Question about 2002 Dodge Stratus

1 Answer

Transmission I dont have mony to pay someone to change my tranmission, so I was working on it but all the scrus and everiting is lose but the transmission still there. and how can i stop the fly weell

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,533 Answers

First of all you need to put a bar or four by four across the engine just where it will fit where the hood closes supporting the chain to hold the engine up you have to put the car on jack stands and secure the back so it does not roll take the tire off on the driverside remove the axle and if you have done all this the torque converter could be stuck

Posted on Jan 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Clutch is not holding pressure what to do


Do you have to had brake fluid, if you dont the clutch master cylinder is bad,try to bleed before, if it leak Under the transmission slave cylinder is out,you had to remove tranmission to change it

Feb 24, 2014 | 1998 Chevrolet Cavalier

1 Answer

Ttack and spedometer wont work sumtime and when it doesn't transmission dont shift right


Take it to a tranmission shop to be road test , They don,t charge to do that,

Nov 29, 2012 | Cars & Trucks

1 Answer

Someone please tell me where to find this neutral safety switch or transmission range sensor. i have looked all over for and i can not find it. i'm not sure it that the right name. can someone als


Usually on the tranmission ,where i dont know??. Best way of finding it is call local autozone or go to store and in most cases the will print you out diagram as to the location and how to replace . They dont charge for the print out. hope this helps and Please rate this post and good luck.

Aug 14, 2012 | 2008 Suzuki Forenza

1 Answer

There is a filter on the mazda tribute tranmission please tell me where it is or be man enough to say I just dont care enough to find out. be specific and dont say that a part that is readily availble on...


If your vehicle has an automatic transmission, the transmission filter is inside of the transmission. You have to remove the transmission pan to access the filter. It is usually 14 bolts that hold it on. While taking the pan off, transmission fluid will spill everywhere, make sure to use a large bucket. When the pan is off, the filter just pops off. After replacing the filter, make sure to replace the gasket that goes between the transmission housing, and the transmission pan.
I hope this helps, if you have any more questions please email me
Matt

Jun 25, 2011 | 2001 Mazda Tribute

1 Answer

Notice on driveway tranmission fluid leaking check t f top off also first gear hard shift took to DOBBS HAD CHECK OUT WAS TOLD tranmission seal on back side was leaking bad also oil pan gasket leaking...


u get a second look your self by looking at the transmission u dont have to take anything apart to find the leak the oil pan is easy so check that one first if u see any fluid on or around the pan then the seal is shot that dont mean the tranny will burn up, just keep an eye on the fluid level second the rear transmission seal is located at the back of the tranny where the rear drive shaft slips into the transmission if you notice fluid around there and on the drive shaft thats leaking also but like i said just because u have a few minor leaks dont mean the tranny will blow up just as long as you keep an eye on the fluid level. do your home work and find a good transmission shop that will gaureentee the there work at a decent price.

Nov 27, 2010 | 1999 Dodge Ram

1 Answer

Im takeing out my motor out of a 96 jimmy and i dont know how to take out mty tranmission


Remove the driveshaft, or both if 4x4. Remove the starter and if automatic remove the inspection cover by the starter and unbolt the torque converter. Don,t lose these bolts, they are special order only from the dealer. Unhook your linkage and wiring. Put a jack under the trans with a block of wood between it and the pan. Unbolt the transmission crossmember from the frame and the trans from the engine.Remove the crossmember and slide the transmission back and lower the jack. Hope this helps.

Sep 12, 2009 | 1996 GMC Jimmy

3 Answers

1999 chevrolet silverado 1500 Z71 5.3 engine 4wd auto trans with tow-package. When tranmission gets hots after stopping at light the transmission goes from 1st to 2nd with a jolting pop.


change the fluid and filter if u havent already if that dont fix problem have trans. checked out u didnt say how many miles are on the vehicle?

Aug 11, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

When changing your tranmission on 2003 Hyundai


The dealer reccommends you use their transmission fluid for optimal shift quality and trans. life.

Jul 22, 2009 | Hyundai Motor 2003 Elantra

Not finding what you are looking for?
2002 Dodge Stratus Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...