Question about Honda Odyssey

1 Answer

Neutral safety switch location 1999 honda odyssey

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Honda Master
  • 14,384 Answers

Click here to see switch.

Posted on Jan 14, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
dncholas
  • 222 Answers

SOURCE: neutral safety switch '97 eclipse

Under dash driver side look behind the upper arm of clutch pedal and you should see a green and black wire coming from the button (switch) assembly on the firewall. The wires go up above the clutch pedal. About in the middle of under dash on the left side you should see a white connector these wires run to. Disconnect. I just had the problem and not only starts now but not stalling like it was but it's only been one day but tested it pretty good.

Posted on Aug 16, 2010

c17hydro
  • 2984 Answers

SOURCE: replace the neutral safety switch on my 1999 Chevy Silverado

If it looks like this:





It is mounted on the side of the tranny. It also says a special to remove it.991cb34.jpg

Posted on Apr 01, 2009

  • 1 Answer

SOURCE: 2004 Jeep Grand Chrokee Neutral Safety Switch Location

The switch is on the transmission..It is usually a dealer item but you can get one from Rockauto.com for about 1/4 of what the dealers charge.

Posted on May 25, 2009

emissionwiz
  • 76846 Answers

SOURCE: Neutral Safety Switch Location

on the transmission where the shift cable attaches.

Posted on Jun 15, 2009

ZJLimited
  • 17970 Answers

SOURCE: Looking for the neutral safety switch

Neutral Safety/Back-up Light Switch

This is a combination switch which controls both Neutral Safety and Back-up lamp circuits.

C6 Transmission


8290dff.jpg

C6 neutral start switch

  1. Disconnect the negative battery cable.
  2. Raise and safely support the vehicle on jackstands.
  3. Remove the downshift linkage rod return spring at the low-reverse servo cover.
  4. Coat the outer lever attaching nut with penetrating oil. Remove the nut and lever.
  5. Remove the 2 switch attaching bolts, disconnect the wiring at the connectors and remove the switch.
  6. Installation is the reverse of removal. Adjust the switch and tighten the bolts to 55-75 inch lbs. (6.2-8.5 Nm).
  7. Remove the jackstands and lower the vehicle.
  8. Connect the negative battery cable.
AOD Transmission

e7f4231.jpg

Removing the AOD neutral start switch
  1. Disconnect the negative battery cable.
  2. Raise and safely support the vehicle on jackstands.
  3. Disconnect the wiring from the switch.
  4. Using a deep socket, unscrew the switch.
  5. Installation is the reverse of removal. Tighten the switch to 10 ft. lbs. (14 Nm).
  6. Remove the jackstands and lower the vehicle.
  7. Connect the negative battery cable.
4R70W Transmission

2f68dfc.jpg


Removing the Manual Lever Position (MLP) sensor

As of 1994, the neutral safety switch is referred to as a Manual Lever Position Sensor (MLP).
  1. Disconnect the negative battery cable.
  2. Raise and safely support the vehicle on jackstands.
  3. Disengage the harness connector from the MLP sensor.
  4. Remove the 2 sensor attaching bolts and remove the sensor.
To install:
  1. Install the MLP sensor and install retaining bolts. Do not tighten, the sensor requires adjustment.
  2. Adjust the MLP sensor then tighten attaching screws to 80-100 inch lbs. (9-11 Nm).
  3. Remove the jackstands and lower the vehicle.
  4. Connect the negative battery cable.


ADJUSTMENT

C6 Transmission
  1. Hold the steering column transmission selector lever against the Neutral stop.
  2. Move the sliding block assembly on the neutral switch to the Neutral position and insert a 0.091 in. (2.3mm) gauge pin in the alignment hole on the terminal side of the switch.
  3. Move the switch assembly housing so that the sliding block contacts the actuating pin lever. Secure the switch to the outer tube of the steering column and remove the gauge pin.
  4. Check the operation of the switch. The engine should only start in Neutral and Park .

4R70W Transmission


4cc4151.jpg


Adjusting the MLP sensor

Park is the last detent when the manual control lever is full forward. Return 2 detents toward the output shaft for Neutral.
  1. Position the manual control lever in Neutral .
  2. Insert Gear Position Sensor Adjuster tool T93P-700 10-A or equivalent, into the slots.
  3. Align all 3 slots on the MLP sensor with 3 tabs on the tool.
  4. Tighten the attaching screws to 80-100 inch lbs. (9-11 Nm).

I hope help you. Good luck (rated this help).

Posted on Sep 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2014 Honda Odyssey parking sensor not working


By parking sensor do you mean the park neutral safety switch ?

Aug 11, 2017 | Honda Cars & Trucks

1 Answer

Location of safety neutral switch on a Honda civic 2005


What is a neutral safety switch? The PRNDL switch is on passenger side of transmission. Pull passenger side front tire off and and it's visible. You have to remove a metal cover, two bolts. That switch tells the car what gear it is in.Here's a link to what it looks like 2005 HONDA CIVIC 1 7L L4 Neutral Safety Switch Range Sensor RockAuto

May 23, 2017 | Honda Cars & Trucks

1 Answer

When i start i just get click or starter just spin .after flicking key afew times or rocking gear lever it then starts


Park neutral safety switch problem ! Or transmission range sensor switch . Watch this video !
Intermittent No Crank, No Start, No Codes This is on a Honda but all cars have samething . 2006 Honda Odyssey Intermittent No Crank No Start No Codes

Dec 14, 2016 | Cars & Trucks

2 Answers

2006 honda odyssey; turn key not even a sound. new battery nothing!! switched out starter nothing!!


Sounds like you are not even getting power to the starter. Check the neutral safety switch to see if it is bad. You can even try to put the gear selector in Neutral and try to start it in case the switch is only bad in the Park position.

Dec 25, 2014 | 2006 Honda Odyssey

1 Answer

Why my99 honda accord wont shift to drive


bad neutral safety switch,here's a link to it, Repair Guides Instruments And Switches Back up Light Switch AutoZone com

Neutral Safety Switch

Print
DESCRIPTION

The neutral safety switch is a combination switch that also controls the backup lights and gear position indicators. The switch is located on the transaxle assembly.Here's a link to the part.
Duralast Neutral Safety Switch JA4308 1999 Honda Accord EX 6 Cylinders...

Sep 04, 2014 | Cars & Trucks

1 Answer

Where is the neutral safety switch on 1998


The neutral satety switch is located at the Right Side Of Gear Selector.

Apr 15, 2010 | 1998 Honda Passport

1 Answer

1999 honda odyssey won't start, has power but won't start.


It's the neutral safety switch. Have your mechanic adjust it, or replace it if it's bad. For now try starting it in neutral instead of park or even try pushing the shifter up all the way (in park) while you turn the key.

Sep 21, 2009 | 1999 Honda Odyssey

1 Answer

Where is the neutral safety switch in 1999 Discovery II?


Neutral Safety swithch is right under shifter, lift plastic surround (snaps off. round solenoid unit.

May 23, 2009 | 1999 Land Rover Discovery

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

346 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...