Question about Cars & Trucks

Open Question

I am trying to put seat covers on my nissan qashqai but i cant get the bottom rear seat up

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
alicantecoli
  • 22246 Answers

SOURCE: Peugeot 406 SV rear seat removal

take it you have done it------- two brackets at front of seat

Posted on Nov 20, 2008

Ad
alicantemick
  • 53 Answers

SOURCE: Nissan Qashqai auto headlights on in daylight

should be on the front of the dash board or even behind the rear view mirror but i think you will find that you need to have the car plugged in at nissan on there diagnostic machine and have the sensor reset

Posted on Dec 23, 2009

SOURCE: how do i take my fuel pump out in my bmw 325, i

The fuel pump in your 325 is under the rear seat, passenger side. Take the seat out, then pull up the rubber grommet with the wire going through it. Leave the wire alone for now. Peel up the thin rubber insulating mat. It is pre cut by the factory and not glued down. Remove the four nuts (10mm socket) and lift the round plate. Now remove the wire by sliding the plastic plug type housing back and lift the entire plug type housing up. Now, remove the hose clamp and slide the hose back off the plastic tube. If you damage the clamp, buy a new 1/4" clamp at the auto store for .30cents. Now unscrew the steel ring holding the pump in place. Unscrew this ring by tapping the ring with a screw driver and hammer. Remember counterclockwise (off). Now put your finger in the plastic ring molded into the top of the pump and pull up with some force. It is in place with a rubber gasket. Tight, but it will come loose. Be careful not to drop any thing into the tank. On the other side (drivers side) is a float/sensor. When reinstalling, seat the rubber gasket into the hole then drop the new pump/sensor into place. Your tank is like a saddle bag so it has two float/sensors. Time: 25 minutes

Posted on Mar 11, 2010

  • 155 Answers

SOURCE: how to remove bottom section

there should be a couple of bolts one on each side on the floor in front of the seat bottom remove and get in car put your hands down between the top and bottom seats and lift hard

Posted on Feb 26, 2011

emissionwiz
  • 76846 Answers

SOURCE: How to remove the rear

Pull up the seat cushion with a VERY firm tug upward on each side. There is a pin on each side (right where a person's legs would go about 12-15 inches in from the side of the cushion) that you need to disengage. But the cushion is not bolted down. This can be difficult so often repeated tries are needed.

Posted on Apr 21, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Nissan qashqai radio code 2014 model


A Nissan Dealership will tell you for free. Or you can buy from a codes website. It is based on the serial number of the set, so you have to remove it. The dealer does from the VIN Number.

There are a few free ideas in the link and a forum that supplies codes, and the website that does.

Nissan qashqai radio code Google Search

Dec 14, 2016 | Nissan Cars & Trucks

1 Answer

Does any one know how i can flip out my rear seat cusion to put a cover on my 2009 qashqai


Hi this link is a FREE download manual for a Nissan Qashqai 2009 model, There's 4 manual...1.6 / 1.6 vista / 2.0 / 2.0 dci acsenta you choose and try pulling your seat out and up, It'd clipped in..Cheers..
LINK->
http://www.repairservicemanuals.com/Nissan/Qashqai%202.0%20Acenta/2009/

Mar 18, 2016 | Seat Cars & Trucks

1 Answer

Nissan qashqai engine light plus traction control light come on at the same time and I cant get over 3000 reves


Hi Declan this is called (limp home mode) the computer shuts the vehicle down to half power to get you home. Get to a Garrage and get it diagnosed properly anything more than this is guess work. Regards Jom...

May 08, 2015 | 2010 Nissan Qashqai

1 Answer

How do I Bend forward the back of the rear seats of a Nissan Pulsar 2014 to put the seat covers on?


Do not bend the rear seat back rests, they will never be the same again. On most (if not all) cars the rear backrests are bolted on by means of two bolts behind the seat, so first remove the seat (the bottom padding that keeps your backside from hitting the floor) by pulling the seat up. On some vehicles, the seat is bolted down with two 6mm bolts on either side. Once you have the seat out, you should see two bolts holding the back rest to the body of the car. Undo these, and the backrest comes off easily.
Now fit the seat covers and bolt the backrest back into place. It is not a difficult job, shouldn't take more than an hour or less.

Dec 14, 2014 | Nissan Cars & Trucks

1 Answer

Remove cover from rear light


probably not, depending on the make and model..but if its a newer mmodel vehicle, you will need to replace the tail light assembly..you can e-mail me directly for these parts @ bigbolt1@gmail.com

Jun 12, 2012 | 2011 Nissan Qashqai 1.5

1 Answer

How to remove bottom section of rear seat in 2010 Nissan Navara D40 ST Dual Cab to fit saet cover


there should be a couple of bolts one on each side on the floor in front of the seat bottom remove and get in car put your hands down between the top and bottom seats and lift hard

Feb 26, 2011 | Nissan Titan Cars & Trucks

1 Answer

Nissan Qashqai auto headlights on in daylight


should be on the front of the dash board or even behind the rear view mirror but i think you will find that you need to have the car plugged in at nissan on there diagnostic machine and have the sensor reset

Dec 23, 2009 | Nissan Pathfinder Cars & Trucks

3 Answers

Nissan qashqai


If this is a new vehicle, you should have an owners manual with it; it would have that information in detail.

Mar 17, 2009 | 2008 Nissan Quest

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...