Question about 2000 Chevrolet Malibu

1 Answer

Warning beeping our 200 Malibu beeps in sequences when parked and engine running. it starts with 1 beep, then 2 then 3 then 4 then back to 1 beep again. doesnt beep while driving. beeped with old battery and new. no other problems.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 90 Answers

Sounds like a security system warning, must use scanner to accesss system. Hope this helps.

Posted on Jan 23, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Chev Malibu 2003 does a sequence of beeps one then two then three then four and does that over and over again in park and reverse til you drive but no lights on dash


It sounds like to me that the emergency brake is ingaged meaning it's pushed down one or two notches. ..and that will shut off the lights and make the warning dinger sound off

Nov 22, 2014 | 2003 Chevrolet Malibu

3 Answers

Alarm warning system on '02 Mercury Mariner 150HP E.F.I.-


Engine tank should be plumb full tight. The engine supplies about 2 lbs pressure through one of the 2 lines going to the boat tank. The other line takes the oil to the engine tank. If that line gets kinked or pinched, the engine tank won't get oil, a check valve lets a little air into it, and the oil pump keeps getting oil. When it goes down just a little, the alarm goes off telling you something is wrong.

Sludge in the boat tank could plug up the pickup screen. I've also seen them plugged up by a foil oil bottle seal carelessly dropped into the tank.

Once you find out why the oil couldn't get there, start the engine with the cowl off and loosen the cap on the engine oil tank until it leaks, then tighten it down and clean up the mess. That tank is normally plumb full tight.

If when the engine is running, you crack the cap on the boat tank, you should hear pressure let off. If the cap leaks, it won't build up pressure. If there is pressure, the oil line is plugged or kinked.

If pressure isn't supplied, the problem would be the crankcase check valve on the engine, lower forward starboard side, with the hose going to it.

hope it helps

Jul 05, 2008 | 2002 Mercury Mariner

1 Answer

1 beep every five minutes, i have no oil ***** light on ever.


Is it the oil warning? Beeps can come from a number of areas. My door closed warning would beep when I braked. Seat belt intermittent, even your speed warning setting beeping once when over setting got me once. I didn't even know I had set it.

If the oil light comes on before starting, (as do all warning lights) and doesn't show up on the beep, it probably is not the source of the beep.

Cheers

Dave

Oct 24, 2014 | 2006 Ford Explorer Eddie Bauer 4x4

1 Answer

2005 jeep wrangler when i turn lights on beeping starts


did you RTM read the operators guide yet,
it tells you why all beeps beep and what lamps flash, (warning) and why. did you?
you turn on, the head lights, (what about 1st click , parking lights"?)
and does the dash cluster, show warnings of any kind?

if a door is ajar the system will think, you are exiting veh. with lights on and tell you, buy beeping ,etc.
but on my jeep it says on the dash DOOR, or on EVICs, (not yours)
the newer car even tells what door IS AJAR.
mine on shows , "DOOR"
the operator guide will say, check all doors for ajar, and get warning clear before driving....etc.

if you lost the guide here it is for free

http://justgivemethedamnmanual.com/jeep/jeep-wrangler-owners-manuals/

click the 05 link
ignore beeps, there are just too many .. i look at the cluster and learn to read it..
my newer jeep 08 can produce 1000s of errors,,,,, possible.
in fact the intent it to beep to tell the driver to look at the cluster
for in depth, causes.
see chapter starting on page 136'

once sound it makes is Check gauges chime. so check them.
and headlamps left on
and door ajar.

page 63
NOTE: If the driver's door is left open, and the headlights
or parking lights are left on, the "High Beam
Indicator Light" will flash and a chime will sound.
Lights-On Reminder
If the headlights or parking lights are on after the ignition
is turned off, a chime will sound when the driver's door

its a crude system, and evolved to complex in 2007.
"DOOR" or RF-door , on mine.
or

NOTE: A tone will chime if the turn signals are left on
for more than 1 mile (2 km).

search manual for
"chime will sound"

Mar 21, 2014 | 2005 Jeep Wrangler

2 Answers

When headlights turned on the dashboard lights dim and after 5 minutes a warning sound comes on.


Sounds like your charging system needs some attention.
1st check battery for voltage should be 12.50 or better with car off
2nd, start car check battery for voltage again should be 14.0 to 14.75 volts.
3 with running turn on headlamps and check charging voltage again if your voltage dropped to battery voltage your charging system is not working.

Oct 30, 2017 | 2006 Jeep Wrangler

1 Answer

'02 Rendevous beeping randomly, no lights or trouble indicatiors on. Beeps when parked, beeps while driving, no rhyme or reason apparant. sometimes goes 10 or 15 minutes without beeping, other times beeps...


The audible warnings alert the driver of a system concern or a critical vehicle condition. The radio generates the audible warnings through the left front speaker. The radio receives audible warning requests via the class 2 serial data line from the IPC or body control module (BCM). If the radio receives multiple audible warning requests, the warning with the highest priority sounds first. The following lists the audible warning priority and the pulse rate:
Fast rate chime--200 pulses per minute
Medium rate chime--150 pulses per minute
Slow rate chime--50 pulses per minute
Single chime

Is the sound heard different from typical Audible Warnings ?

Fasten Safety Belt Warning
The radio activates the fasten safety belt audible warning as requested by the IPC. The IPC sends a class 2 message to the radio indicating the chime frequency, slow rate and duration (5 pulses). The fasten safety belt warning sounds and the fasten safety belt indicator illuminates when the following occurs:
• The ignition switch transitions to ON.
• The inflatable restraint sensing and diagnostic module (SDM) detects that the driver's seat belt is not buckled, signal is low. The IPC receives a class 2 message from the SDM indicating the driver's seat belt status.
If the seat belt is buckled when the ignition is turned on, the chime does not sound. If the seat belt is buckled while the chime is sounding, the chime stops. If the seat belt is unbuckled after the initial transition to ON, the chime does not sound.
Headlamps On Warning
The radio activates the headlamps on warning as requested by the body control module (BCM). The BCM sends a class 2 message to the radio indicating the chime frequency, fast rate and duration, continuous. The headlamps on warning sounds when the following occurs:
• The ignition is OFF.
• The BCM determines that the driver's door is open, signal is low.
• The BCM determines that the headlamp switch is in the park or head position.
Key-In-Ignition Warning
The radio activates the key-in-ignition audible warning as requested by the BCM. The BCM sends a class 2 message to the radio indicating the chime frequency, medium rate and duration, continuous. The key-in-ignition warning sounds when the following occurs:
• The ignition switch is OFF.
• The body control module (BCM) determines that the driver's door is open, signal is low.
• The BCM determines that the key-in-ignition switch is closed, signal is low.
Turn Signal Reminder
The radio activates the turn signal warning as requested by the IPC. The IPC sends a class 2 message to the radio indicating the chime frequency, medium rate and duration, continuous. The turn signal warning sounds when the following occurs:
• The ignition switch is in the RUN position.
• The turn signal switch is in either turn position, sensing, within 1 second, an open to B+ transition in the turn signal control circuit, left or right turn.
• The vehicle has traveled a distance of 1.2 km (¾ mi) by counting pulses on the vehicle speed input circuit.
The IPC turns OFF the turn signal reminder when either the ignition switch is turned to the OFF position, or the turn signal switch returns to the OFF position, sensing, within 1 second, no transitions from open to B+ in either of the turn signal control circuits, left turn or right turn.
Additional Chimes
The following chimes will turn ON when an associated indicator/message turns ON in the IPC/DIC:
• ABS indicator
• AWD Disable indicator
• Battery/Charge indicator
• Brake indicator
• Change Engine Oil indicator
• Door Ajar indicator
• Hot Coolant Temp indicator
• Low Brake Fluid indicator
• Low Fuel indicator
• Low Oil Level indicator
• Low Oil Pressure indicator
• Low Tire Pressure indicator/reset
• Low Washer Fluid indicator
• MIL (Service Engine Soon) indicator
• Oil Life Reset
• Park Lamp Out indicator
• Rear Hatch Ajar indicator
• Service Traction System indicator
• Service Vehicle Soon indicator
• TRAC OFF indicator
For a description of an indicator refer to Indicator/Warning Message Description and Operation .
For diagnosis of an indicator refer to Symptoms - Instrument Panel, Gages and Console .

Did the Mechanic check for DTC'S - diagnostic trouble codes in the BCM or insturment cluster ? Did you try a Buick dealer ?

Jul 09, 2017 | 2002 Buick Rendezvous

2 Answers

Beeps while driving


My van did this aswell, you must have a power sliding door, when it is not latched properly this warning goes off but it won't say on your message center "door ajar". Stop and reopen the door and close it again no more bell. good luck.

Aug 19, 2009 | 1999 Pontiac Montana

Not finding what you are looking for?
2000 Chevrolet Malibu Logo

Related Topics:

688 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...