Question about 1995 Audi A4 1.8

Open Question

Adjust intake & exhaus valve of kia pride b3 - 1995 Audi A4 1.8

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 kia sephia vavle adjustment procedure


Settings are made with engine cold - intake valves 0.28 - exhaust valves 0.33

Oct 07, 2016 | 2000 Kia Sephia

2 Answers

Code p0507


possible causes are:

Dirty throttle body
Electric throttle control actuator incorrectly adjusted/faulty/damaged
Air leak on Intake
Poor electrical connection to the Intake Air Control valve

P0507 KIA Idle Air Control IAC System RPM Higher Than Expected

May 14, 2014 | 2003 Kia Sedona

1 Answer

Check engine light code p200a


P200A Intake Manifold Runner Performance
The Variable Charge Motion Actuator (VCMA) is used to adjust a valve (flap) in the intake runner for each cylinder. The valve does not close off the runner but restricts it in such a way to cause turbulence (swirl) in the air fuel mixture. The turbulence in the air will reduce emissions under cold start condition. The valve is operated by a worm gear type driver which doesn't open for limp home mode in the case of loss of current supply. (It doesn't have a return spring.) The system also has a Valve Position Sensor (VPS) to supply a feedback of the valve position to the PCM.

Feb 11, 2014 | 2011 Kia Sorento

1 Answer

Needed torqur spec on rocker arms on 1994 gmc 5.7liter


There is no torque spec for rockers. You tighten until there is no backlash, then preload another 1/4 to 1/2 turn. With #1 at TDC on the compression stroke, you adjust #1 by this procedure. You can also adjust intake valves on #'s 2, 5 & 7 as well as exhaust on 3's 1, 3, 4 & 8. Then rotate the engine until #6 is TDC on compression stroke and adjust intakes on #'s 3. 4. 6 & 8 and exhaust on #'s 2, 5, 6 & 7. Good luck.

Oct 01, 2013 | Chevrolet Cars & Trucks

1 Answer

How to adjust travel


1 intake down
2 compress up
3 power stroke down
4 exhaust up




if you start with you start with the piston just a couple of degrees past TDC (top dead center) so that it has started its return down


now set the valves so they are closed:
if you have an adjustable valve clearance's then your clearances should be noticeable like 10 thousands ( you should be able to move the lifter ( rocker arm ) and it will be loose up and down


with the spark plug still out; so you can see the piston coming to TDC and passing it to come down


turn the flywheel and watch the strokes and the condition of the valves


1 just past tdc, the intake valve opens and the piston goes down for the intake stroke


2. jst as the piston comes around BDC the intake valve should close and return to tdc with all valves closed ( the compression stroke )


3 just past TDC the ignition will fire and the piston will return down with both valves closed( the power stroke)


4 just past BDC the exhaust valve opend , the piston travels up and completes the exgaust stroke.




and after completing the exhause stroke and arriving at tdc the intake valve opens and you start over again 1,2,3,4

Sep 12, 2012 | Cars & Trucks

1 Answer

Where is the pvc valve on a 2.7 V6 Kia Optima


Pretty much all PCV Valves are on a valve cover

They regulate the amount of air evacuated from the crankcase,
& have to block off vacuum at times & prevent oil from getting into
intake,thus on a valve cover near oil

They NEVER NEED TO BE REPLACED
never have in 50 years
They can be sprayed clean, if you like,with brakleen etc

AGAIN -- a PCV unless it's vacuum hose leaks HAS NOTHING
WHAT SO EVER TO DO WITH HOW YOUR VEHILCE RUNS

Jul 12, 2011 | Kia Optima Cars & Trucks

1 Answer

What are the valve adjustment specs on the head of 1999 kia sportage both dual and overhead cam 2.0 please give answer to both intake and exhaust please ...


the valves are hydralic and are not adjustable.if they are noisey there may be a bad lifter or cam. if they sit for a few days they will click for awhile when started. the factiry recomends running the engine in nuetral for 5 minutes at 2000 rpm the bleed out air bubbles [or just drive it down the highway a few miles.

Aug 26, 2010 | 1999 Kia Sportage

1 Answer

02 Sedona. Removed valve cover and the intake


Over 20 years in the field and I can't say I've seen something like that. Are you able to send clear pics of what you found?

May 22, 2010 | 2002 Kia Sedona

Not finding what you are looking for?
1995 Audi A4 1.8 Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75817 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14337 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...