Question about Honda Jazz

Open Question

Malfunction indicator lamp - Jazz Honda Cars & Trucks

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
j_del
  • 1586 Answers

SOURCE: what causes the malfunction indicator lamp to comes on honda accord 2001?what can i do to correct it?

It could be anything at all that is electrical or sensor-related in nature. Your car is an OBD2 car (for emissions), and it's a very strictly-controlled system. As a result, pretty much anything that fails will cause the light to come on and will store a code in the computer. Go to AutoZone and ask them to scan your computer for codes - they'll do it for free, where a dealer will hit you for up to an hour's labor. They'll tell you the fault codes, which will point you in the right direction for the fix. Get the codes that come out of the scan and post them as a reply here and we can go from there.

Posted on Oct 11, 2008

Ad
beduncan
  • 73 Answers

SOURCE: Malfunction Indicator Lamp

Take your car to your local autoparts store and have them pull the codes - this is free at most stores. Post the codes when you're done. This can be caused by anything - even as simple as not tightening your gas cap (you should hear the clicks - it doesn't damage the cap).

Posted on Aug 07, 2009

  • 1 Answer

SOURCE: MALFUNCTION INDICATOR LAMP

Check your CAPS LOCK as that may be the problem.

Posted on Nov 03, 2009

emissionwiz
  • 76132 Answers

SOURCE: malfunction indicator lamp in my toyota corolla is on how i fix?

The check engine light also called the malfunction indicator comes only when the computer control unit (called the PCM) senses a fault in the electronic controls of the engine and/or the emission system, there are about 200 possible faults that turn the light on, to know what has developed a problem you must have the system tested, this is called an OBD2 fault code test, Kragen and Autozone parts stores do this testing for free.

Posted on May 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuses ok,light in dash tested and works. But check engine light does not come on when you turn on the ignition. What else should I check? This is a ford ranger XLT 4x4 4.0L V6-245cid engine (pushrod)


The instrument cluster (10849) carries out a display proveout to verify that all warning/indicator lamps and monitored systems are functioning correctly. When the ignition switch (11572) is in the ON position with the engine (6007) off, the following indicators will illuminate:
  • CHECK ENGINE/malfunction indicator lamp (MIL).
  • CHECK GAGE warning indicator.
  • Charge system warning indicator.
  • Anti-lock brake warning indicator (ABS).
  • Safety belt warning indicator (60second proveout).
  • Air bag indicator.
  • An indicator is inoperative - CHECK ENGINE/malfunction indicator lamp (MIL)
  • Bulb.
  • Circuitry.
  • Instrument cluster printed circuit.
  • Powertrain control module (PCM) (12A650).
  • GO to Pinpoint Test N .

Feb 15, 2016 | Cars & Trucks

1 Answer

What is malfunction indicator lamp on 03 mercury sable


Malfunction indicator ,check engine lamp . service vehicle soon etc.. Trouble Codes Check Engine Light On

Oct 23, 2015 | Mercury Cars & Trucks

1 Answer

Push button for four wheel drive isn't working


Do you have any lights on the dash lit ?
SERVICE indicator (4WD/AWD) Lamp
The SERVICE indicator (4WD/AWD) lamp is an integral part of the cluster and cannot be serviced separately. This lamp is used to inform the driver of the vehicle of malfunctions within the automatic transfer case (ATC) system. The SERVICE indicator (4WD/AWD) lamp is controlled by the transfer case shift control module via CKT 1567. this system will set DTC'S if there is a problem .
Diagnostic Trouble Codes DTC B2725 ATC Mode Switch Circuit Malfunction DTC C0300 Rear Speed Sensor Malfunction DTC C0305 Front Speed Sensor Malfunction DTC C0308 Motor A/B Circuit Low DTC C0309 Motor A/B Circuit High DTC C0310 Motor A/B Circuit Open DTC C0315 Motor Ground Circuit Open DTC C0323 T-Case Lock Circuit Low DTC C0324 T-Case Lock Circuit High DTC C0327 Encoder Circuit Malfunction DTC C0367 Front Axle Control Circuit High DTC C0374 General System Malfunction DTC C0376 Front/Rear Shaft Speed Mismatch DTC C0387 Unable to Perform Shift DTC C0550 ECU Malfunction DTC C0611 VIN Information Error you probably should take this to a repair shop !

This tt

Feb 22, 2015 | 1999 Chevrolet Silverado 1500

1 Answer

P1613 what it means engine light on


  • Check Malfunction Indicator Lamp (MIL)
  • Check Wiring/Connectors from/to Malfunction Indicator Lamp (MIL)
  • Check Control Module Coding
  • Check/replace ignition/starter switch
  • Check relay on left plenum chamber for execive wear

Mar 15, 2014 | 1998 Volkswagen Passat

1 Answer

I went to scan my toyota yaris car and the following codes were give ; temperature ckt low input po117


EOBD II Error Code: P0117
Fault Location:
Engine Coolant Temperature (ECT) Sensor (G62) - Low Input
Possible Cause:
Malfunction Indicator Lamp (MIL) Triggered on first occurrence.
Coolant thermostat.
Wiring short to earth.
Engine coolant temperature (ECT) sensor.

EOBD II Error Code: P0340
Fault Location:
Camshaft Position (CMP) Sensor A (G40), Bank 1 - Circuit Malfunction
Possible Cause:
Malfunction Indicator Lamp (MIL) active.
Wiring from/to Camshaft Position Sensor (CMP) faulty.
Camshaft position (CMP) sensor faulty.
Timing misaligned.
Possible Solutions:
Check Wiring from/to Camshaft Position Sensor.
Check Camshaft Position Sensor.
Check Timing.

EOBD II Error Code: P0500
Fault Location:
Vehicle Speed Sensor (VSS) - Circuit Malfunction
Possible Cause:
Malfunction Indicator Lamp (MIL) Non Emission Fault - No warning light.
Wiring.
Vehicle speed sensor (VSS).
Engine control module (ECM).

Dec 13, 2012 | 2001 Toyota Yaris

1 Answer

1996 e350 got engine check light p1742 code


Call your local dealer with your vin # ,, there is a recall for that specific code.
96-5-16 • MALFUNCTION INDICATOR LAMP (MIL) ILLUMINATION - CODE P1742 STORED IN MEMORY - NO DRIVEABILITY CONCERNS PRESENT - VEHICLES WITH E4OD TRANSMISSION BUILT THROUGH 10/15/95 • LAMP - MALFUNCTION INDICATOR LAMP (MIL) ILLUMINATION - CODE P1742 STORED IN MEMORY - NO DRIVEABILITY CONCERNS PRESENT - VEHICLES WITH E4OD TRANSMISSION BUILT THROUGH 10/15/95


MARCH 1996 PCM - MIL ON/DTC P1742 Set

Jul 29, 2010 | 2002 Ford E350

1 Answer

Malfunction indicator lamp


The Malfunction Indicator Lamp or MIL (Also called the check engine light or service engine soon light) comes on when the on board computer detects an issue with the operation of the engine or transmission.

The best thing to do is to take the vehicle to an auto parts store like Autozone and have them hook up their scan tool to the vehicle and read the code. They can read it, tell you what it is and also tell you what the code means.

If it is pointing to a faulty component or sensor and you replace or repair the component the the light will go off on its own after the computer sees that the malfunction is no longer present.

You can have the code cleared, but if whatever caused the light to come on in the first place is not addressed then it will just come back on eventually.

Dec 31, 2008 | 2006 Toyota Tacoma

1 Answer

Malfunction indication


The Malfuntion Indicator Lamp (MIL) is being lit up by the vehicle's computer to indicate there is a problem with one of the vehicle's systems.Have the vehicle scanned,write down the code number and definition,and ask whoever scans it what's involved in repairing the malfunction,and what system it is in.Or come back in here with the code number and definition,and we can help you.

Jul 10, 2008 | 2003 Nissan Pathfinder

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

259 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...