself more room to work. It has only two bolts at the top holding it in place. And then slips into two retaining clips at the bottom. Lifting it will pull it out of these retaining clips.

When you remove the small bypass hose located at the top of the radiator , to the passenger side, be careful not to break off the small nipple protruding out of the radiator tank. It is plastic and will break easily if you try to pull the rubber bypass hose from it. This will have to be taken to a radiator shop to have repaired if you accidentally break this off. Be sure to carefully loosen the hose from this nipple before trying to pull it off.

And one more thing, if you go to that much trouble to replace this sensor, it is a good idea to go ahead and replace the timing belt as well. It is a maintenance item and you will have to go through the same process to replace it as well. Do it once and do it all.

I hope this helps.

Posted on Nov 15, 2008

  • 1 Answer

SOURCE: kia sorento, 2004. clock and airbag warning light

You may have a fuse problem.

Posted on Jun 02, 2009

  • 1 Answer

SOURCE: 2006 Kia Sorento Brake Lights not working

Apparently this is a recall matter and will be fixed at no charge. KIA Consumer Assistance Center 1-800-333-4542. Recall notices were to go out in May/June 2009.

Posted on Jun 17, 2009

bschilz
  • 2049 Answers

SOURCE: Hi is there an OBD ll connector in a Kia Sorento

Yes, it's locaqted just above and to the right of the brake pedal. Here is a link to a phot showing you what to look for...
http://www.obdclearinghouse.com/documents/newdocuments/kia/sorento/2005_kia_sorento.jpg

Posted on Sep 13, 2009

Testimonial: "Super Thanks"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2011 KIA Sorrento 2.4 were is the fuel pressure regulator located. put on adjustable fuel reg .need to disconnect stock one


fuel pressure regulators are normally located in the fuel manifold. They are either vacuum controlled or electronic controlled to maintain the right fuel pressure for engine requirements and to shut off the fuel pump when the ignition is turned off
If your manually adjusted unit will not do all that then you are asking for fault codes to appear and all sorts of problems to occur

Jan 18, 2016 | Kia Cars & Trucks

1 Answer

KIA SORENTO RIGHT RIGHT FRONT DOOR WINDOW OPENER DOES NOT OPERATE PROPERLY


the switch is bad or lose. can it be opened from both the driver side and the passenger side controller? One switch may be bad and not the other or if both switches are good than it is in the wiring to the power window or motor.

Apr 07, 2014 | 2005 Kia Sorento

1 Answer

Crank sensor kia sorento


double check timing because they are easy to time 180 degrees gff if engine not at top dead center

Mar 19, 2014 | 2006 Kia Sorento

1 Answer

How do i fix the whining noise my 2009 kia sorento makes


may be your power steering pump whining. Check fluid first, then if it's up, start the car up and have someone turn the wheel back and forth a few times. Listen to see if there is more or less noise when this happens. Does the noise go away after it warms up?

Jan 27, 2013 | 2009 Kia Sorento 3.3

1 Answer

Does 55 06 have belt or chain


you havent stated if its a petrol or a diesel and pray tell me what the 55 plate have in relevance to the question is it some sort of secret code ?? and if so in what country does it mean anything ?

Dec 06, 2012 | 2007 Kia Sorento 4x4

2 Answers

06 Sorento, passanger front door wont unlock.. Do we have to take the whole door panel off? is it maybe the motor ? Tryed to unlock with remote and manual.. It just wont open.


I take it that this is the only door that does not work. This being the case does the door sound as if the electric motor is working inside the door? When you try to unlock with the key does the key turn and nothing happens? If this be the case then a plastic clip that joins the key lock arm and the lockmechanism is likly to be broken requiring trim removall and replacing parts not very expensive but hard to get out. I find removing four bolts holding seat in position and removing the seat is the easy way

Dec 02, 2012 | 2006 Kia Sorento

Not finding what you are looking for?
2006 Kia Sorento Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

74896 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...