Question about 2006 Chrysler PT Cruiser

1 Answer

My 2006 pt cruiser working fine then turn key it started then

Then it went off it did this three times and now it want do any thing but the lights, radio and everything will come on but not the motor and the security light flashes in the dash. It have kind of did this before when I put key in the ingnition it start and go back off and I'll take the key out and insert again until it start and the security light will be flashing

Posted by on

  • Anonymous Jan 27, 2009

    THIS SOLUTION WAS HELPFUL BECAUSE I HAD THE SAME PROBLEM. THE CAR LIGHTS AND RADIO WOULD COME ON BUT THE CAR JUST WOULD NOT START AND AFTER GETTING A NEW BATTERY IT DID IT AGAIN A WEEK LATER AND WHEN IT GOT TOWED IT STARTED AT THE DEALER THEY COULD NOT FIND ANY THING WRONG SO I GUESS I REPLACE THE KEY THEY ONLY GAVE ME ONE WHEN I BROUGHT THE CAR 9 MONTHS AGO.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,011 Answers

It has a bad chip in the key.not comunicating with the toumbler

Posted on Jan 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 pt cruiser, ran fine, went in for clutch replacement, mechanic called said clutch work completed, car wont start, claims the engine would turn over, but would not start, turns over fast like no...


Has ALL the wiring been put back ? sounds like he missed a few wires....check high amp fuses too (in case starter fuses blown due to incorrect reassembly).... one more thing.... any fuel in there ?

Apr 07, 2014 | 2003 Chrysler PT Cruiser

1 Answer

Ignition wont start the car when hot outside. U have to turn the key to the start position and hold for a few seconds or even crank or turn turn key the key past the start position to sometimes get it to...


My 2006 PT Cruiser has the same problem! When hot in the cab it won't start but after it is cool outside it starts up without missing a lick! When it is hot and you turn the key you get nothing but do have power to lights, radio, etc. weirdest thing ever and nobody knows why! We have had the ignition module replaced and have a new battery. This one has stumped everyone. Any suggestions folks?

Jul 24, 2010 | 2006 Chrysler PT Cruiser

1 Answer

Pt cruiser cut off and will not restart this happen at light while idling, i try to restart but just turns over


Not sure if it still works,but this works on a 2001 PT.To see if there are any codes turn the key on then off 3 times fast,on the third time leave it on,Where the odometer is will display the trouble codes.Just count on1 on 2 on 3.At 24,000 ,68,000 110,000 miles my wife's 01 PT would not start(EGR Valve)at 75,000 & 140,000 crank position sensor.First time ran bad second time just died and wouldn't restart.Well hope the key thing still works and good luck.If you can get the codes then go to this link.
http://www.ptcruizer.com/computer-codes.html

Apr 01, 2010 | 2006 Chrysler PT Cruiser

1 Answer

Will not start


YOUR IMMOBILIZER SYSTEM IS IN LOCKOUT MODE..IF YOU REMOVE IGNITION OFF DRAW FUSE FROM UNDERHOOD FUSEBLOCK,IOD FUSE FOR 10 SECONDS,IT SHOULD RESET THE IMMOBILIZER..IF IT DOES,THE FAULT LIES WITH THE IMMOBILIZER MODULE ITSELF..AS FAR AS I KNOW,THE DEALER IS THE ONLY ONE ABLE TO PROGRAM THE NEW ONE..THE CAR SHOULD START AND RUN AFTER DOING THIS WITH THE FUSE

Jul 25, 2009 | 2006 Chrysler PT Cruiser

1 Answer

While driving my 2004 pt cruiser touring edition it went dead after I stop at a stop light; after about 3 times of trying to restart my car it finally started. I proceeded to the next stop light about...


If you have a "Autozone" in your area, go there and have them run a check on your alternator. It is free to do, and they will run engine error codes for you free of charge.

May 03, 2009 | 2004 Chrysler PT Cruiser

1 Answer

WON'T START


my 2006 pt cruiser won"t start. the light do come on but it will not turn over just a clicking sound. i drove it for about an hour then went back to it 30 mins later and it didn"t start. just clicking sound.

Sep 21, 2008 | 2006 Chrysler PT Cruiser

Not finding what you are looking for?
2006 Chrysler PT Cruiser Logo

380 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...