Question about 2005 Buick Rendezvous
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
There could be alot of problems if the AWD lights comes it could either
transmission oil is old or the oil filter is dirty ,these interact with onboard
computer and produces false signal which causes the car to be AWD mode
or this could be the problem with selector switch ,first try to replace the oil and check if its AWD light goes......
Posted on Feb 18, 2009
3.4L & 3.5L Engines
The fuel filter is located on the frame rail near the tank—with 3.4L and 3.5L Engines
Posted on Oct 11, 2009
Testimonial: "Thank you for your reply, but my car is not the fuel filter in the fuel line underneath the body."
On most cars after 2000 it is recommended to keep a minimum of 9 volts in the system when disconnecting the battery.
You can buy a 9 volt battery unit to plug into your lighter socket.
Otherwise....if you have a battery charger....attach it to the alternator output and put it on its lowest setting....that should keep voltage in the numerous memory circuits while you change the battery.
When changing the battery.....(removing voltage from the system) it's a 50% chance of putting the radio into theft mode.
The codes to take it out of theft mode are available online.....just google.
Posted on Oct 29, 2009
SOURCE: Easy way to change thermostat
Hi, below are the removal/installation instructions for your thermostat.
Removing the housing bolt..
The removal and installation of the thermostat...
NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Posted on Jan 11, 2011
Tips for a great answer:
Dec 28, 2016 | Buick Cars & Trucks
Feb 18, 2016 | 2002 Buick Rendezvous
Jul 19, 2014 | 2006 Buick Rendezvous
Nov 19, 2011 | 2005 Buick Rendezvous
Nov 07, 2009 | 2006 Buick Rendezvous
Jan 12, 2009 | 2004 Buick Rendezvous
Jul 23, 2017 | 2005 Buick Rendezvous
81 people viewed this question
Usually answered in minutes!