Question about 2002 Chevrolet Astro

Open Question

How to replace left side headlight low beam bulb on the 2004 astro van

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 75 Answers

SOURCE: how to change bulb on drivers side low beam head light

My niece has a jimmy, they should be the same. The inside should be the high beam, the outside the low, DO NOT TOUCH THE GLASS ON NEW BULBS! Oil will cook on them and pop them! Both come off the same way. Take off the big rubber thing. They are soft but over hard plastic. Just pull them off. If you have trouble, you can flip the little wire clips that hold the headlight housing in place, this will give you room to see the rubber caps enough to figure them out better. The bulb assembly rotates CCW counter clockwise, and should slip out easily. Take the wires and plug off. it should be obvious how it pulls off. Snap the new bulb into the wires without touching the glass part. Gently replace in backwards order as you removed it. Put the rubber caps on, they keep water off the bulbs. It will break them!

The passenger side was harder for me. I had to take the air cleaner off, the whole cover and filter.You should be able to see or feel the same type caps, The low beam outside, High beam inside. The same 2 wire clips are there to release the housing. Everything pretty much goes the same, other than the air cleaner has to be removed and replaced. And make sure the rubber cap is replaced! Good Luck and good motoring!

Posted on Dec 19, 2008

  • 1 Answer

SOURCE: 2006 Trailblazer Headlight Replacement

There are not two rods, there are two clips one under fender weild and one right above the light on top of the cover. Pull up on these two clips and pull the light forward a couple of inches and remove the dust cover. You have to take the air filter cover off to be able to reach in and replace the light. It took me about 10 min to figure these out but hope it helps out.

Posted on Jan 14, 2009

  • 10 Answers

SOURCE: Replacing a headlight bulb, low beam, in a 2004 Chevi Trailblazer

Step1
Your first stop should be to your local auto parts shop to get the bulbs you need. You'll need to pick up #9006 bulb, this one has a gray bas and is used for replacing the outside high beam. If you are looking to replace your inner low beams you'll need to pick up #9005 which has a black base. The bulbs should run you about $16.00 USD.
Step2
Alright once you have your bulb and are ready to replace it make sure you have popped the hood the release lever is on the inside of your vehicle.
Step3
While facing your car with the hood open, your going to remove the grill by pushing down on the two retainer clips which are on the top of the grill. You'll need a flathead screwdriver to help you with the rest of the retainer clips. There are two on the bottom ends of your grill one in the center and 2 on each side. Now you'll just pull up on the grill and it should come out easily.
Step4
On each side of the headlamp you should see a One inch long tab, when you pull up on the tabs it will release the headlamp so that you may pull the headlamp toward you. Pull the head lamp out.
Step5

There will be two round rubber caps at the rear of the headlamp. Remove the caps and then pull out the wire harness from the bulb.
Replace the bulb or bulbs and remember that #9006 has the gray base and is for the high beam and #9005 is for the low beam and has the black base. Reconnect the wire harness and replace everything to its original position and now you have a fixed headlamp! Congratulations!

Posted on Jan 16, 2009

  • 1 Answer

SOURCE: Driver side Headlight Replacement

I am car stupid. Just following the instructions in the owners manual, I was able to replace my low beam driver side bulb in less than a half hour. Only one tip. When it says pull straight up on the tab, definitely oil it first. I snapped the tab off and cut myself because it didn't have enough give.

Posted on Jan 19, 2009

  • 1 Answer

SOURCE: Passenger Low Beam Headlight needs replacement!!!

You could remove the air filter cover and then you will be able to reach the bulb.

Posted on Apr 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What would cause the low beam headlight not to work when all other lights work?


If you have standard halogen bulbs:

  1. Burned out light bulb; or
  2. Fried wires between the dashboard wiring harness and the headlight bulb connectors; or
  3. Fried headlight bulb connectors.
If you have HEI emitters:
  • Failed ballast.

May 11, 2015 | 2002 Mercury Grand Marquis

3 Answers

2000 ASTRO VAN - HI BEAM LIGHTS DO NOT WORK - HAVE REPLACED THE MAIN HEADLIGHT SWITCH - CHECKED THE HI BEAM BULBS HAVE NOT 12 VOLT TO BULBS


check relays and fuses located with owners manual if you dont have
look in fuse box may be under hood not familiar with astro vans

Apr 04, 2011 | Chevrolet Astro Cars & Trucks

4 Answers

2004 Lincoln Navigator low beam headlight went out so I changed the bulb and fuse but it still does not work.


If you have the HID bulbs check with an Autoparts store like Autozone. I believe the right and left headlights have separate Relays in the Powerbox. It is possible that there are 2 low beam and 2 high beam relays total. They pull too much power for both sides to be wired together and may wire the high beams separate too!

Feb 08, 2011 | 2004 Lincoln Navigator

2 Answers

Right headlight low beam does not work, high beam does. Left side headlight works fine


I had the same problem with my 2004 ram, passenger side low-beam wouldn't work after replacement. Online I saw many things from socket replacement to Fcm replacement. What worked was to remove fcm (front control module) and clean appropriate contacts with small nail file . Repair took less than 1 hour and cost 0$, wish I could give credit where I found info.

Nov 28, 2010 | 2004 Dodge Ram 1500

1 Answer

My passenger side low beam headlight is out. the driver side low beam headlight works fine. I replaced the bulb and the headlight still doesn't work. What should I look at next?


Check the fuse. There are seperate fuses for right and left. You dont mention if the high beam works for that side? If it does, the fuse is good. The GREEN wire at the bulb is the ground for the low beam. If that wire has power, then the ground is bad. If the high beam works, the hi'lo beam switch is good, and there is a problem between that headlight and the Engine Compartment Junction Block

Dec 16, 2009 | 2004 Hyundai Santa Fe

1 Answer

2004 Chevrolet Trailblazer


First face the vehicle so the battery in on the right.
Second open hood.
Third Remove the Grill by pushing firmly on two retainer clips that are on the top, use the wide slot screwdriver to get the rest of the clips off. Pull up gently on the grill it should then pop out. The grill extends under each headlight assemblymag-glass_10x10.gif any other retainer clips should release when the grill in popped out.
  • Step 2 Fourth on top of the headlight assembly you will see one 1" tab on the right and left side, pull the tabs upward about two inches and this should release the headlight assembly. You then should be able to pull the headlight assembly out toward you.
  • Step 3 Finally at the back of the headlight assembly you will see two rubber caps one for low beam and one for high beam, the white base is for the low beam and the black base is for the high beam. Unsnap the wire harness from the bulb base, turn the bulb clockwise.

    Replace the bulbs high beam on the outside and low beam on the inside.
  • Jun 19, 2009 | 2004 Chevrolet TrailBlazer

    1 Answer

    Left low beam headlight inop. tried bulb and checked fuse. both OK


    check fuses under hood there should be seperate fuses for each side.

    May 26, 2009 | 2004 Lexus RX 330

    1 Answer

    Low beam, driver's side headlight out. Bulb, fuse or entire apparatus replacement? I have the same problem, low beam, driver's side headlight is out but I can't figure out how to get the bulb out to...


    The low beam bulb needs to be replaced. Go to an autozone store as they will sell you the bulb, and even assist you in their parking lot with installing it.

    May 06, 2009 | 2004 Lexus ES 330

    1 Answer

    Left low beam headlight on Chrysler 2003 T&C wont work while engine is on


    Ill guarantee you have an electrical short on the left side of the headlight switch,circuit.From here its immpossible for me to go any further.Good Luck.,Get A Wiring diagram.

    Apr 18, 2009 | 2003 Chrysler Town & Country

    1 Answer

    Low beam headlights not working on 2004 Pontiac Montana extended


    You headlight lamp have a diffuser mechanism which allows it to flip between the hight beam and low beam feature of the bulb. In fact, you high beam will function even if the low beam is not working.

    I would recommend the purchase of the new headlight lamp. It would cost you you any where from $15.00 per unit to get a replacement lamp

    Dec 26, 2008 | 2004 Pontiac Montana

    Not finding what you are looking for?
    2002 Chevrolet Astro Logo

    Related Topics:

    75 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts

    yadayada
    yadayada

    Level 3 Expert

    75051 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22095 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    7726 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...