Question about 1996 Chevrolet Blazer

1 Answer

Heater Switch I would like to know how to R/R heater blower switch. How do I remove the panel to get to the switch. It is a 1996 Chev Blazer

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 31 Answers

By R/R, do you mean Reset or Replace? and by heater blower switch, do you mean that the lo to hi fan speed switch is not turning the fan on?

If so, I had the same problem in mine. Instead, open the hood, and in the back of the engine compartment, on the passenger side, you will see two or three relays, they are little grey blocks about 1x1x2 inches. On mine, the middle one was burned out when I unplugged it. They cost about 12 bucks at the local auto store.

Posted on Jan 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Heater not working in 96 chey blazier


1. Check engine coolant.
2. Check heater core.
3. Check electronic control valve.
4. Check thermostat.

The problem lies within one of these four possible issues. =)

Nov 21, 2012 | 1996 Chevrolet Blazer

1 Answer

Replacing blower motor for 1996 chev corsica


Remove lower kick panel passenger side, blower motor in inside heater case, very close to the passenger door, behind glove box. From under the glove box look up to find a circular bulge with 5 (7mm) bolts around it, remove the 2 wire connector (black and purple). Remove the five bolts, drop down the blower motor, transfe over cage if new one doesn't come with one, reverse to reassemble.

Jan 28, 2011 | Chevrolet Corsica Cars & Trucks

1 Answer

1996 chev. blazer, heater not getting hot


You may need a thermostat and a coolant flush but one thing you can try first is disconnecting the heater hoses and run a garden hose with low pressure through the heater core both directions.These are commonly known to get plugged heater cores. If flushing the heater core out brings your heat back definitely get a coolant flush. Make sure to dispose of any antfreeze properly.

Nov 08, 2010 | 1996 Chevrolet Blazer

1 Answer

How to replace a blower motor in a 1996 ford thunderbird lx


Removal
  1. Remove the glove compartment liner to gain access to the heater blower motor and blower motor wheel assembly mounting screws.
  1. Use a small screwdriver to remove clip retaining hydraulic damper strut.
  1. Remove four screws and remove the heater blower motor assembly and blower motor wheel assembly from the heater blower motor housing.
Installation
  1. Using a new seal, position the heater blower motor and blower motor wheel assembly to the heater blower motor housing with the flat side of the flange near the heater blower motor switch resistor (18591). Install the four retaining screws.
  1. Tape the heater blower motor power lead to the air inlet duct to keep the wire away from the blower outlet during installation.
  1. Install the heater blower motor and blower motor wheel assembly in the vehicle.
  1. Install the glove compartment liner.

Oct 07, 2010 | 1996 Ford Thunderbird LX

2 Answers

Heater problem, not very hot & not switching from defrost to floor


either the AC\Heater panel switch on your center dash or the heater box vent door is stuck or not operating. Most likely panel switch or disconnected \ broken vacumm lines at back of switch

Jan 13, 2010 | 1996 Chevrolet Blazer

1 Answer

I have a 2000 ford E350 van with front and rear air. the front blower motor runs at low speed, The front blower still runs on low even when the knob is set on medium or high. I do not know where the...


it's either the blower motor switch or blower motor resister. Resistor ?Heater Blower Motor Switch Removal Remove the battery (10655) ; refer to Section 414-01 . Remove the battery tray. Remove the screws. Remove the battery tray. Disconnect the heater blower motor switch resistor connector. Remove the heater blower motor switch resistor (18591). Remove the two screws. Remove the heater blower motor switch resistor. ----------------------------------- Switches Removal Disconnect the battery ground cable. Remove the center trim panel; refer to Section 501-12 . Remove the control assembly. Remove the screws. Remove the control assembly. Remove the A/C-heater function selector switch knob. Disconnect the vacuum harness connector. Disconnect the A/C-heater function selector switch connector. Remove the A/C-heater function selector switch. Remove the screw. Remove the A/C-heater function selector switch. Remove the temperature control switch knob. Disconnect the temperature control switch connector. Remove the temperature control switch. Remove the screw. Remove the temperature control switch. Remove the heater blower motor switch knob. Disconnect the heater blower motor switch connector. Remove the heater blower motor switch (18578). Remove the screw. Remove the heater blower motor switch. ----------------------------

Mar 31, 2009 | 2007 Ford E-350 Super Duty Length XLT

2 Answers

Heater control 98 chevy s10 blazer


These trucks have a problem where moisture builds up in the heater box then freezes. When this freezes and you change your heater settings it breaks the shaft for the blend door. If this is what happened you should be able to look under the dash above and to the right of the gas pedal and you will see two vaccuum accuators one of them you should be able to wiggle around the linkage if it is broke. To fix this you need to remove the entire dash to get the heater box out which involves discharging the AC and draining the coolant because the heater core and evaporator come out. Please rate.

Dec 13, 2008 | 1996 Chevrolet Blazer

1 Answer

HEATER FAN


In the top of your heater plentum you should have whats referred to as a blower motor relay these tend to become tempermental as they go.

Nov 18, 2008 | 1995 Chevrolet Blazer

4 Answers

Vacuum leak


i would say its in the dash unfortunately you will have to pull it out to inspect.

May 25, 2008 | 1996 Chevrolet Blazer

Not finding what you are looking for?
1996 Chevrolet Blazer Logo

Related Topics:

160 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...