Question about 2011 Hyundai Sonata Hybrid

Open Question

2012 Hyundai Sonata Hybrid reset after oil change

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: check engine light and how to diagnois and reset 1999 Hyundai Sonata

I had same problem and my repair shop just replaced a sensor in the tranny. Said it was a defect by Hyundai,but they won't recall it.

Posted on Oct 21, 2008

Ad
  • 393 Answers

SOURCE: replacing rear wheel bearings on 1999 hyundai sonata

  1. for drum brakes with sealed hub(all one piece) remove lug nuts and wheel.
  2. spray penetrating oil around studs if there is a big phillips head screw visible remove it with impact driver/if not use big ballpeen hammer ,tap on flat of drum near studs(becareful not to hit them) until drum loosens(your creating a shockwave to loosen rust)
  3. once drum is off there are 4-bolts coming in from behind backing plate, remove them then hub should be able to be removed w/a little persuation from hammer.
with out sealed hub ,
  1. remove wheel
  2. remove dust cap,cotterpin,star washer(if equipped) do not re use cotter pin
  3. remove nut then washer, wiggle brake drum and front bearing will come out.
  4. put nut on shaft tighten 2-3 turns grab drum by sides and pull towards you this should remove drum leaving inner bearing/seal on shaft
  5. to replace reverse procedure making sure to pack new bearings w/grease(take drum and use long punch to remove bearing races, use race/seal installer to install new races
with disk brakes

  1. remove wheel
  2. remove caliper/bracket
  3. remove rotor
  4. remove 4-bolts from behind,tap old hub out
  5. reverse procedure



Posted on Nov 15, 2008

  • 75 Answers

SOURCE: Major oil leak after oil change

Your filter was installed either without the rubber seal, or the seal wasn't lubed before installation and it slipped, causing an improper seal. You will have to drain the oil again, remove the filter, and make sure it is reinstalled with a proper seal.

Posted on Dec 05, 2008

defadad
  • 351 Answers

SOURCE: '05 Hyundai Sonata Coolant Change

remove the cap on the radiator or the header tank, use a plastic container that will hold about 4 ltrs of coolant, there should be a drain tap at the bottom of the radiator, if not you have to remove the hose clamp on the bottom hose and let the coolant drain out.
Replace the hose and clamp, top up the radiator and run the motor while checking the coolant level, if the level goes down a bit just top it back up and check over the next day.
hope this helps

Posted on May 19, 2009

  • 2 Answers

SOURCE: how do you reset the check engine light on hyundai sonata?

Just disconnect your battery for a couple of minutes.

Posted on Jul 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2012 hyundai sonata accelerates on its own


Just keep foot close to brake peddle. Hahaha. Jk. Spray some wd-40 on your throttle body and throttle cable. If not that then take of throttle body and clean butterfly.

Mar 24, 2016 | 2012 Hyundai Sonata Hybrid Base Sedan 2.4L...

1 Answer

Why won't it start?


Hyundai Sonata Questions - My Hyundai Sonata won't start ...

www.cargurus.com > Questions > Hyundai > Sonata

CarGurusMar 5, 2013 - My Hyundai Sonata won't start, everything comes on when the key is turned but no ... it is in park and until I jiggle the shift until the light does come on it will not start. Was in ... My 2009 Sonata has been "perfect" with no issues.

2009 Hyundai Sonata turns over but will not start ... - CarGurus

www.cargurus.com > Questions > Hyundai > Sonata

CarGurusJun 16, 2013 - 2009 Hyundai Sonata turns over but will not start, sometimes. - 70000 kms.

Car wont start? - Hyundai Forums : Hyundai Forum

www.hyundai-forums.com/nf-2006...sonata/139435-car-wont-start.html

Mar 14, 2012 - 10 posts - ‎4 authors
2009 Hyundai Sonata GLS 2.4L I4 AT - Slate Blue ... If you turn the ignition to on, not start, do you hear a humming coming from the rear? 2010 Not starting. Fuel Pump? Starter?
10 posts
Apr 1, 2012
Car Won't Start - Break Pedal Hard !
10 posts
Mar 4, 2011
2007 Sonata Won't Start
10 posts
Jan 4, 2011
Car Cranks But Will Not Start
10 posts
Jan 16, 2008
More results from www.hyundai-forums.com

Jan 01, 2016 | 2009 Hyundai Sonata

1 Answer

Car battery died can't get in the trunk to charge battery.


Should be able to get into trunk by remove the back seat and activate the emergency release in trunk

Nov 30, 2015 | 2012 Hyundai Sonata Hybrid Base Sedan 2.4L...

1 Answer

How to fixed the code p0017 hyundai sonata 2012 model


if u've changed the oil and put new sensor in it,,,, , many times you can disconnect the battery for 15/20 minutes and system sometimes resets itself............

Jul 22, 2014 | Hyundai Sonata Cars & Trucks

1 Answer

How do I install trailer wiring on 2012 Sonata Hybrid


On a car?

Your transaxle won't last long pulling much

You can't pull anything with a 4 cylinder

Nov 30, 2012 | 2012 Hyundai Sonata Hybrid Base Sedan 2.4L...

1 Answer

Why does my new hyundai sonata hybrid getting 27 mpg.


it does depend on the type of driving you do, and break-in is a factor for a new car-mileage will be lower until the car is fully broken in (3-5000 miles), and if you do more highway driving than stop-and-go it will affect your gas mileage.

May 31, 2011 | 2011 Hyundai Sonata Hybrid

1 Answer

2005 hyundai sonata oil light flickers. oil


Yes there is a sensor located on the front of engine on the transmission side(single wire). It cannot be "reset". Possibly loose connection at the sensor,or a faulty sensor, OR... you could be losing oil pressure inside the engine somewhere(lets hope not) these engines are designed to run on very low oil pressure compared to cars of days gone by. The sonata 4 cylinder runs about only 12 psi. The V6 is 7.6 psi or more.
So if it is an oil pressure issue it is extremely important not to run the car before it is fixed or you will need an entire engine.

Jan 24, 2010 | 2005 Hyundai Sonata

1 Answer

Check engine light and how to diagnois and reset 1999 Hyundai Sonata


I had same problem and my repair shop just replaced a sensor in the tranny. Said it was a defect by Hyundai,but they won't recall it.

Sep 14, 2008 | 2000 Hyundai Sonata

Not finding what you are looking for?
2011 Hyundai Sonata Hybrid Logo

Related Topics:

343 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...