Question about Ford F-350

Open Question

Where is the maf sensor on my 2003 f350 6.0 diesel located?

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: trying to locate MAF sensor

Look near your A/C system and under the overflow hose for the coolant. It is a round can looking thing with a small wiring harness attached on top. There rae 3 hex screws holding it on to the bracket. Remove these and slip it off of the air intake tube. Use a small screwdriver to depress the small latch on the inside of the harness and gently pull it off. Disassemble the MAF sensor from the mounting plate, remove it from the vehicle and spray the wires with carburetor cleaner several times. That should clean it up for you. Good luck and let me know if you need more info.

Posted on Feb 16, 2009

  • 76848 Answers



Posted on May 22, 2009

  • 158 Answers

SOURCE: I need the location of MAF sensor in a 1998 Dodge

Your vehicle dose not have a maf sensor. They used a map sensor it is on the engine located under the front of the breater where it attaches to the engine.

Posted on Jul 02, 2009

  • 2309 Answers

SOURCE: where is map sensor located on 2003 chevrolet

you got engine knock check the knock sensor

Posted on Oct 31, 2010

  • 17970 Answers

SOURCE: manual aerio 2003,maf sensor

El sensor MAF (Mass Air Flow sensor) esta dise?ado para medir el flujo de aire que ingresa al motor, este dato viaja hasta el PCM (Powertrain Control Module - Computador) por medio de un cable el cual env?a una se?al de voltaje que cambia de acuerdo al flujo.

En algunos sensores MAF la se?al entregada es una corriente pulsante de frecuencia variable (en modelos General Motors, por ejemplo).

El sensor MAF mayormente difundido es el el llamado Sensor MAF por hilo caliente. En este sensor, internamente funciona mediante un hilo muy fino met?lico el cual se encuentra a muy alta temperatura, en el momento que comienza a entrar aire el aire enfr?a este hilo y las cargas cambiantes de aire causan un efecto diferente sobre la temperatura del hilo, entonces todo el circuito que maneja el tema del calentamiento del hilo generara una se?al de voltaje de acuerdo a que tanto es enfriado.

Esto se encuentra incorporado dentro del sensor, el cual va ubicado en el sistema de admisi?n del veh?culo, lo m?s pr?ximo al filtro de aire del motor.

Internamente existe un circuito que permanente monitorea los cambios de temperatura del hilo por medio de un transductor el?ctrico, esto dentro del sensor.

Espero que esto le ayude. Su opini?n es importante y yo agradezco su tiempo y consideraci?n si se deja alg?n comentario testimonial sobre esta respuesta.

Gracias por usar FixYa, y que tenga un gran d?a.

Posted on Oct 26, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Location of map sensor on 2003 windstar

Fern, I believe you mean the Mass Air Flow sensor (MAF). It is normally found in the fresh air intake plastic/rubber hoses attached to the air filter box, on yours it may be in the part of air filter box. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
2003 Ford Windstar clean or replace Mass Air Flow sensor MAF
Clean Your MAF
2003 windstar MAF sensor location Google Search

Aug 01, 2016 | Cars & Trucks

1 Answer

2003 silverado fuse panel

There isn't one. The MAF is controlled by the engine control module. The control module sends the power and ground to the MAF. As it also send power to other sensors. If you have no power to the MAF, then it is in the wiring, if you have power to other sensors. IE.. TPS, EGR, and others.

Aug 26, 2014 | 2003 Chevrolet Silverado 1500

1 Answer

Show me location of code po102

This is the Mass Air Flow Sensor. It's a screen-like device located on the air intake line to the throttle body. It measures the flow rate and density of air entering the engine. The code can mean a few possible things:

1. Dirty Air filter
2. Dirty MAF Sensor
3. MAF Sensor wiring problems

Try replacing the air filter first. Remember that engine codes must be reset or they will remain in the computer even after repairs. If that doesn't work you can remove the MAF and clean it with a MAF Sensor approved spray cleaner. If you use the wrong cleaner you will destroy the MAF. If cleaning the MAF don't work, then replacement is indicated.

Nov 07, 2013 | 2003 GMC Yukon Denali

1 Answer

Where is th MAF sensor located on a 2003 Pontiac Sunfire

I don't list one used on a 2003 Sunfire with a 2.2 engine.

Jan 12, 2013 | 2003 Pontiac Sunfire

1 Answer

Location of maf sensor on jaguar x type 2004

DON'T USE WD40 on the air intake this will destroy the Lambda sensors,
for info on the location go here

Oct 04, 2012 | 2003 Jaguar X-Type

1 Answer

Where is MAF/MAP on Mitsubushi 4D56 turbo diesel?

I suggest download this specific Factory Service Manual: Mitsubishi FSM Engine 4D56-25-diesel

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Feb 13, 2012 | Mitsubishi Delica Cars & Trucks

1 Answer

Where is the iat sensor located on a 2003 kia sorento

Intake Air Temperature (IAT) Sensor: this sensor is located in the air intake plenum assembly. This sensor is combined with the MAF sensor.

Hope helps (remember to rating this free answer).

Oct 07, 2011 | 2003 Kia Sorento

2 Answers

I have a 2003 explorer sport trac and the maf sensor is acting up. I want to replace it myself but I need to know the location of the sensor to do so

Have you checked the price of a Mass Air Flow meter? You might want to see why its acting up first.
Do you use a K&N or like kind air filter? The MAF could be fouled by exessive oil on it. Could just need a cleaning.
The MAF is located inline between the air filter and the throttle body.

Aug 25, 2011 | 2003 Ford Explorer Sport Trac

1 Answer

Where is the IAT (Intake Air Temperature) sensor located on a 2002 2500HD with a 6.6 Duramax Diesel?

The intake air temperature sensor on a 6.6L diesel is part of the mass air flow sensor, located just outside the air filter housing, in the intake air snorkle going to the engine. The other one is for the turbo system and is located directly at the top of the engine in the inlet pipe for the turbo. This on is the intake temperature heater / sensor, and will set a totally different code relating to the turbo. The one you want is incorporated with the MAF sensor. Usually code P0101 sets.

Feb 06, 2011 | 2002 Chevrolet Silverado 2500HD

1 Answer


Usually this is located on the pipe that comes off the air filter. It can also be located on the intake manifold itself, however the majority of the time its on the pipe coming from the air filter.



Dec 05, 2008 | 2003 Toyota Tundra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers


Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides