Question about 2005 Chrysler Pacifica Touring
Body control module
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
IF YOU OPEN THE HOOD ON THE RIGHT SIDE THERE IS A SQUAR BOX THAT SITS RIGHT NEXT TO THE BATTERY OPEN THAT BOX AND LOOK UNDER THE PART YOU OPEN AND IT HAS A DIAGRAM AND THE NUMBER WHERE IT GOES
Posted on Dec 29, 2008
It is located on the back side of the underdash fuse box (junction block). You remove the lower steering column cover and knee blocker reinforcement. Then remove two plugs from the bottom of the bcm.
Remove the bolts holding the junction block to dash panel mounting bracket. Remove the junction block from the bracket. Remove screws holding the bcm to the jb. Slide the bcm downward to disengage guide studs on jb from channels on bcm mounting bracket
Remove bcm from jb.
Posted on Jan 02, 2009
It is located on the back side of the underdash fuse box (junction block). You remove the lower steering column cover and knee blocker reinforcement. Then remove two plugs from the bottom of the BCM.
Remove the bolts holding the junction block to dash panel mounting bracket. Remove the junction block from the bracket. Remove screws holding the BCM to the junction block. Slide the BCM downward to disengage guide studs on jb from channels on BCM mounting bracket
Posted on Mar 23, 2009
Each of the plugs has it's own coil so they are under the swaure coil, you won't see traditional spark plug wires, look for sets of two wires headed for ~ 2.5 inch square block, three plugs can be seen in front of the large plastic air plenum, the uther three are underneath the plenum. Takes a real handy DIY person to do this as there are plenty of things to remove before the plenum comes off. Take good notes on how you remove things, I missed a lever that is part of the idle system and throught I messed things up bac\d, but when I located the correct place to attach the lever it was fine. Also be careful and not break a connector to the individual coils. I did, but was able to glue it together...
Posted on Apr 09, 2009
Tips for a great answer:
Apr 17, 2018 | Saturn Cars & Trucks
Dec 08, 2016 | 2006 Chrysler Pacifica
Feb 14, 2016 | Chrysler Cars & Trucks
Dec 13, 2015 | Scion Cars & Trucks
Dec 06, 2015 | Cars & Trucks
Jan 23, 2018 | 2005 Chevrolet Avalanche
Nov 03, 2013 | Chrysler Concorde Cars & Trucks
Aug 20, 2012 | 2002 Chrysler PT Cruiser
Mar 23, 2009 | 1999 Chrysler Town & Country
926 people viewed this question
Usually answered in minutes!