Question about 2001 Oldsmobile Bravada

2 Answers

I replaced the fuel pump on my 2001 Bravada and it still wont work when I turn the key on the pump is'nt making any noise at all my fuel gauge still dont work and I'm not getting any fire at t

Could the computer be out and can it be checked with a code reader with the engine not running

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Oldsmobile Master
  • 5,256 Answers

Yes, key only needs to be on, for code reader to check codes. Don't condemn the computer till you have checked all other possibilities-some checking of the fuel pump circuit should be done. A tech would need to consult the wiring diagram for your Bravada.

Posted on Jan 14, 2013

  • James Simmons Jan 15, 2013

    Well in not getting any spark from coil is y I think it may be computer. It just died while driving

  • montehammons Jan 15, 2013

    It could be that, then. Or a sensor has failed. A bad crank position sensor will cause no spark, for instance. Check the codes first. For diagnosing, you would need a good wiring diagram and a digital volt ohm meter. Good luck.

×

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 41 Answers

Have you checked the fuel pump relay and the fuse? Yes, the OBD 2 system can check for and have codes pulled with the switch set to "on" while vehicle is not started. Need a scanner though to check it.

Posted on Jan 14, 2013

  • James Simmons Jan 15, 2013

    Why would I not be getting any spark from my coil. That's y I think it may be the computer, I checked the ignition module too its ok

  • jim0264
    jim0264 Jan 15, 2013

    Check the codes a smontehammons suggested. It will let you know if anything is out of spec or failed most likely. Could be anything from bad wiring (short) to the computer.

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

garyq1970
  • 73 Answers

SOURCE: 1998 oldsmobile bravada

fuel gauge sending unit is at fault

Posted on Aug 24, 2008

  • 2 Answers

SOURCE: engine wont turn over with key, not getting enough gas to run.

Have the key and ignition checked! I am assuming that the key has a security chip on it, Right? If so, re-program key at dealership, and if that alone doesn't work, have them check both the key and column.

Posted on Oct 16, 2008

  • 1 Answer

SOURCE: 96 bravada replaced fuel still no start runs with starter fluid

If your getting gas and spark get an obd 2 scan tool and check your mass air flow sensor. I had the same problem. If your having a problem with this vehicle always check the computer first; it will save you tons of headaches later.

Posted on Jun 05, 2009

  • 2841 Answers

SOURCE: i have a 2001 Bravada.

Replace the fuel filter. If that does not help, the have a fuel pressure test run on the fuel system. You may end up finding out that the fuel pump is weak and indeed needs replacing.

Posted on Sep 06, 2009

Mustgo
  • 2359 Answers

SOURCE: 93 oldsmobile bravada won't start. Was running

Are you one of those people who TOP OFF the tank when filling up?

When the EVAP recovery system soak with few ounce of gasoline......the trap vapor will take few days escape.

EVAP system is design to handle fuel vapor. Few ounce of gasoline can damage the fuel vapor recovery relay and decrease the service live of the recovery lines.

=========

You can accelerate the process by locating the charcoal canister (near the nose of the car and same side as your gas filler door)

MOVE the car to outdoor.

Disconnect the EVAP line and let it air out by itself.

DO NOT introduce any heat source or fan to speed up the process.

Reconnect this EVAP hose and use a small amount of starting fluid at the intake manifold.


Please post more information by Clicking on the comment link.

I will follow up.

Posted on Dec 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replaced fuel pump now fuel gauge isn't working


sending units get knocked out of calibration when they change the pump.(carelessly).if you can.. check the top of the tank, to see if they plugged it in firmly. if not, raise heck till the change it. (doubt they will). other than the wires, not much you can do, without dropping the tank.

Jan 11, 2013 | 2001 Hyundai Tiburon

1 Answer

2001 chevy suburban fuel gauge stoped working


If the sending unit was connected and grounded, I would guess the gauge in the cluster is faulty.

Jul 09, 2012 | 2001 Chevrolet Suburban

1 Answer

Fuel Pump 2000 Bravada changed but still not working... help!!!!!!


You check the relay?Make a tool out of the relay take the relay apart collapse it.to make full contact and stick it back in,key does the fuel pump come on?If yes keep it like this for 15 minutes if the vehicle stall,the problem is not the fuel pump, The ECM must see a RPM of 250 or more in order to turn the fuel pump on. If it doesnt see a RPM of a 250 it doesnt even know its running.Okay back to the tool you made,This only trouble shoot the fuel pump system

Mar 12, 2012 | 2000 Oldsmobile Bravada

1 Answer

MY JEEP TURNS OVER BUT WILL NT START. dOES THE 2001 MODEL HAVE A FUEL OFF SWITCH


The only manufacturer that uses a fuel cut off switch or inertia switch is Ford. Your jeeps fuel pump power supply is ultimately controlled by the cars computer. If you suspect there is a fuel pressure issue the first step would be to actually check fuel pressure with a fuel assure gauge. Or listen to see if you can hear the fuel pump run for a couple of seconds when you turn the key to the run position. If there is no fuel pressure or you can not hear the fuel pump run than the next step is to check for power to the fuel pump. You should be able to find the fuel pump harness back by the fuel tank. There will be a connector where the fuel pump harness plugs into the vehicle harness. You'll want to check for power to the pump by back probing the wires at that connector. There should be power for a couple of seconds when the key is turned on and any time the engine is cranking. If there is power the fuel pump is bad. If there is no power let me know and I'll be happy to help you with some further diagnosis.

Aug 15, 2011 | 2001 Jeep Grand Cherokee

1 Answer

1997 Oldsmobile Bravada ~ lots of $$ has already been spent to keep it running. Recently became reluctant to start. Generally turn key mid-way twice and then completely turn key and it starts. If try to...


It does sound like a weak fuel pump but you should check fuel pressure before you condem it. You should see readings in the mid 50s to 60 psi key on engine off. The check engine light may be a separate issue. You'll need to find out what code/s are stored in the PCM. A parts store like Autozone can help you with this.

Jul 28, 2011 | 1997 Oldsmobile Bravada

1 Answer

1994 olds bravada trys to turn over but wont start


First check the spark up at the engine. Also turn the key to the on position with out turning it over and listen and see if the fuel pump primes. You should hear it hum. Thats where I would start anyway. If you don't hear it prime, then the fuel pump is out. If it is running and you are getting spark, then you may have to hook up a fuel pressure gauge to it and make sure you are getting enough pressure.

Feb 05, 2010 | 1994 Oldsmobile Bravada

6 Answers

I have a 2001 Bravada. The vehicle will crank and turn over but it wont start. I have replaced the cam shaft sensor and the fuel pump relay and the rotor bug. I dont think it is the fuel pump because i...


ok... Wait we have to settle some things here. You can get the vehicle started by pouring fuel down the throttle body, if so then it is most definatley a fuel pump problem. I usually try to bang on the tank with a rubber malle while cranking the engine. if it starts then its the pump, the simplest way to check is to see if your getting power at the fuel pump assembly. If you are then you need to change the pump the power wire is the grey one on the tank.

Sep 06, 2009 | 2001 Oldsmobile Bravada

1 Answer

2001 Olds Bravada Fuel Guage


could be 1 of 2 things. the gauge itself could be bad or, a wire to the gauge

Feb 07, 2009 | 2001 Oldsmobile Bravada

Not finding what you are looking for?
2001 Oldsmobile Bravada Logo

147 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...