Question about Lexus ES 330

Open Question

REMOVAL OF OIL PAN 2005 LEXUS ES330 - ES 330 Lexus Cars & Trucks

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76846 Answers

SOURCE: Do i have to use synthetic oil on my 2006 lexus ES330?

U do not have to use synthetic oil but I recommend u do if u plan to drive the car for 100,000 miles or more, syn oil almost eliminates engine wear, if u use it change the oil and filter every 5,000 miles

Posted on Jan 24, 2009

Ad
c17hydro
  • 2984 Answers

SOURCE: 2003 oil pan removal

4.0L Engine To Remove:

  1. Disconnect negative battery cable.
  2. Lift the vehicle.
  3. Drain the engine oil.
  4. Remove or disconnect the following:
    • Exhaust pipe from exhaust manifold.
    • Exhaust hanger at the catalytic converter and lower the pipe.
    • Starter motor.
    • Flywheel/torque converter housing access cover.
    • Oil level sensor (if equipped).
  5. Place a pole jack under vibration dampener with a piece of wood between dampener and jack.
  6. Remove or disconnect the following:
    • Engine mount through bolts and raise engine for clearance to remove pan.
    • Transmission cooler lines (if equipped).
    • Oxygen sensor harness from oil pan mounting studs.
    • Oil pan bolts and studs.
    • Oil pan and gasket.
To Install:
  1. Clean the gasket mating surfaces.
  2. Apply Mopar® Silicone Adhesive Sealant or equivalent onto the cylinder block in four location as shown.
7605306.gif

  1. Attach the pan gasket to the oil pan with Hi-tack or equivalent (2003-2005 vheicles).
  2. Use 1 ½ x ¼ inch bolts to fabricate alignment dowels. Cut off the head of the bolts and cut a slot into the top of the dowels (2006 vehicles).
4e495fd.gif

  1. Install two dowels into the timing case cover (2006 vehicles).
  2. Install two dowels into the cylinder block (2006 vehicles).
  3. Place the gasket over the dowels and onto the cylinder block and timing case cover (2006 vehicles).
  4. Position the oil pan.
  5. Install the 1/4 inch oil pan bolts. Tighten to 84 in-lb (9.5 Nm).
  6. Install the 5/16 inch oil pan bolts. Tighten to 132 in-lb (15 Nm).
  7. Remove the dowels.
  8. Install the remaining 1/4 inch oil pan bolts. Tighten to 84 in-lb (9.5 Nm) (2006 vehicles).
  9. Lower the engine onto the engine mounts.
  10. Install the through bolts and tighten the nuts.
  11. Remove jack stand and remove the piece of wood.
  12. Install the flywheel and torque converter access cover.
  13. Install starter motor.
  14. Connect the exhaust pipe to the hanger and to exhaust manifold.
  15. Install the transmission oil cooling lines (if equipped).
  16. Install the oxygen sensor wiring supports to the oil pan mounting studs.
  17. Install the drain plug into the oil pan. Tighten to 25 ft-lb (34 Nm).
  18. Lower the vehicle.
  19. Connect negative battery cable.
  20. Fill the oil pan with oil. WARNING
    Use extreme caution when the engine is operating. Do not stand in a direct line with the fan. Do not put your hands near the pulleys, belts or fan. Do not wear loose clothing.
  21. Start the engine and inspect for leaks.

Posted on Jun 06, 2009

grwashburn
  • 3 Answers

SOURCE: air filter, 2005 lexus es330

To the right of the engine there is a large rectangular plastic box which houses the air filter (just above the battery) On the right end of this housing there's two silver colored bolts, remove these bolts with a ratchet, extension and socket. Lift top of housing (lid) up from the right end - you'll see it swivels from the left end. Slide out used filter and slide in new filter. After making sure filter is seated properly, replace bolts.

Posted on Aug 15, 2009

  • 548 Answers

SOURCE: Change F to C for my lexus Es330 air conditioner

i dont think its possible was the car from canada? I have heard of but wasnt witness to when the battery was disconnected that the car went to farenheit

Posted on Aug 21, 2009

Testimonial: "Always very helpful, quick solutions. "

  • 89 Answers

SOURCE: how do i turn off the maintenanace light on my 2005 lexus es330?

watch this free video instructions on how to reset your maint reqd light if video dosent work go to www.vehix411.com

Posted on Oct 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuel pump relay located on a 2005 lexus es330


under the hood to find the fuse/relay for fuel pump

Jan 16, 2015 | 2005 Lexus ES330

1 Answer

My trunk light on my 2005 Lexus ES330 won't come on. I have checked the bulb and it is good.


Check to see if there is a fuse if not check the trunk switch that turns on the light.

Nov 22, 2014 | 2005 Lexus ES330

1 Answer

How do i fix the glove box on 2005 Lexus ES330.


Loosen the two screws that hold the metal latch to the dash board and move it out a bit. May take a couple of times to get it right.

Oct 01, 2014 | 2005 Lexus ES330

1 Answer

Lexus es330 engine check in view because i have changed fuel filter


this vehicle may be due for a service.

slow starting in colder weather can be due to many issues. such as dirty or wet ignition sytem or low battery charge.
if you live in colder climate you may need to change your oil to a thinner one for cold tempretures.

also check that exaust pipe is not blocked, air filter is clean and fuel filter is not blocked.


I hope this was useful.

Oct 25, 2011 | 2005 Lexus ES330

1 Answer

I have a 2005 Lexus ES330 it is making a loud humming noise what could be wrong with it?


Hi, it could be a wheel bearing, a bad motor mount, if it's front wheel drive it could even be an axle rubbing on the frame (hince a bad motor mount), etc but it's hard to say without hearing it myself. But should have a good idea of where the problem is now and fix it.

Jul 25, 2011 | 2005 Lexus ES330

1 Answer

Is changing spark plugs on a 2005 Lexus ES330 considered a basic tuneup


spark plugs be replaced every 100.000 kms or 60.000 miles oem

Oct 07, 2010 | 2005 Lexus ES330

2 Answers

How do you turn off the ''service engine'' light on a 2005 lexus es330.


Is there somehting wrong with it or did you recently have an oil change done or something?

Apr 22, 2010 | 2005 Lexus ES330

1 Answer

How do i reset the check engine light on a 2005 es330


undo the battery for 30 secs. now pay me

Nov 20, 2009 | 2005 Lexus ES330

3 Answers

How do i turn off the maintenanace light on my 2005 lexus es330?


watch this free video instructions on how to reset your maint reqd light if video dosent work go to www.vehix411.com

Jan 05, 2009 | 2006 Lexus Es 330

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

907 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...