Question about 2007 Mercury Montego AWD Sedan
Posted by Anonymous on
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
LOL!!! I had the same problem. I can't recall the exact steps, but there aren't that many options, so you'll get this. With the car running, press the Info button on the left side. It will cycle through the various statuses of the car. At one point, it will get to the Oil and will tell you something like "Press Reset if New." Press it and hold that darned button until it acknowledges that you changed the oil. It will reset that message from 0% to 100%. It took me a couple of tries to get that to reset. Just keep trying it till it resets. You'll get it.
Posted on Mar 02, 2009
Go to a automotive store and tell them you have a 2005 Mercury Montego and what engine it has if there is more then one model and get an oil filter and the oil. Put the car up on ramps and secure it making sure it won't roll back or fall while you are under it. get under the engine and look for the oil pan which should have a bolt in the bottom of it where you can drain the oil. Drain the oil in a proper container and then put the drain plug back in the pan. Then find the oil filter and unscrew it and remove it.. It could be full of oil so watch out and make sure the pan is underneath the filter. Wipe the base where the oil filter screws on and make sure the gasket from the old filter is not still on the engine. Get your new filter and take your finger and put it in one of your new containers of new oil and spread that on the gasket of the new filter. Screw on the filter until the gasket touches the base and then turn only a little more then a 1/4 to 1/2 turn tops. Do not over tighten the filter. Find out what oil the vehicle needs (probably 5-30) and look for the oil cap on a valve cover under the hood. It probably takes 5 quarts but check for sure in your manual or ask when you are at the automotive store. Put the oil in and put the filler cap back on. Now go start the vehicle and make sure you have oil pressure by either the oil pressure guage showing pressure or the oil pressure idiot light goes off and while running check under the car for any signs of leaks. If no leaks then back the car off the ramps and shut the car off on a level surface. Let it sit 10 minutes and check for leaks underneath the car and check the oil dipstick to make sure the proper level of oil is in the engine. Then you are set.
Always check your air filter when changing oil to make sure it is clean as that helps your engine run better and you save gas in the process. Good luck
It is also best to change oil when your engine is warmed up as well.
Posted on Mar 28, 2009
You will need to optain a wire schematics for the abs system and related parts. The fuse is blowing because there is an obvious short circuit in the system. The wire schematics will help you trace the shorted power wire thats giving you problems. Repair wire as nesessary. (Replace damaged section of wire) Replace fuse.
Posted on Jul 23, 2009
SOURCE: Oil change light
Look up the light on the part of your owners manual that explains what each idiot light is for on your dash. That should give you a page where more information on it is available. Part of that section should state that if maintenance is done by someone other then your Mercury dealer, then do the following to reset the light. That should take care of ya.
Posted on Dec 15, 2009
you will have to find the controller, the code should be on it, looke in the left wheel area behind the panel, it used to be there
Posted on Jul 28, 2010
Tips for a great answer:
Jul 28, 2016 | 2005 Mercury Montego
Jan 03, 2013 | 2005 Mercury Montego
Oct 14, 2012 | 2005 Mercury Montego
Oct 11, 2017 | 2005 Mercury Montego
Jan 03, 2010 | 2005 Mercury Montego
Aug 28, 2009 | 2005 Mercury Montego
Aug 17, 2009 | 2005 Mercury Montego
Oct 19, 2008 | Mercury Montego Cars & Trucks
22 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: