Question about 1995 Chevrolet Camaro

Open Question

How do i reset the vat system on a 1995 Camaro after new key re installment?

Put a new ignition switch in the car. it clicks but doesnt rev up

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 25 Answers

SOURCE: 1985 corvette vats system w/o chip in key need to bypass

REMOVE THE INFO PANEL IN THE CENTER. THE RELAY IS BEHIND THE INFO PANNEL. YOU CAN HEAR THE RELAYS CLICKING. YOU CAN CUT THE WIRE OF THE RELAY TO STOP THE RELAY FROM ACTIVATING THE IGNITION CUT OFF.
IF NO OIL PRESSURE THE ENGINE WILL STOP, CHECK THE OIL PRESSURE. GO TO CORVETTTE FORUM .. NEED SLEEP !

Posted on May 29, 2009

  • 355 Answers

SOURCE: how can I bypass the car alarm ignition switch

Here is a great write-up on the subject. This will get rid of the entire VATS system. It was the only thing that saved my 94 Park Avenue. http://newrockies.com/vatsbypass

Posted on Mar 02, 2010

judd0081
  • 334 Answers

SOURCE: i recently put a new alternator in my 1995 camaro.

The problem is your Vats security system. This causes the car to either "not start" or "shut down" while running. (depending on the system) If the security light flashes, i guarantee that this is what the problem is. 1st trick, turn the key forward 2 clicks till right before it would normally start, leave like that for 10 minutes. ( no less ) After 10 minutes, turn key back then forward and your car might start. Cheap fix: ----- http://vats.likeabigdog.com/ ----- Bypassing the key Never worry again fix: -------- http://newrockies.ca?ap_id=judd0081 ----- With this fix, you can take that whole Vats, passlock, passkey **** system out of your car all together. Good info on both sites

Posted on Jan 12, 2011

  • 355 Answers

SOURCE: I need to replace the

you can use any non-VATS lock/key and then get rid of the VATS system completely with this: http://newrockies.com . It will save you a lot instead of buying the VATS key/lock to match your TDM.

Posted on Feb 27, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

How do I fix the security system? the security light comes on and it wont crank. Does it reset itself?


sounds like gem module I had a 2001 did the same took batt cable off for 10 min and put back on and it worked for awhile it's the anti theft module a dealer can remove in for $ 150 hope that helps hope that helps

Nov 21, 2015 | 1995 Chevrolet Camaro

3 Answers

If I replace ignition switch on my 95 camaro with one that doesn't have the VATS chip on key will it start?


No you need to put the same one with the correct chip if not you need to bypass the system ill give you a general video on how to do it

Mar 29, 2015 | 1995 Chevrolet Camaro

1 Answer

I recently put a new alternator in my 1995 camaro. Now when i turn over the key the security light comes on and stays on solid (not flashing) The car won't start. I already tried bypassing the vats with...


The problem is your Vats security system. This causes the car to either "not start" or "shut down" while running. (depending on the system) If the security light flashes, i guarantee that this is what the problem is. 1st trick, turn the key forward 2 clicks till right before it would normally start, leave like that for 10 minutes. ( no less ) After 10 minutes, turn key back then forward and your car might start. Cheap fix: ----- http://vats.likeabigdog.com/ ----- Bypassing the key Never worry again fix: -------- http://newrockies.ca?ap_id=judd0081 ----- With this fix, you can take that whole Vats, passlock, passkey **** system out of your car all together. Good info on both sites

Nov 29, 2010 | 1995 Chevrolet Camaro

4 Answers

Okay heres what happen my chip in my key fell out so car wont start noter what doo I do


research vats bypass on google. I had to bypass, you simply measure the resistance through the chip, go to radioshack and buy the resistors that add to that amount or withing 2%. cut the orange wire that leads to the ignition and install the resistors bypassing the vats permanently.
http://vats.likeabigdog.com/
http://shbox.com/1/vats_bypass.jpg

Aug 17, 2010 | 1995 Chevrolet Camaro

1 Answer

I need to replace the ignition switch on my 94 Camaro. Do I have to use a special ignition switch that uses the "VATS" system, or can I just replace the switch that comes with its own set of keys that are...


you can use any non-VATS lock/key and then get rid of the VATS system completely with this: http://newrockies.com . It will save you a lot instead of buying the VATS key/lock to match your TDM.

Aug 17, 2010 | 1994 Chevrolet Camaro

3 Answers

Car started an hour ago now wont turn over security light in dash came on and stays on


if the security light is on then it is the VATS system. the ignition switch is fine still.

Aug 15, 2010 | 1995 Chevrolet Camaro

3 Answers

Lost keys to 91 chevy camoaro. put in new ignition switch. will not start . What do I do


the old key might be for the immoberlizer as well if it has one so you will not be turning the immoberlizer off if it is coded to the key

Mar 22, 2010 | 1991 Chevrolet Camaro

2 Answers

95 chevy camaro with pass key will not start. Replaced key and it started. Later it did not start. What's going on? What are some things to try?


If it's the same as the VATS system in my 86 Corvette (resistor pellet in key) the ignition switch might need to be replaced. The contacts on the key wore low, replacing the key helped for a short time but the new contacts wore the switch down faster then it too needed to be replaced. $200!

Nov 16, 2009 | 1995 Chevrolet Camaro

3 Answers

How to bypass the chip in the key 1995 chevy camaro


cant bypass if u want to get rid of it need to replace ignition system with a non security chip system--including computer reprogram

Oct 29, 2009 | 1995 Chevrolet Camaro

2 Answers

Everything works in the car but car doesnt start


The security light is staying on because 1 of 2 things, both of which relate to the vehicles VATS (vehicle ani-theft system). You know that little black bump in your key? Well thats part of the VATS system. There is a connection in the ignition that reads the resistance of the pellet. If its not the right one, the security light disables the ignition and starter for 3-5 mins. Now either the wiring is loose on the inside of the ignition switch, or the metal contacts of the key is dirty. Try cleaning the key off with some rubbing alcohol and try again. Or better yet, if you have a spare key that gets used less often, try that one. If that dosent work, its time for a new ignition

Feb 23, 2009 | 1995 Chevrolet Camaro

Not finding what you are looking for?
1995 Chevrolet Camaro Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...