Question about Cars & Trucks

Open Question

How to remove ignition barrel on a citroen dispatch

Key will not go in to barrel

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
alicantecoli
  • 22246 Answers

SOURCE: glow plugs

awkard job but easy to do and remember the old adage if its in the way remove it ,remove the long communial wire then take the heaters out which is either a 12mm or 13 mm deep socket depends on make of glow plugs as to the size

Posted on Nov 23, 2008

Ad
  • 4 Answers

SOURCE: mercedez 190 ignition barrel. I have taken out ignition barrel attached to steering coloum but i can not remove key ignition from steering coloum how does it remove ignition barrel from steering

Should be the same as w123 model. Check diy Mercedes web page.
Photos included easy to do.

Posted on Jul 07, 2009

dsakrison1
  • 65 Answers

SOURCE: having trouble starting my 2003 subaru wrx

The sensor is not in your key. It is in the Key Fob, unless your car is not equipped with keyless entry. If there is no key fob than your car is not equipped with vehicle immobilization.

Posted on Sep 21, 2009

Danniboi
  • 1098 Answers

SOURCE: citroen dispatch 1.9 diesel hard to start

You need new heater plugs by the sound of it.
could be possible fuel pump starting to fail but unlikely if its just when cold.

Posted on Jan 13, 2010

dnewcombe1
  • 1564 Answers

SOURCE: how do to remove ignition barrel as key broken in

You must remove the steering wheel and locking plate underneath. This requires special tools that may be lended to you if you live near an Autozone and purchase the parts from them. To remove the tumble you must turn it to the "run" position with a screwdriver and poke in the small locking pin that is located on the front bottom surface of the tumbler bore. If you are unable to turn the keyswitch, it becomes necessary to replace the entire steering collar. Thank you, Dana

Posted on Feb 15, 2010

Testimonial: "Job DONE GREAT HELP. JUST HAD TO DRILL A SMALL HOLE IN THE END OF BARREL TO PUSH KEY OUT "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2012 Nissan Note. Heater blower stopped working but would come on intermittently - have changed heater motor and resistor card -still not working - any suggestions?


possibly check ignition leads from barrel, does it work if you wiggle the key in ignition? had a similar problem with a citroen and had to replace the wiring loom from the ignition switch.

Oct 25, 2017 | Nissan Cars & Trucks

1 Answer

How can i remove a citroen picasso ignition barrel without having a key


Very,very difficult. Bear in mind that there is an RFID sensor near the barrel that is used by the immobilizer system. If you can turn your key one notch between OFF and ON, then the locking pins can be pressed in and you can pull the barrel out. If not, your need to remove the whole steering column and do a lot of drilling/grinding to remove the locking pin.

Sep 06, 2014 | 2001 Citroen Xsara Picasso

1 Answer

Can u please help i spent all my money on a citroen berlingo the man was sarting with a screw driver soimanaged to get a barrell but now wont start with immobiliser can i snip a cable too buy pass this i...


You will need the old key. If you have it tape it to the new barrel each key has a chip to tell imobeliser its correct the old key taped on the barrel is the only way

Aug 08, 2014 | 2004 Citroen Berlingo 1.9

1 Answer

How to bypass an immobiliser on a citroen berlingo van


Try using the old key and place it near the barrel then turn the new key. These keys have RFID that the immoblizer can detect. Once key is changed, it will still look for original key to disable immo.

Aug 08, 2014 | 2006 Citroen Berlingo 1.9d

1 Answer

How to bypass an immobiliser


Check for a ring that fits outside the ignition barrel cover. It is usually connected to to two wires. Try removing it before you insert the key.

Aug 07, 2014 | 2004 Citroen Berlingo 1.9

1 Answer

Citroen troubleshooting


well since the starter was only 2 months old i am betting its an ignition short. When u turn the key, the solenoid on the starter engages the bendix gear with the engines flywheel and then energizes the starter motor. And when u release the ignition the solenoid and the starter motor should de-energize. hope this helps you.

Mar 05, 2014 | Cars & Trucks

1 Answer

Ignition key stuck


sorry new barrel and key

May 11, 2013 | Citroen Xsara Cars & Trucks

1 Answer

Fuse box layout citroen dispatch


I have a dispatch 52 plate with no working reverse lights, I THINK I need a new reverse light switch which is ment to be with the bulk of the engine but I cant for the life of me find it, any help would be great

Mar 20, 2012 | Citroen Berlingo Cars & Trucks

1 Answer

I have an Isuzu Rodeo and the key is stuck in the ignition any idea how to get it out? Year 2000


replace the whole ignition barrel with new key and get key programmed by dealer
can remove barrel and key by removing steering column covers turn ignition to on position and with small shank screw driver push in hole in outer top rear section of barrel assembly then pull out ignition lock barrel with key in it. fit new lock barrel and key, program new key into system and can get door lock barrels coded to suit new key or get code for old key and cut new key so it fits mechanical locks on the rest of the vehicle (just wont turn in ignition) 2 keys for vehicle.

Jun 13, 2010 | 2000 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

392 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...